Instruction d'utilisation American Standard Heritage Elongated One-Piece Toilet 2071.016

Résumé du contenu de la page N° 1

HERITAGE1.6 GPF ONE-PIECE TOILET
INSTALLATION
2071.016
INSTRUCTIONS
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not

Résumé du contenu de la page N° 2

6 MTG. CLIP COVER BOLT NUT WASHER CLOSET FLANGE INSTALL TOILET a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor. ! CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED! b. Install caps on washers. (If necessary, cut bolt height to size before installing caps.) c. Smooth off the bead of sealant around base. Remove excess sealant. 7 INSTALL TOILET SEAT Install t

Résumé du contenu de la page N° 3

9 10 ARM TOP REFILL ADJUSTMENTS NIPPLE TUBE a. Adjust water level. Water level TANK should be adjusted to level LEVER CRITICAL LEVEL indicated on tank by adjusting float MARK ("C.L.") MUST BE cup. 1" ABOVE "S" OVERFLOW PIPE FLOAT CLIP CUP See Step 10 for water level FILL adjustment method VALVE FLUSH VALVE b. If bowl fails to siphon, an adjustment WATER LEVEL ADJUSTMENT may be required with the lift chain. CLIP LINK Simply remove the bead chain from the retainment clip and ta

Résumé du contenu de la page N° 4

TROUBLESHOOTING 12 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 12. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below LIFT ARM LIFT ARM water level in tank. Attach refill tube to overflow pipe using "S" FIRST FIRST clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper)