Résumé du contenu de la page N° 1
INSTALLATION INSTRUCTIONS
DRAWER DISHWASHER
INSTRUCCIONES DE INSTALACIÓN
DE LA LAVAVAJILLAS DE CAJÓN
INSTRUCTIONS D’INSTALLATION
LAVE-VAISSELLE À DOUBLE TIROIR
Table of Contents/Índice/Table des matières..................................................................2
IMPORTANT:
Save for local electrical inspector's use.
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
IMPORTANTE:
Guarde para tenerlas a disposición
Résumé du contenu de la page N° 2
TABLE OF CONTENTS DISHWASHER SAFETY...........................................................................3 Connect Water Supply Line and Drain Hoses ...................................10 Make Electrical Connection................................................................12 INSTALLATION REQUIREMENTS .........................................................4 Electrical Requirements........................................................................6 Install Trim Pieces and Level Dis
Résumé du contenu de la page N° 3
DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately
Résumé du contenu de la page N° 4
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Parts Supplied Read and follow the instructions provided with any tools listed Check that all parts are included. here. Tools needed C D B ■ Pliers ■ 10" adjustable wrench A ■ Phillips screwdriver ■ Utility knife ■ Flat-blade screwdriver ■ Level ■ ³⁄₁₆" and ¼" nut drivers or ■ Electric drill hex sockets E F ■ ¹⁄₈" drill bit ■ Measuring tape or ruler ®† ■ Security T-20 TORX ■ 1½" hole sa
Résumé du contenu de la page N° 5
Product Dimensions Installation Clearances Cutout dimensions 24" 23³⁄₈" (61 cm) (59.5 cm) 23¹⁄₂" (59.7 cm) 24" 33³⁄₄" (61 cm) (85.7 cm) 33³⁄₄" (85.7 cm) Preferred utililty area 19¹⁄₄" 1¹⁄₂" (48.9 cm) (3.75 cm) A ¹⁄₂" (1.3 cm) 25" (63.5 cm) B 8" (20.3 cm) A. Choose left-hand or right-hand drain and water connection route. B. Choose left-hand or right-hand electric connection route. NOTE: All holes should be drilled at 1½" (3.8 cm) diameter. Water Supply Requirements ■ A hot water line
Résumé du contenu de la page N° 6
If direct wiring dishwasher: ■ Use flexible, armored or nonmetallic sheathed, copper wire Electrical Requirements with grounding wire that meets the wiring requirements for your home and local codes and ordinances. ■ Use strain relief method provided with house wiring junction WARNING box or install a UL-listed/CSA-certified clamp connector to the house wiring junction box. If using conduit, use a UL-listed/CSA-certified conduit connector. If connecting dishwasher with a power supply cord:
Résumé du contenu de la page N° 7
INSTALLATION INSTRUCTIONS 2. Drill 1½" (3.8 cm) diameter holes for drain and water hoses and electrical wiring as shown. Holes should be placed WARNING ½" (1.3 cm) from back wall. A Electrical Shock Hazard ¹⁄₂" Disconnect electrical power at the fuse box or circuit (1.3 cm) breaker box before installing dishwasher. 25" Failure to do so can result in death or electrical shock. (63.5 cm) B 1. Disconnect power. 2. Turn off water supply. 8" (20.3 cm) Unpack Dish Drawer WARNING A. Choose l
Résumé du contenu de la page N° 8
S S T TA ART T ELAY 4 8 HOURS Option 1: Solid surface countertop installation Option 2: Wood countertop installation ■ Install second set of mounting brackets 33½" (85 cm) from ■ Prepare dishwasher by folding over tabs located on the top floor. If needed, drill ¹⁄₈" pilot holes in cabinet. front as shown. 33¹⁄₂" (85 cm) PREPARE DISHWASHER WARNING H Tip Over Hazard Do not open dishwasher drawer until inside cabinet opening. Doing so can result in death or serious injury. WARNING 2. Place corn
Résumé du contenu de la page N° 9
Option 2: Left-hand side utility route H : X H : X 33³⁄₄" (85.7 cm) : 0" 34¹⁄₂" (87.6 cm) :⁵⁄₈" (1.6 cm) 34" (86.3 cm) :¹⁄₈" (0.3 cm) 34⁵⁄₈" (87.9 cm) :³⁄₄" (1.9 cm) 34¹⁄₈" (86.7 cm) :¼" (0.6 cm) 34³⁄₄" (88.3 cm) :⁷⁄₈" (2.2 cm) 34¹⁄₄" (87 cm) :³⁄₈" (1 cm) 34⁷⁄₈" (88.6 cm) :1" (2.5 cm) 34³⁄₈" (87.3 cm) :½" (1.3 cm) 35" (88.9 cm) :1¹⁄₈" (2.9 cm) 4. Place dishwasher in upright position. Route Electrical Wiring WARNING Route wire through 1½" (3.81 cm) hole located 8" (20.32 cm) above the floor. Elec
Résumé du contenu de la page N° 10
■ Slide dishwasher partway into the cabinet opening. Allow for Option 1: Right-hand side utility access access to the electrical terminal box. ■ For right-hand routing, drain hoses are shipped in the correct position. Place the water supply line in the clip as shown. Connect Water Supply Line and Drain Hoses 1. Connect water supply line to the water valve under the sink. A Option 2: Left-hand side utility access ■ For left-hand routing, remove drain hoses from the clips in the rear bracket a
Résumé du contenu de la page N° 11
