Manual de instrucciones de Philips Color External Monitor EM43

Resumen del contenido incluido en la página 1

Setup, Use and Care Guide
EM43 Color External Monitor



Gates Underwater Products • 5111 Santa Fe Street, Suite H • San Diego, CA • 92109
858.272.2501 • 800.875.1052 • Fax 858.272.1208 • www.GatesHousings.com
1

Resumen del contenido incluido en la página 2

Dear Gates Customer, Welcome to the Gates family! You now own one of the finest underwater housings available, and we thank you for choosing Gates. For over 33 years Gates has crafted the most reliable, durable and dependable housings to suit many needs, from recreational diving to treasure hunting, marine research and Hollywood productions to U.S. Navy programs. You see, at Gates, your selection of our product is only the beginning. We are here to service you, the cust

Resumen del contenido incluido en la página 3

Gates EM43 External Color Monitor Setup and Use Before You Begin Every Gates housing is pressure tested before leaving the factory to assure a watertight seal. The EM43 is shipped with batteries installed and is ready to use. Rough or abusive handling during shipment however, could have caused unnoticed damage after leaving the factory. Please carefully inspect the contents of the package and the EM43 for any sign of damage during shipment. If damage is suspected, contact Gates d

Resumen del contenido incluido en la página 4

Mounting Attachment of the EM43 to any housing is straightforward. The dovetail base will slide into the grooves on the top of the housing and then secured with thumbscrews. Tighten in place with thumb screws Slide the dovetail into the grooves Video Connection The EM43 will electrically connect via one of two methods: either a 2-pin EO connector (SD interface) or a 6-pin connector (HD interface). In either case the male cable connector will m

Resumen del contenido incluido en la página 5

6 pin connector 6 pin connector mated and secured with retainer strap Insert and fully seat the connectors to each other. The 6 pin connector can also be secured by a retainer strap. Verify operation by turning on the camera. If properly connected, the monitor will automatically turn on and display an image within 3-4 seconds. Gates Underwater Products • 5111 Santa Fe Street, Suite H • San Diego, CA • 92109 858.272.2501 • 800.875.10

Resumen del contenido incluido en la página 6

Batteries The EM43 uses 8 AA cells for power. The EM43 will accept a variety of AA cell battery types (or chemistries): • Alkaline (such as Duracell or Energizer) • Oxy-nickel hydroxide (such as Panasonic Oxyride) • Lithium (such as Energizer e2) • NiMH or NiCad rechargeable Caution: Do not use mixed battery types. This can cause battery leakage and damage to the EM43. Changing Batteries To change the cells, release the latches on the either side of the monitor and separate

Resumen del contenido incluido en la página 7

Monitor Adjustment The EM43 has three adjustments for hue, contrast and brightness. These adjustments can be found on the inside rear half of the housing (see photo). While the monitor is pre-adjusted at the factory, Gates recommends the monitor be further adjusted to match the camera being used. This will ensure a consistent match between the monitor and the image actually being recorded. Matching the camera and monitor should be done in a darkened area to allow good viewing of b

Resumen del contenido incluido en la página 8

EM43 Setup, Use and Care Guide Appendix A Camera Display Settings In some instances your camera will require setting up the video output settings to properly display a video image on the EM43 monitor. Use the chart below to navigate the menus system of your camera to establish these settings. Standard Definition High Definition Input to EM43 Input to EM43 EM43 Interface Connector 2 pin E.O. connector 6 pin connector SD Cameras Sony DSC-VX1000 No Changes Required No