Résumé du contenu de la page N° 1
INSTALLATION INSTRUCTIONS
DRAWER DISHWASHER
INSTRUCCIONES DE INSTALACIÓN
DE LA LAVAVAJILLAS DE CAJÓN
INSTRUCTIONS D’INSTALLATION
LAVE-VAISSELLE À TIROIR(S)
Table of Contents/Índice/Table des matières..................................................................2
IMPORTANT:
Save for local electrical inspector's use.
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
IMPORTANTE:
Guarde para tenerlas a disposición del
Résumé du contenu de la page N° 2
TABLE OF CONTENTS DISHWASHER SAFETY............................................................................... 3 Prepare Cabinet Opening......................................................................... 7 Prepare Dishwasher ................................................................................. 8 INSTALLATION REQUIREMENTS ............................................................. 4 Tools and Parts............................................................................
Résumé du contenu de la page N° 3
DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately
Résumé du contenu de la page N° 4
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Parts Supplied Read and follow the instructions provided with any tools listed Check that all parts are included. here. Tools Needed C D B A ■ Pliers ■ 10" adjustable wrench ■ Phillips screwdriver ■ Utility knife ■ Flat-blade screwdriver ■ Level ■ ³⁄₁₆" and ¼" nut drivers or ■ Cordless drill hex sockets E F ■ ¹⁄₈" drill bit ■ Measuring tape or ruler ®† ■ Security T-20 TORX ■ 1½" hole sa
Résumé du contenu de la page N° 5
Installation Clearances Location Requirements IMPORTANT: Observe all governing codes and ordinances. Cutout Dimensions Failure to meet codes and ordinances could lead to fire or electrical shock. Proper installation is your responsibility. ■ Contact a qualified installer to ensure that the dishwasher is 24" (61 cm) installed to meet all electrical and plumbing national and local codes and ordinances. ■ Install the dishwasher as specified in these instructions. ■ Have everything you need to p
Résumé du contenu de la page N° 6
You must have: ■ 120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply. Electrical Requirements ■ Copper wire only. We recommend: WARNING ■ A time-delay fuse or circuit breaker. ■ A separate circuit. If direct wiring dishwasher: ■ Use flexible, armored or nonmetallic sheathed, copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances. Electrical Shock Hazard ■ Use strain relief method provided with house wiring junction box or ins
Résumé du contenu de la page N° 7
INSTALLATION INSTRUCTIONS 2. Drill 1½" (3.8 cm) diameter holes for drain and water hoses and electrical wiring as shown. Holes should be placed WARNING ½" (1.3 cm) from back wall. A Electrical Shock Hazard ¹⁄₂" (1.3 cm) Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. 25" Failure to do so can result in death or electrical shock. (63.5 cm) B 1. Disconnect power. 8" (20.3 cm) 2. Turn off water supply. Unpack Dish Drawer A. Choose left-h
Résumé du contenu de la page N° 8
S ST TA ART T ELAY 4 8 HOURS Option 1: Solid surface countertop installation ■ Install second set of mounting brackets 33½" (85 cm) from Prepare Dishwasher floor. If needed, drill ¹⁄₈" pilot holes in cabinet. WARNING 33¹⁄₂" Tip Over Hazard (85 cm) Do not open dishwasher drawer until dishwasher is inside the cabinet opening. If the dishwasher is not in the cabinet opening, slowly open the drawer while someone grasps the rear of the dishwasher. Failure to follow these instructions can resul
Résumé du contenu de la page N° 9
2. Using two or more people, place corner packaging on the Option 1: Right-Hand Side Utility Route floor and place dishwasher on its back. 3. Adjust leveling legs based on the cabinet opening measurement and the chart below. H : X H : X Route wire through 1½" (3.81 cm) hole located 33⁷⁄₈" (86 cm) : 0" 34¹⁄₂" (87.6 cm) :⁵⁄₈" (1.6 cm) 8" (20.32 cm) above the floor. 34" (86.3 cm) :¹⁄₈" (0.3 cm) 34⁵⁄₈" (87.9 cm) :³⁄₄" (1.9 cm) After routing the electrical wire through the right-hand hole, attach
Résumé du contenu de la page N° 10
Route Water Supply Line and Drain Hose 1. Connect water supply line to water valve on dishwasher. Option 1: Right-Hand Side Utility Access ■ For right-hand routing, place the water supply line in the clips. 2. Slide clamp onto drain hose, and then push hose into “Y” connector until fully seated. Several clicks will be heard. ■ Route drain hose on clips on bottom/back of unit. 3. Slide clamp into position over the “Y” connector. Option 2: Left-Hand Side Utility Access ■ For left-hand routin
Résumé du contenu de la page N° 11
