Instruction d'utilisation Lightolier IS-EG1

Résumé du contenu de la page N° 1

Lighting Systems IS-EG1












11”

We reserve the right to change details of design, materials and finish.

Résumé du contenu de la page N° 2

Lighting Systems IS-EG1 48” or 96” 48” or 96” Junction Box (By Others) Canopy Canopy Power Canopy Figure 1 Power Cord Power Cord Male Plug Cable Female Plug 10-32 Screw Cable Gripper End-Cap Screw (Do Not Over Tighten) 1/4-20 Bolt Figure 2 We reserve the right to change details of design, materials and finish.

Résumé du contenu de la page N° 3

Lighting Systems IS-EG1 Step 1. Installing the Suspension Cables A. B. Step 2. Installing the First Fixture A. B. F. Step 3. Installing the Remaining Fixtures A. B. F. Step 4. End of Row A. B. We reserve the right to change details of design, materials and finish.

Résumé du contenu de la page N° 4

Lighting Systems IS-EG1 Step 1. Modifying the Unit A. B. F. NOTE: In some instances some of the wires in the fixture are required to remain uncut (DALI, SHARING DAYLIGHT SENSOR , ETC.) In this case only cut and tap into the hot and neutral wires in the wire harness. Power Cord 1st Power Drop 2nd Power Drop 96" 96" 96" 96" 96" 48" Figure 3 We reserve the right to change details of design, materials and finish.