Résumé du contenu de la page N° 1
INSTALLATION/OPERATION MANUAL
Vistage™ Series
Ultra-Thin Flat-Panel Displays
Models V-50HD and V-63HD
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
RuncoCare™ Standard Two Year Limited Warranty Congratulations on your purchase of a Runco® product! With proper installation, setup and care, you should enjoy many years of unparalleled video performance. This RuncoCare Standard Limited Warranty is provided free of charge by Runco International, LLC (“Runco”) with the purchase of a covered Runco product. The following sets forth Runco’s Standard Limited Warranty applicable to all Runco projectors, processors, LCD display and plasma display
Résumé du contenu de la page N° 4
RuncoCare Claim Procedure In the event of a product defect, please follow the warranty claim procedure provided below: 1. The Customer is required to contact a Runco dealer or Runco Technical Support via email at support@runco.com or via phone at (toll free) (800) 23RUNCO (800-237-8626). If the customer is located outside North America, call +3589 4200 554 in Europe for product service. 2. Be prepared to provide the date of purchase, the place of purchase, serial number, product model number
Résumé du contenu de la page N° 5
h Expected lamp degradation and normal decrease in lamp output over a period of time or as the lamp is consumed i Customer caused defects, including but not limited to, scratched/defaced/altered plastics j Failure to follow maintenance procedures as outlined in the product’s user guide where a schedule is specified for regular cleaning of the product k Opening the product and/or tampering with internal circuitry l Products lost, stolen or discarded m Any damage or dissatisfaction associate
Résumé du contenu de la page N° 6
Online Product Registration Please visit http://www.runco.com/support/product-registration/ to register product. Limitation of Implied Warranties RUNCO PROVIDES NO WARRANTIES, EXPRESS OR IMPLIED, EXCEPT THOSE EXPRESSLY PROVIDED HEREIN. RUNCO EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Exclusion of Damages RUNCO’S MAXIMUM AGGREGATE LIABILITY HEREUNDER IS LIMITED TO THE COST OF REPAIR OR REPLACEMENT OF THE
Résumé du contenu de la page N° 7
Important Safety Instructions Thank you for your purchase of this quality Runco video product! For the best performance, please read this manual carefully as it is your guide through the menus and operation. WARNING This symbol is intended to alert the user to the presence of CAUTION RISK OF ELECTRIC SHOCK uninsulated “dangerous voltage” within the product’s enclosure DO NOT OPEN that may be of sufficient magnitude to constitute a risk of electric shock. CAUTION: TO REDUCE THE RISK OF ELECTR
Résumé du contenu de la page N° 8
PRODUCT DISPOSAL: The Product contains small amounts of tin, lead and/or mercury. Disposal of these materials may be regulated due to environmental considerations. IMPORTANT RECYCLE INSTRUCTIONS Lamp(s) inside this product contain mercury. This product may contain other electronic waste that can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal Laws. For more information, contact the Electronic Industries Alliance at WWW.EIAE.ORG. For l
Résumé du contenu de la page N° 9
1Table of Contents RuncoCare™ Standard Two Year Limited Warranty ................................................... iii Important Safety Instructions ....................................................................................... vii 1. Introduction ...............................................................................................................1 About This Manual .......................................................................................................1 Targe
Résumé du contenu de la page N° 10
Table of Contents Connecting an Audio Processor or Secondary Display Device to the DHD Controller (Optional)............................................................................22 RS-232 Controller Connection..............................................................................23 Ethernet Network Connection...............................................................................23 Connecting to AC Power .......................................................................
