Résumé du contenu de la page N° 1
Operating instructions
for dishwashers
To prevent accidents and reduce
the risk of damaging the machine, ö
read the Operating Manual
before installing or using
the machine. M.-Nr. 04 390 922
Résumé du contenu de la page N° 2
Contents Contents Guide to the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Before using for the first time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Opening and closing the door
Résumé du contenu de la page N° 3
Guide to the appliance Guide to the appliance Miele dishwashers are available in two versions: 1. Integrated (“i”) dishwashers “i”- dishwashers are designed for instal- lation under a continuous countertop. The control panel with its accessories is included with the “i”- dishwasher in a separate package for on-site installa- tion. The front is designed to accept a custom made panel, matching the exist- ing kitchen cabinets. Installation directions can be found in the Installation chapter. 2. “U”
Résumé du contenu de la page N° 4
Guide to the appliance 4
Résumé du contenu de la page N° 5
Guide to the appliance 1. Upper spray arm (not visible) 2. Cutlery tray 3. Inlet funnel for middle spray arm 4. Upper basket 5. Water hardness selector 6. Middle spray arm 7. Lower spray arm 8. Four height adjustable levelling legs 9. Combination filter 10. Salt reservoir 11. Dual compartment detergent dispenser 12. Rinse aid reservoir (with dosage selector) 13. Data plate 14. On/Off button 15. Door release 16. Child safety lock 17. Time display 18. Pushbutton switches 19. “Check” i
Résumé du contenu de la page N° 6
IMPORTANT SAFETY INSTRUCTIONS Repairs should only be carried out WARNING by qualified personnel. Disconnect the appliance from the power supply When using your dish- before servicing (pull out the plug or washer, follow all basic turn off the circuit breaker). safety precautions. If not purchased specifically as a This appliance conforms to “Freestanding” model, only install all uniform safety codes and the dishwasher under a continuous regulations. To avoid injury countertop which is secured to
Résumé du contenu de la page N° 7
IMPORTANT SAFETY INSTRUCTIONS When loading items to be washed: – Locate pointed items so that they are not likely to damage the door seal. – Load knives with the cutting edge down to reduce the risk of injuries. Do not wash plastic items unless they are labeled “dishwasher safe” or the equivalent. For items not labeled, check the manufacturer’s recommenda- tions. Do not abuse, sit, or stand on the door or dishracks of the dish- washer. Remove the front door and cut off the power cord of the di
Résumé du contenu de la page N° 8
Caring for the environment Caring for the environment Disposal of the packing material. Energy saving washing. The cardboard box and packing ma- These dishwashers are exceptionally ef- terial protects the appliance during ficient in their use of water and elec- shipping. It has been deliberately de- tricity. You can make the most of your signed to be biodegradable and recy- appliance by following these tips: clable. Please dispose of these ma- Make full use of the baskets without terials as you
Résumé du contenu de la page N° 9
Before using for the first time Before using for the first time Add the correct amount of detergent. Before using for the first time please note the following points: Follow the detergent manufacturer’s recommendations on how much deter- gent to use. Not enough or too much Setting the water softener. detergent can lead to poor wash re- The water softener must be set to corre- sults. spond to the water hardness in your Cleaning results vary from brand to area. This can be obtained from your brand
Résumé du contenu de la page N° 10
Opening and closing the door Opening and closing the door To open the door. Child safety lock. Press the release catch inside the The child safety lock is designed to door grip. deter children from opening the dish- washer door. If the door is opened during operation, all functions are automatically inter- Use the key provided to turn the rupted. child safety lock to the required set- ting. To close the door. Horizontal setting = The door is Push the baskets in. locked. Lift the door and push un
Résumé du contenu de la page N° 11
Water softener Water softener The water softener must be set to corre- Settings spond to the water hardness in your value water area. This can be obtained from your gr/gal ppm °f for level local water company, or by using a test program- selector kit that can be purchased from the ming (Setting) Miele Parts Department. 1 20 2 1 6 2 40 4 2 6 To avoid the build up of calcium de- 3 50 5 3 6 posits on dishes, cutlery, and in the 4 70 7 4 6 5 90 9 5 6 dishwasher, if the water hardness is 6 110 11 6 6
Résumé du contenu de la page N° 12
