Instruction d'utilisation Audiovox APS-92BT-CL

Résumé du contenu de la page N° 1

Model APS-92BT-CL
Owner's Manual
Transmitter Programming Guide
Transmitter Button Functions
The transmitters included in the security system kit are pre-programmed at the factory, with
button # 1 assigned to channel one only. The suggested program arrangement is listed below.
To program channel 2 and 3, please follow the programming instructions listed on pages two
and three of this manual.
Factory Settings for Transmitter Buttons
Button Channel System Function
Remote Arm/Disarm
Remote Emergen

Résumé du contenu de la page N° 2

These factory programmed settings can be prioritized based on an individual's frequency of use, (i.e. pressing both buttons simultaneously to activate channel 1, arm/disarm etc.) by following the normal programming instructions below. Please note when changing the button sequences of the factory settings, it is necessary to perform steps 5, 9, and 12 three times using "transmitter A", followed by one time using "transmitter B". PROGRAMMING TRANSMITTERS: It is important to remember that during pr

Résumé du contenu de la page N° 3

6. Move the valet/bypass switch on, then off again. 7. The dash mounted L. E. D. will flash 2 times, and the siren will "chirp" one time, indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc. 8. You can assign any one of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to operat

Résumé du contenu de la page N° 4

BATTERY REPLACEMENT: The transmitter incorporates a small red L.E.D. built into the case. This L.E.D. can be used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. To replace the battery... 1. Remove the transmitter cover by removing the small screw from the back of the transmitter case. 2. Remove the discharged battery, making note of the orientation of the + and - contacts, and dispose of properly. 3. Install the new (

Résumé du contenu de la page N° 5

ORDERING ADDITIONAL or REPLACEMENT TRANSMITTERS: Order Form for Additional 2 Button Transmitters Model: APS-92BT-CL IMPORTANT: Read instructions below and legibly print all required infor mation. 1. Fill in the following information NAME ADDRESS STATE ZIP CODE CITY DATE PURCHASED WHERE PURCHASED 2. Enter the number of transmitters requried here 3. The cost per transmitter is $65.00 4. Enter total amount enclosed here $ (N.Y. State residents only: Include appropriate state sales tax) 5

Résumé du contenu de la page N° 6

Audiovox Corporation 150 Marcus Blvd. Hauppauge, N.Y. 11788 Form No. 128-4855