■ Route water supply line and drain hoses into the cabinet. 4. Slide clamp into position (figures C and D). A B C D ■ Slide dishwasher partway into the cabinet opening. Allow for access to the electrical terminal box. 5. Connect the drain hose using one of the following options: Option 1: Waste Disposer No Drain Air Gap A C B Connect Water Supply Line and Drain Hoses 1. Connect water supply line to the water valve under the sink. A. For new construction, remove disposer plug. B. Connect drain c
Résumé du contenu de la page N° 12
Option 3: Waste Disposer and Drain Air Gap Make Electrical Connection A WARNING B C Electrical Shock Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. A. Drain air gap Failure to do so can result in death or electrical shock. B. Drain hose connector C. Waste 1. Remove screw securing the electrical box cover. Remove cover. Option 4: No Waste Disposer, No Drain Air Gap A B A. Drain hose connector B. Waste NOTES: ■ Attach the drain hose conne
Résumé du contenu de la page N° 13
2 2 5. Reinstall electric box cover with all wires contained inside the terminal box. WARNING Electrical Shock Hazard Electrically ground dishwasher. Connect ground wire to green ground connector in terminal box. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 3. Connect wires as follows using twist-on connectors sized to connect direct wire to 16-gauge dishwasher wire. Power supply wire: Terminal box wire: white white NOTE:
Résumé du contenu de la page N° 14
1 1 4. Slide the dishwasher into position in the cabinet opening. 8. Attach the toe kick bracket to the frame. Check that the drain hose and electrical wiring are not kinked. 5. Check left to right level by placing the level on the top of the drawer. Check front to back level by placing level on the slide rails. 9. Place the trim strip into the toe kick bracket. 6. Adjust legs with a ³⁄₁₆" socket wrench to level the dishwasher. A 10. Attach the toe kick bracket on the opposite side. A. Adjus
Résumé du contenu de la page N° 15
1 2 1 2 2 11. Place the flexible side trim strips on both sides as shown. 3. Attach dishwasher to upper cabinet mounting brackets. Option 1: Solid surface countertop Attach dishwasher to the side cabinet mounting brackets (installed earlier). A 12. Slide the dishwasher back into position in the cabinet A. Attach dishwasher to side cabinet mounting brackets. opening. Check that the drain hose and electrical wiring are not kinked. Option 2: Wood countertop Attach the dishwasher to the counterto
Résumé du contenu de la page N° 16
2. Pull slide rails forward until they snap into position. 3. Push top drawer in and repeat above steps for bottom drawer. 6. Select the Rinse Only cycle and press START/RESUME. Allow 4. In the cabinet under the sink, coil excess drain hose and wrap the dishwasher to fill, rinse and drain. Check for leaks. If leaks with a zip tie. are found, secure the connection and repeat this step. If you need Assistance or Service: WARNING Please reference the “Assistance or Service” section of the User
Résumé du contenu de la page N° 17
Notes 17
Résumé du contenu de la page N° 18
SEGURIDAD DE LA LAVAVAJILLAS Su seguridad y la seguridad de los demás es muy importante. Hemos incluido muchos mensajes importantes de seguridad en este manual y en su electrodoméstico. Lea y obedezca siempre todos los mensajes de seguridad. Este es el símbolo de advertencia de seguridad. Este símbolo le llama la atención sobre peligros potenciales que pueden ocasionar la muerte o una lesión a usted y a los demás. Todos los mensajes de seguridad irán a continuación del símbolo de advertencia d
Résumé du contenu de la page N° 19
■ Tener todo lo necesario para instalar la lavavajillas ■ Ponerse en contacto con un instalador calificado para adecuadamente. asegurarse de que la lavavajillas haya sido instalada de manera que cumpla con todos los códigos y ordenanzas eléctricos y de plomería nacionales y locales. REQUISITOS DE INSTALACIÓN Piezas y herramientas Reúna las herramientas y piezas necesarias antes de comenzar la Piezas suministradas instalación. Lea y siga las instrucciones provistas con cualquiera Verifique q
Résumé du contenu de la page N° 20
Espacios libres para la instalación Requisitos de ubicación IMPORTANTE: Observe todos los códigos y reglamentos Dimensiones de corte aplicables. Si no se siguen los códigos y ordenanzas, esto podría hacer que se produzca un incendio o choque eléctrico. La instalación correcta es su responsabilidad. ■ Póngase en contacto con un instalador calificado para 24" asegurarse que la lavavajillas haya sido instalada de manera (61 cm) que cumpla con todos los códigos y ordenanzas eléctricos y de plo
