Résumé du contenu de la page N° 1
Résumé du contenu de la page N° 2
Important Safeguards and Precautions FOR YOUR SAFETY, READ AND RETAIN ALL SAFETY OUTDOOR ANTENNA INSTALLATION AND OPERATING INSTRUCTIONS. HEED ALL 1 SAFE ANTENNA AND CABLE CONNECTION WARNINGS IN THE MANUAL AND ON THE UNIT If an outside antenna or cable system is connected to the equipment, be sure the antenna or cable system is grounded INSTALLATION so as to provide some protection against built up static NEC - NATIONAL charges and voltage surges. ELECTRICAL CODE 1 POWER SOURCE CAUTION ANTENN
Résumé du contenu de la page N° 3
Safety Precautions/Mesures de sécurité WARNING: To prevent fire or shock hazard, do not expose this equipment to rain or moisture. CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert. Avertissement: Afin de prévenir tout risque d’incendie ou de chocs électriques, ne pas exposer cet appareil à la pluie ou à une humidité excessive. Attention: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise
Résumé du contenu de la page N° 4
Before Using Disc formats supported by this DECK Congratulations DECK can play back discs bearing any of the following on your purchase of one of the most marks: [Discs Played 8cm (3") or 12cm (5")] sophisticated and reliable products on the Logo Disc type market today. Used properly, it will bring you years of enjoyment. Please fill in the DVD (DVD-Video) information below. The serial number is on the DVD-R (DVD-Video formatted tag located on the back of your DECK. discs [finalized]) Date of
Résumé du contenu de la page N° 5
Initial Setup VCR DVD For Your Basic (Connection) Operation Operation Information Operation Table of Contents DVD / VCR Important Safeguards and Precautions ............................ 2, 3 Before Using ............................................................................ 4 DECK & Cassette Information ........................................... 6 , 7 Location of Controls ....................................................... 8 ~ 10 Displays (On Screen Displays and Multi Function Displa
Résumé du contenu de la page N° 6
R R DECK & Cassette Information Head Cleaning Prevent Accidental Tape Erasure Playing older or damaged tapes may eventually Break off the tab to cause video heads to become clogged. prevent recording. Video Head Clog Sensor Record Tab During playback, this screen appears if V I DEO HEADS MAY NEED CLEAN I NG Screw driver clogging is detected. PLEASE I NSERT HEAD CLEAN I NG CASSETTE To remove screen, OR REFER TO MANUAL press PLAY on the To record again remote or DECK. END :
Résumé du contenu de la page N° 7
Initial Setup (Connection) Specifications Power Source: 120 V AC, 60 Hz Power Consumption: Power On: Approx. 32 watts, Power Off: Approx. 4 watts Video Signal: EIA Standard NTSC color Video Recording System: 4 rotary heads helical scanning system Audio Track: 1 track (Normal), 2 channel (Hi-Fi Audio Sound) Tuner: Broadcast Channels: VHF 2 ~ 13, UHF 14 ~ 69 CABLE Channels: Midband A through I (14 ~ 22), Superband J through W (23 ~ 36) Hyperband AA ~ EEE (37 ~ 64), Lowband A-5 ~ A-1 (95 ~ 99) Spec
Résumé du contenu de la page N° 8
Location of Controls Bold: VCR Function Remote Control Italic: DVD Function Bold Italic: VCR and DVD Functions Normal: Others EJECT / INPUT p. 35 OPEN / CLOSE pp. 20, 22 TV mode POWER p. 28 CHANNEL / TRACKING / V-LOCK pp. 6, 21 NUMBER keys VOLUME + / - p. 28 ACTION pp. 18, 47 ADD/DELETE / CLEAR pp. 19, 39, 46 SET MENU p. 38 VCR mode SELECT p. 28 STOP DVD mode pp. 20, 22 p. 28 FAST FORWARD / PLAY SEARCH / SLOW+ pp. 20, 22 pp. 20, 23 SKIP REWIND / SEARCH / SKIP SLOW- p. 23 pp. 20, 23 TITL
