Instruction d'utilisation Anchor Audio XTR-6000CU2

Résumé du contenu de la page N° 1

HAVING TROUBLE W/ YOUR SOUND SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound (power LED = OFF) • power switch is in OFF position
• blown fuse
No Sound (power LED = ON) • no output from source
• input cable unplugged
• input volume control low or off
• accessory or expansion module not in option bay
Distorted Sound • poor or improper connection on input cable
• input signal too strong
Excessive Hum or Noise • input cable not shielded
• not using balanced microphone
HAVING TROUBLE W/ YOUR WIRELESS

Résumé du contenu de la page N° 2

A MESSAGE FROM THE OWNER OPERATING THE WIRELESS MICROPHONE/TRANSMITTER Thank you for choosing an Anchor Audio portable sound system. Our products incorporate state-of-the-art design and the finest CHANNEL SELECTION - HANDHELD TRANSMITTER CHANNEL SELECTION - BODY-PACK TRANSMITTER quality of materials and workmanship. We’re proud of our products and appreciate the confidence which you have shown by select- 1. Unscrew battery cover on bottom of microphone 1. The channel selection dial is located o

Résumé du contenu de la page N° 3

DIVERSITY WIRELESS BY ANCHOR AUDIO FEEDBACK Anchor Audio UHF wireless is a 16 channel, diversity wireless system that receives signals with two independent antennae. Feedback, a howling noise or shrill sound, is self-generated by the sound system. It’s caused by a microphone picking up the sound With diversity wireless the receiver processes the stronger signal, effectively minimizing dropouts and interference from other coming from the speaker and then re-amplifying it. Once a feedback lo

Résumé du contenu de la page N° 4

BASIC SYSTEM OPERATION NOTE: Fully Charge Batteries Before First Use! WIRELESS RECEIVER CONTROLS 1. Before turning your system on: Set all Input Level Controls to (see page 6) minimum & Tones Controls to the flat or middle setting CD PLAYER CONTROLS 2. Plug in a wired microphone (MIC IN or BALANCED INPUT jacks) SPEECH/PROJECTION BUTTON (see page 6) and/or a separate audio source (LINE-IN jack) (see instructions below) 3. Set Power Switch to “ON”, a red LED near switch will light up 4. Adjust