Water softener Press the “Top Solo” button as often To set the water softener for a hard- as necessary until the value of your ness level of 1-35 gr/gal: water hardness in gr/gal appears in the display. Example: For a water hardness of 30 gr/gal: Keep pressing the “Top Solo” button until “30” appears in the time display. After the figure “36” is reached the counter returns to “0”. Value “0” must not be set! Press the “START” button twice to Check that the water hardness selec- store the change i
Résumé du contenu de la page N° 13
Water softener Example: Setting the water softener for a hard- ness level of 36 - 70 gr/gal requires The water hardness is 60 gr/gal. the following two step procedure: The water hardness selector in the wash cabinet must be set to 5, 1. (48 - 65 gr/gal). Turn the dishwasher off. Turn the program selector knob to the “STOP” position. Press the “Delay start” and “START” buttons at the same time, while turn- ing the machine on. A “P” and a num- ber will appear in the time display. Set the program
Résumé du contenu de la page N° 14
Water softener Filling the salt reservoir. The salt reservoir should be filled be- fore the first use and when the “Salt” in- dicator lamp lights up. Use water sof- tener reactivation salt (1 - 4 mm grain size), as other salts may contain inso- luble additives which can impair the functioning of the softener. The salt reservoir holds approx. 4 lbs (2 kg) of salt. Inadvertently filling the salt reservoir with dishwashing detergent will damage the water softener. Make sure that only water softene
Résumé du contenu de la page N° 15
Water softener Salt indicator. Bypassing the Salt indicator lamp. In order to bypass the salt indicator lamp, you will need a screwdriver and needle nose pliers. Remove the salt reservoir cap. Looking into the salt reservoir, you will see the top of the float chamber on the right hand side b. When the salt reservoir is empty, the “Salt” indicator lamp will light, notifying you that the reservoir should be refilled with reactivation salt. After the reservoir has been filled, the water softener is
Résumé du contenu de la page N° 16
Adding rinse aid Adding rinse aid The use of Rinse Aid is recommended Adding rinse aid. to prevent spotting on dishes and glass- ware that normally occurs during the drying phase of automatic dishwashing. Inadvertently filling the rinse aid reservoir with detergent always leads to damage to the reservoir. Only pour rinse aid formulated for residential dishwashers into the reservoir. Add Rinse Aid before the first use and anytime the “Rinse Aid” indica- tor lamp comes on. Press the button in the
Résumé du contenu de la page N° 17
Adding rinse aid Setting the dosage. Close the dishwasher door halfway The dosage selector comes factory set and pour liquid rinse aid into the stor- to 3. It can be adjusted from 1 to 6, de- age container until it is visible on the pending on your requirements. surface of the screen. Do not add Use a higher setting if spots appear aid until the “Rinse aid” indicator on dry glassware. lamp comes on. If streaking appears on dishes or Only use rinse aid specifically glasses, use a lower setting. l
Résumé du contenu de la page N° 18
Loading the dishwasher Loading the dishwasher Load the dishes so that water can Some loading examples are shown on contact all surfaces. the following pages. Do not place dishes and cutlery in- side other pieces where they may be Note concealed. If the additional feature “Top Solo” has Hollow items such as cups and been selected with a wash program, all glasses should be inverted and items must be loaded into the upper placed in the upper basket. basket and cutlery tray. See the “Addi- tional fe
Résumé du contenu de la page N° 19
Loading the dishwasher Cutlery tray. Loading examples. The easily loaded cutlery tray ensures thorough cleaning of cutlery and cook- ing utensils. In addition, the cutlery tray insert is removable and can be carried to a drawer or table for easy loading or unloading, thereby eliminating much of the handling of the cutlery. Upper basket. For small, lightweight, or delicate items such as cups, saucers, glasses, des- sert bowls, etc. The plate inserts on the left and right rear of the lower basket
Résumé du contenu de la page N° 20
Loading the dishwasher Place the heads of cutlery with round To make unloading easier, cutlery can or oval handles in the holders. This will be grouped in zones, one for knives, secure them during the wash cycle. one for forks, etc. Ensure that spoon heads are in contact Spoon heads should be placed so that with at least one holder so they cannot water can run off them freely. flip over and collect water. Do not cover the opening in the middle of the cutlery tray, and make sure that the upper sp