Résumé du contenu de la page N° 11
1List of Figures 2-1. V-50HD Front-Panel Controls and Indicators................................................................5 2-2. V-63HD Front-Panel Controls and Indicators................................................................5 2-3. V-50HD/V-63HD Rear Panel ........................................................................................6 2-4. DHD Controller Front Panel ..........................................................................................7 2-5. DHD Cont
Résumé du contenu de la page N° 12
List of Figures Notes: xii Vistage™ Series Flat-Panel Display Installation/Operation Manual PRELIMINARY
Résumé du contenu de la page N° 13
Introduction 1. Introduction This Owner’s Manual describes how to install, set up and operate the Runco Vistage™ 1.1 Series Flat Panel Display and DHD Controller. About This Manual Throughout this manual, the Runco Vistage™ Series Flat Panel Display and DHD Controller is referred to as the “V-50HD/V-63HD.” Runco has prepared this manual to help installation personnel and end users get the most Target Audience out of the V-50HD/V-63HD. Runco has made every effort to ensure that this manual
Résumé du contenu de la page N° 14
Introduction Graphic Conventions: These symbols appear in numerous places throughout the manual, to emphasize points that you must keep in mind to avoid problems with your equipment or injury: TIPS highlight time-saving short cuts and helpful guidelines for using Tip certain features. NOTES emphasize text with unusual importance or special Note significance. They also provide supplemental information. CAUTIONS alert users that a given action or omitted action can Caution degrade performa
Résumé du contenu de la page N° 15
Introduction Runco introduces its Vistage™ Series of ultra-thin flat panel displays, combining elegance, 1.3 beauty and unparalleled customization with the stellar video performance that is Description, Features synonymous with the Runco brand. These flat panel displays offer a stylish solution that and Benefits can be personalized to reflect the style and passion of its homeowner. Unlike most other thin panel televisions, the entire front of the Vistage display is comprised of solid glass
Résumé du contenu de la page N° 16
Introduction Key Features and Benefits The V-50HD/V-63HD offers these key features and benefits: ➤ � Ultra-thin 1.7” panel inside a sleek, elegant design � 50” (V-50HD) or 63” (V-63HD) diagonal screen size � Completely customizable finish options with Runco FinishPalette™ � Emissive Cell Structure™ that delivers exceptional brightness and viewing angles � Solid glass front for better viewing performance when the display is on and a more uniform finish when it is off � Ships with Runco’s new D
Résumé du contenu de la page N° 17
Controls and Functions 2. Controls and Functions 2.1 Vistage Series at a Glance Figure 2-1 and Figure 2-2 show the V-50HD/V-63HD front-panel controls and indicators. Front-Panel Controls and Indicators 1 2 3 4 Figure 2-1. V-50HD Front-Panel Controls and Indicators 1 4 2 3 Figure 2-2. V-63HD Front-Panel Controls and Indicators Vistage™ Series Flat-Panel Display Installation/Operation Manual 5 PRELIMINARY
Résumé du contenu de la page N° 18
Controls and Functions 1. REMOTE CONTROL SENSOR Receives the signals from the remote control. 2. STANDBY INDICATOR Lights blue to indicate that the V-50HD/V-63HD is in standby mode; otherwise, it is off. 3. DISPLAY STAND Optional accessory for table-top installations. 4. SPEAKER BAR Optional accessory that can be mounted to the bottom of the panel. Rear-Panel Connectors Figure 2-3 shows the rear-panel connector locations on the V-50HD/V-63HD. ➤ SECONDARY SERVICE PRIMARY INPUT PORT INPUT 1
Résumé du contenu de la page N° 19
Controls and Functions The rear-panel connectors reside behind protective cover plates with cable routing slots. Use a Phillips screwdriver to remove the plates in order to connect cables, and to re-attach them afterward. To minimize the amount of space required behind the panel when Note wall-mounted, the connectors are recessed and right-angled relative to the rear panel surface (the AC input faces right and the other input connectors face downward). 1. AC POWER INPUT Connect the V-50H
Résumé du contenu de la page N° 20
Controls and Functions Figure 2-5 shows the rear connector panel on the DHD Controller. 2.3 DHD Controller Rear Panel H HD1 1 RS-232 Y Y Vi Vi Vi Vi Video 1 d deo deo deo deo 1 1 1 1 1 V Viideo 2 deo 2 HDMI Out To Display H HD2 2 Pb Pb Pr Pr V Viideo 3 deo 3 HDMI Out PC / Control HDMI 2 HDMI HDMI 2 2 HDMI 4 HDMI HDMI 4 4 Ethernet Audio Only 1 2 38 4 5 6 7 9 Figure 2-5. DHD Controller Rear Panel 1. POWER INPUT (100 to 240 VAC) Connect the DHD Controller to power here. 2. HD1 / HD2 (5 x Analog
