Resumen del contenido incluido en la página 1
Prostyle TM Grill Cooktop
Model JGD8348BDP _wEsT FOURTHSTREET. NORTNE H.WTON.,A
Triple Bay ConventionalGas _JENN-AIF_
Dimensionsshowninbothinchesandcentimenters
NOTICE TO INSTALLER:Leavetheseinstruction with stheappliance.
NOTICE TO CONSUMER: Retaintheseinstruction forsfuture reference.
%
j_ 23,81crn
SEE PAGE2
SELECT APPROPRIATE FOR CUTOUT
DUCTCUTOUT
1" (SEEDUCTING DIMENSIONS
,i
INSTALLATION INSTRUCTIONS.)
15o PRESSUREREGULATOR
.__ APPLI ANCE
[38.1 cm] 46 13/16" "I
3 13/16" " I [11S.90 ¢m]
_9.6B
Resumen del contenido incluido en la página 2
CABINET and COUNTERTOPCUTOUTS (115.2 cm) 22_" Ref (58,11 cm) 17.46--22.86 crn) *Recomme8 nd "for Custom Cabinetry. O O_ NOTE: LOWER CONTROL PANEL IS REQUIRED IF THIS DIMENSION EXCEEDS 5_/_ " (14.60 crn). \ SEE PAGE 3 ABOUT i" 1" REINFORCING CABINET FRONT CABINET (FRONT VIEW) See cutout suggestions 1-4 on page 6. NOTE: Tolerances for Cutout I Dimensions are ± 1/16 in (.16 cm) I As requiredbyinstallation (116,2 cm] 227/6"Re1 (58.1 crn 1 _------ =l o I TOP == I_ _-_ VIEW O ° / p 4613/16" _ REMOVECO
Resumen del contenido incluido en la página 3
InstallingCabinetry Over Your Jenn-Air Grill Minimum horizontal clearancebetweenthe edge of the Avoiduse of cabinetsabovecooktopfor storagespace to applianceand combustibleconstruction extendingfrom eliminate associatedpotential hazards such as reaching the cookingsurface to 18" (45.7 cm) above the cooking over open flames. 1=/_" (4.45 cm) at rear 8" (20.32 cm) at sides surface is: NOTE: This is not the recommended clearance, but Dotted lines indicate range minimum al,owable clearance. ,.,_ t"--
Resumen del contenido incluido en la página 4
InstallationOf Appliance Follow accompanying ducting instructions carefully. NOTE: For some cabinet styles, it may be necessary to reinforce the front of the cabinet by attaching a brace This appliance is designed to always be vented outdoors, from front to rear inside the cabinet under the Burner Box. The Countertop Cutout, Cabinet Front Cutout and Duct Installductwork per ducting instructions provided. Duct Opening should be prepared according to the illustration openings in cabinet are shown
Resumen del contenido incluido en la página 5
ConnectingAppliance To Gas Supply Air Shutter Adjustment A TRAINED SERVICEMAN OR GAS APPLIANCE This appliance is shipped from the factory with air shutters INSTALLER MUST MAKE THE GAS SUPPLY adjusted for use with Natural Gas. If further adjustment is CONNECTION. Leak testing of the appliance shall be necessary, or to resetfor usewith LP, adjust air shutters as conducted by the installer according to the instructions follows: given. Install a manual shutoffvalve in an accessible locationin Grill
Resumen del contenido incluido en la página 6
Important Installation Suggestions Pressure Testing 1. Chamfer all exposed edges of decorative laminate to The maximum gas supply pressure for the appliance prevent damage from chipping, pressure regulator supplied on this appliance is 14" W.C. 2. Radius corners of cutout and file to insure smooth The test pressure for checking this appliance pressure edges and prevent comer cracking, regulator must be at least 6" W.C. for Natural Gas, and at least t 1" W.C. for LP. It is shipped from the factor
Resumen del contenido incluido en la página 7
Conversion To LP Gas Control Settings This appliance is shipped from the factory equipped for The size andtype of cookwareand the amountand type use withNaturalGas. To convertit from NaturalGas for of foodbeingcookedwill influencethe settingneededfor use withLP Gas, performsteps 1 through4. bestcookingresults.The settingindicatedshouldserve as 1. Remove NaturalGas orificehoods.Installcolorcoded a guidewhile youbecome familiarwith yourcooktop. orificehoodssupplied.Located ina packattachedto the o
Resumen del contenido incluido en la página 8
TOCONVERT APPLIANCE FORUSEWITHPROPANE GAS NaturalGasTo PropaneGas (LP)Conversion Instructions Models- JGD8348BDP Manifold- Propane Gas pressure required - 10" W.C. Incoming Propane Gas pressure required to appliance pressure regulator- 11" - 12" W,C. Propane Conversion Orifice Hoods are supplied with this model. Propane Gas input specified - 46,000 BTU/hr. Q ,_ JGD8348BDP Left Rear (LR) 7500 #66 .033 Zinc Left Front (LF) 7500 #66 ,033 Zinc Center Rear (CR) 6500 #68 .031 Red Center Front (CF) 900
Resumen del contenido incluido en la página 9
TO CONVERT APPLIANCE FORUSEWITHNATURAL GAS PropaneGas(LP)To NaturalGas Model- JGD8348BDP Conversion Instructions Manifold - Natural Gas pressure required - 5" W.C. If this appliance has been converted for usewith LP Gas, Incoming Natural Gas pressure required to appliance each of the following modifications must be performed to pressure regulator - 6" - 7" W.C. convert the unit back to Natural Gas. Natural Gas input specified - 56,000 BTU/hr. A. Replace allorifice hoods - Perform steps 1through
Resumen del contenido incluido en la página 10
MINIMUM SPACING REQUIREMENT GASGRILLCOOKTOPS Forinstallinga TripleBay Downdraft Cooktopincombinationwith another Downdraft Cooktop,the mini- mum spacing between adjacent units must be provided, as shown, for satisfactory performance. _ _ _ _ _ _, ANY DOWNDRAFT COOKTOP PROSTYLE COOKTOP (SINGL O_, OUeL On E TRmP eA LE Y L. 18" ,= (45.7 cm) r ANY DOUBLEBAY _= _ _ _ _ _ _ PROSTYLE COOKTOP I -'_ (45.7crn) < , ,,:o k ANYSINGLEBAY _= _ _= _ _ _ PROSTYLE COOKTOP 10
Resumen del contenido incluido en la página 11
REQUIRED ADJUSTMENTS ATTIMEOFINSTALLATION The installation of this appliance must conform with local codes, or in the absence of local codes, with the latest edition of the National Fuel Gas Code ANSI Z223.1 USA or current CAN/CGA-B149 Installation Code. --'--I to Thi LP s range procedure was manufactured found in the for installation usewithinstructions. NaturalGas. IfLP gas isthe fuel of choice, follow the conversion Test all external connectionsfor gas leaks. Never test for gas leaks with an
