Instruction d'utilisation Schumacher SE-112S

Résumé du contenu de la page N° 1

PO Box 1368 • Effingham, IL 62401 •Phone: 217-347-5591 • FAX: 217-347-2952
US & Canada Call Toll-Free: 800-500-8388 (VETT)
MODEL
SE-112S
1 ½ AMP OWNER’S MANUAL
Read rules
for safe
BATTERY CHARGER & MAINTAINER 12VOLT
operation
and
instructions
carefully.
WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU REA

Résumé du contenu de la page N° 2

PERSONAL PRECAUTIONS AND SAFETY 1. WARNING: Wear complete eye protection and clothing necklaces, and watches when working with a lead-acid protection, when working with lead-acid batteries. battery. A lead-acid battery can produce a short-circuit 2. Make sure someone is within range of your voice or close current high enough to weld a ring (or the like) to metal, enough to come to your aid when you work with or near a causing a severe burn. lead-acid battery. ' 6. Take care not to drop a metal t

Résumé du contenu de la page N° 3

MOUNTING INSTRUCTION Figure 1 illustrates the charger mounting brackets. Figure 2 illustrates surface mounting of the charger to the Fender well. If using the nut and bolt provided, drill two holes between 3/16" and 1/4" in diameter. (For alignment of holes use one of the brackets as a template.) If the backside of the mounting surface is hard to reach, you may consider using two 1/2" sheet metal screws instead of nut bolt, drill a pilot hole if required, drill holes between 1/8" and 5/32". CAUT

Résumé du contenu de la page N° 4

OPERATING INSTRUCTIONS 3. Check polarity of battery posts. Model SE 112S is intended for use with 12 volt battery systems only. The POSITIVE (+) battery post usually charger contains an electronic control circuit which safeguards against has a larger diameter than the overcharging the battery. NEGATIVE (-) post. 4. Determine which post of battery is grounded (connected to the After reading and following the directions "Charging battery in vehicle" or chassis). If negative post is "Charging batte