5. Connect the drain hose using one of the following options: Option 3: Waste disposer and drain air gap Option 1: Waste disposer no drain air gap A C B C A B A. Drain hose connector B. Drain air gap C. Waste Option 4: No waste disposer, no drain air gap A. For new construction, remove disposer plug. B. Connect drain connector to waste disposer. C. Tighten clamp. A Option 2: No waste disposer and drain air gap B C C A B A. Drain hose connector B. Cut drain connector C. Waste NOTE: Attach the dra
Résumé du contenu de la page N° 12
Make Electrical Connection WARNING WARNING Electrical Shock Hazard Electrically ground dishwasher. Electrical Shock Hazard Connect ground wire to green ground connector in Disconnect electrical power at the fuse box or circuit terminal box. breaker box before installing dishwasher. Do not use an extension cord. Failure to do so can result in death or electrical shock. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Remove screw securing the electrical b
Résumé du contenu de la page N° 13
2 2 1 1 5. Check left to right level by placing the level on the top of the 5. Reinstall electric box cover with all wires contained inside the drawer. Check front to back level by placing level on the slide terminal box. rails. 6. Adjust legs with a ³⁄₁₆" socket wrench to level the dishwasher. Install Trim Pieces and Level Dishwasher 1. Open bottom drawer. 2. Push in clips and slide rails back 5" (12.7 cm). A 3. Lift drawer off slide rails. Place drawer off to the left on covering. Slide ra
Résumé du contenu de la page N° 14
2 2 8. Attach the toe kick bracket to the frame. 11. Place flexible side trim strips on both sides as shown. 9. Place trim strip into toe kick bracket. 12. Slide the dishwasher back into position in the cabinet opening. Check to ensure that the drain hose and electrical wiring are not kinked. Secure the Dish Drawers 1. Remove top drawer (same procedure as followed to remove bottom drawer) and set drawer on bottom drawer separated with corner packaging. 10. Attach toe kick bracket on the oppo
Résumé du contenu de la page N° 15
1 1 2 3. Attach dishwasher to upper cabinet mounting brackets. 2. Pull slide rails forward until they snap into position. Option 1: Solid surface countertop ■ Attach dishwasher to the side cabinet mounting brackets (installed earlier). A 3. Push top drawer in and repeat above steps for bottom drawer. 4. In the cabinet under the sink, coil excess drain hose and wrap with a zip tie. Plug in dishwasher or reconnect the power. A. Attach dishwasher to side cabinet mounting brackets. Option 2: Woo
Résumé du contenu de la page N° 16
CUSTOM PANEL INSTALLATION INSTRUCTIONS Custom Drawer Panels If you plan to install a custom wood panels, you will need to create the panels yourself or consult a qualified cabinetmaker or Preparing Custom Panels carpenter. See dimension drawings for panel specifications. 1. Lay the custom panels (top and bottom) face down on a IMPORTANT: clean, soft work surface. ■ The thickness of the custom panel must be ¹⁄₂" (12.7 mm) to 2. Using a pencil, mark the centerpoints for the 2 panel fastener ³
Résumé du contenu de la page N° 17
3. Using the screws provided, secure the custom panel to the inner door by screwing through the inner door and into the ¹⁄₈" Install Panel Fasteners (3.175 mm) pilot holes. 1. Remove the two panel fasteners from the face of the inner door of the upper drawer. 2. Screw the two panel fasteners into the panel fastener pilot holes of the custom panel. 3. Repeat steps 1 and 2 for the lower drawer. Mount the Custom Panel 1. Mount the upper custom panel to the drawer by aligning the panel fastene
Résumé du contenu de la page N° 18
SEGURIDAD DE LA LAVAVAJILLAS Su seguridad y la seguridad de los demás es muy importante. Hemos incluido muchos mensajes importantes de seguridad en este manual y en su electrodoméstico. Lea y obedezca siempre todos los mensajes de seguridad. Este es el símbolo de advertencia de seguridad. Este símbolo le llama la atención sobre peligros potenciales que pueden ocasionar la muerte o una lesión a usted y a los demás. Todos los mensajes de seguridad irán a continuación del símbolo de advertencia d
Résumé du contenu de la page N° 19
REQUISITOS DE INSTALACIÓN Piezas y herramientas Reúna las herramientas y piezas necesarias antes de comenzar la Piezas suministradas instalación. Lea y siga las instrucciones provistas con cualquiera Verifique que estén todas las piezas. de las herramientas enlistadas aquí. Herramientas necesarias C D B ■ Pinzas ■ Llave de tuercas ajustable A de 10" ■ Destornillador Phillips ■ Cuchillo para uso general ■ Destornillador de hoja plana ■ Nivel ■ Llave de tuercas o llave ■ Taladro eléctrico E F
Résumé du contenu de la page N° 20
Área de servicio preferida Medidas del producto 24" 23³⁄₈" A (61 cm) (59,5 cm) ¹⁄₂" (1,3 cm) 25" (63,5 cm) B 33³⁄₄" (85,7 cm) 8" (20,3 cm) A. Elija una ruta hacia la derecha o hacia la izquierda para la conexión del desagüe y del agua. B. Elija una ruta hacia la derecha o hacia la izquierda para la conexión eléctrica. NOTA: Todos los orificios deben ser taladrados con un diámetro de 1½" (3,8 cm). 19¹⁄₄" 1¹⁄₂" Requisitos del suministro de agua (48,9 cm) (3,75 cm) ■ Una tubería de a