Résumé du contenu de la page N° 9
Résumé du contenu de la page N° 10
Location of Controls (continued) Bold: VCR Function Italic: DVD Function Rear View of DECK Bold Italic: VCR and DVD Functions AC Power Plug VHF/UHF Antenna Output Terminal p.12 While plugged into an AC outlet, this DECK consumes 4 W of electrical power in off mode. VHF/UHF Antenna Input Terminal p. 12 Component Video Output Connector (Y, PB, PR) (DVD Only) p. 13 Video Output Video Input Connector Connector p. 12 p. 35 S-Video Out Audio Input Optical Digital Audio Audio Output 2 Connector Co
Résumé du contenu de la page N° 11
Initial Setup (Connection) Displays (On Screen & Multi Function) On Screen Displays (VCR) Function & Channel Displays Blank Tape/ No Video Signal Indications When a function button CH 0 8 Whenever a blank section of a tape is pressed, e.g. PLAY, comes up in Play mode, or when the or you change selected channel has no broadcast channels, a 5-second signal with Weak Signal Display display appears. Feature (p. 33) set to OFF, the TV screen will turn solid blue. Function Status Current Time Channel
Résumé du contenu de la page N° 12
Connections Basic Connections If your TV has AUDIO and VIDEO IN terminals, connect them to DECK for higher quality picture and sound. You can enjoy stereo sound even if your TV is not stereo by connecting a stereo amplifier to DECK. a Connect DECK and TV with an RF Coaxial Cable (supplied) or an AV Cable b (not supplied) as shown in the figure below. DSS Receiver DECK TV DECK TV Cable Box DECK TV Antenna or Cable DSS Receiver IN IN Cable
Résumé du contenu de la page N° 13
Initial Setup (Connection) Other Connections You Can You Cannot With a Cable Box (DECK Cable Box TV) view any record (including scrambled DVD/VCR DECK ANT or CATV scrambled) TV channels. channel. IN FROM ANT. IN 1 OUT IN OUT R Cable Box use Remote VHF/ AUDIO VHF/UHF L UHF OUT TO TV IN OUT Control to select VIDEO channels without using Multi-brand control feature. Connect With Two Cable Boxes You Can You Cannot DVD/VCR DECK ANT record and view view a
Résumé du contenu de la page N° 14
Connections (continued) Audio Connections Ready Checklist Turn down the volume, then turn DECK, as well as other equipment to be connected, off before proceeding with connection. Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely. Read through the instructions before connecting other equipment. Ensure that you observe the color coding when connecting audio and video cables. Connecting Amplifier (2ch stereo system) [Analog connection] Speake
Résumé du contenu de la page N° 15
Résumé du contenu de la page N° 16
Initial Setup for Basic Connections (Ready to Play) Before doing Initial Setup Turn TV on. 1 a b See connections RF Coaxial Cable Connection and AV Cable Connection on p. 12. 2 Set TV to channel 3. Set TV to VIDEO. [DECK ➛ ➛ ➛ ➛ ➛ TV] 3 Go to “Doing Initial Setup (Ready to Play).” (See below.) [Cable Box ➛ ➛ ➛ ➛ ➛ DECK ➛ ➛ ➛ ➛ ➛ TV], [DSS ➛ ➛ ➛ ➛ ➛ DECK ➛ ➛ ➛ ➛ ➛ TV] Turn on Cable Box and set it to your Public Broadcasting Station (PB
Résumé du contenu de la page N° 17
Résumé du contenu de la page N° 18
➡ ➡ Reset Language, Channels, Clock, VCR’s MENU Press ACTION* PROGRAM functions are not available SET UP VCR 1 when using COMPONENT Video Output SET CLOCK to display MENU. SET UP CHANNEL and S-VIDEO OUT. Please set TV to IDIOMA/LANGUE : ENGLISH VCR’S OUTPUT CH:3 either RF INPUT or VIDEO INPUT, and then press PROGRAM. SELECT : SET:SET EXIT : ACTION Language Channels Clock 2 1) Press to select 1) Press to select 1) Press to s
Résumé du contenu de la page N° 19
Résumé du contenu de la page N° 20
