Résumé du contenu de la page N° 1
Installation and operating instructions
for HomEntry garage door opener
Model HE60R
ChamberlainAustralia Pty Ltd
Phone toll free 1800 638 234
Fax toll free 1800 888 121
Chamberlain New Zealand Ltd
Phone toll free 0800 637 546
Fax toll free: 0800 653 663
www.homentry.com.au
This manual contains IMPORTANT SAFETY information.
DO NOT PROCEED WITH THE INSTALLATION BEFORE READING THOROUGHLY.
Résumé du contenu de la page N° 2
0
Résumé du contenu de la page N° 3
Start by Reading These Important Safety Instructions WARNING: Failure to comply with the following instructions may result in serious personal injury or property damage. • Read these instructions carefully and followALL instructions carefully � The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual. These safety alert symbols mean WARNING – a personal safety or property damage
Résumé du contenu de la page N° 4
Carton Inventory 1 1. Instruction manual (this document) 2. Stop bracket collar 3. Clamp bracket 4. Release handle and cord 5. Remote controls (2) 6. Extension poles (2) 7. Weight bar 8. Bracket plate 9. Hardware bag 10. Warning Labels (2) Tools Required 2 1. Ladder (or similar device to safely support door weight) 2.Adjustable wrench for U-bolts already installed on the door 3. 8mm socket, 10mm socket and 13mm extended socket and socket wrench 4. 30mm socket extension (for minimum sideroom inst
Résumé du contenu de la page N° 5
3 Door Requirements The maximum allowable door height is 3.5m with a maximum curtain area of 8m² (door height in metres multiplied by the width in metres). The maximum allowable door weight is 60kg. Door area; 2 hxw=m 2 eg.2.5x3=7.5m Minimum side room installation Typical side room installation Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe requ
Résumé du contenu de la page N° 6
4 Testing the door Disable all locks and remove any ropes connected to the garage door. Complete the following test to ensure your door is well balanced, and not sticking or binding: � Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring. � Raise and lower the door to discover if there are any sticking or binding points. SAFETY CHECK! � If your door spring does not hold the door in place or the Is your door balanced? YES (proceed to the door
Résumé du contenu de la page N° 7
7 Preparing the Opener Set Opener Position (Left or Right hand) For left hand side installations For right hand side installations the wire jumper should be removed. the wire jumper should be in place (factory installed). Attaching the Extension Poles (if required) � Insert the extension poles into the gear. �Align the extension pole holes with the gear holes. � Using the supplied screws secure the extension poles. Place the Opener in Manual Release mode. � Pull the release cord down and across
Résumé du contenu de la page N° 8
8 Installation steps FOR RIGHT HAND INSTALLATIONS (REFER SECTION 7, page 5) � Ensure that the opener position jumper (wire connector) is installed (refer Section 7, page 5). � Place the opener in manual release mode (refer Section 7, page 5). �Opentherollerdoorfully.Forsafety,tiearopearoundthedoor. Ensure that the U-bolt on the left hand side of the door is secure. � Mark the position of the door shaft on the right hand door bracket. SAFETY CHECK! � Carefully remove the U-bolt on the right hand
Résumé du contenu de la page N° 9
9 Attach the Release Handle and Cord � Thread one end of the rope through the hole in the top of the red handle so “NOTICE” reads right side up as shown. Secure with an overhand knot at least 25mm from the end of the rope to prevent slipping. � Thread the other end of the rope through the loop of the manual release cable. �Adjust rope length so the handle is no higher than 1.8m above the floor. Secure with an overhand knot. If the door is greater than 2.5m in height the Release Cord Extension ki
Résumé du contenu de la page N° 10
12Setting the Limits The Travel Limits regulate the points at which the door will stop when moving UP or DOWN. During the SetUp procedure, the motor will run and operate the door. The Opener must be fully installed on the door and all installation steps completed before proceeding. Make sure the door is clear of obstruction. Ensure your hands are away from any moving parts before activating the door. Position the door about half way and Engage the motor. (Section 10 page 7). Remove the Lens cove
Résumé du contenu de la page N° 11
13 Setting the Force The force, as measured on the closing edge of the door, should not exceed 400N (40kg). If the closing force is measured to more than 400N, the Protector System must be installed. See Section 16. The force setting regulates the amount of power required to open and close the door. � Door should be closed. � Press the PURPLE button twice to enter opener into ForceAdjustment Mode. The indicator LED will flash quickly (The Courtesy LEDs dim). � Press the Green start button on the
Résumé du contenu de la page N° 12
Install the Protector System™ 16 (Safety Beams) Install this accessory for all installations where the SAFETY FIRST! closing force as measured on the bottom of the Whilst Chamberlain have engineered door is over 400N (40kgf). safety features into your garage door opener, we urge you to consider fitting After opener has been installed and adjusted, The Safety Beams to your new garage door Protector System™ accessory can be installed. opener. In many countries these devices Instructions are includ
Résumé du contenu de la page N° 13
Special Features 18 � Multi function Control Panel Connect white/red wire to the red quick connect terminal and the white wire to the white quick connect terminal. � The Protector System™ (Safety Beams) Connect both white wires to the white quick connect terminal and both white/black wires to the grey quick connect terminal. 19 Motorlift/ HomEntry Compatible Accessories 5. Model 770AMLThe Protector System 1. Model 84330AML Single-Function Remote Control 6. Model 845AML Control Panel 2. Model 833
Résumé du contenu de la page N° 14
Troubleshooting � Repeat the limit and force setting in Section 12 & 13, pages 8 & 9 . Repeat safety reverse test after 1. The opener doesn't operate from either the adjustments (Section 14 page 9). GREEN start button or the remote controls: � If The Protector System is installed check the beams, �Doestheopenerhaveelectricpower?Plugalampinto both Red LEDs should be on. the outlet. If it doesn't light, check the fuse box. 9. The opener strains to operate door: � Have you disabled all door locks?
Résumé du contenu de la page N° 15
MAINTENANCE OF YOUR OPENER SPECIFICATIONS HE60R Input Voltage: 230-240VAC, 50Hz, 85W Once a Month: � Repeat safety reverse test. Rated Load: 15Nm Make any necessary adjustments (see pages8&9). Max.Pull Force: 450N � Manually operate door. If it is unbalanced or binding, call Max. Door Weight 60kg for professional garage door service. Idle Current: less than 25mA@ 230VAC � Check to be sure door opens and closes fully. Set Limits and/or Force if necessary. Drive: DC gearmotor permanent lubrication
Résumé du contenu de la page N° 16
CHAMBERLAIN LIMITED WARRANTY Liability –Australia only HomEntry HE60R Under no circumstances shall the Seller be liable for Roller Door Operator consequential, incidental or special damages arising in connection with the use, or inability to use, the Unit. In no ChamberlainAustralia Pty Limited / Chamberlain New Zealand event shall the Seller's liability for damages or injury arising Limited (Seller) warrants to the original purchaser of the from breach of law or contract or for negligence, exce
