Instruction d'utilisation Yamaha DSP1D

Résumé du contenu de la page N° 1

Optional Boards
for
DSP UNIT
hank you for choosing the board for Yamaha DSP1D (DSP unit).
T Ask an authorized Yamaha service engineer to install the board. Do not install the board yourself.



The following items are optional boards available for the DSP1D.

INPUT DSP BOARD IDB1D
CONSOLE INTERFACE BOARD CIB1D
ENGINE MANAGEMENT BOARD EMB1D
PATCH DSP BOARD PDB1D
GROUP DSP BOARD GDB1D
EFFECT DSP BOARD EDB1D
Installing the board (For only an authorized Ya

Résumé du contenu de la page N° 2

3. Loosen two screws on the 6. Slide the board into the protect bar. slot along the upper and lower guide rails. The sliding position is la- belled with the corre- sponding board model name. 4. Lift up the protect bar and remove it. 7. Press both edges of the board firmly and slide the board all the way into the 5. If you are replacing the slot. PDB1D board and the Reverse these steps to re- GDB1D board, remove install the protect bar and two connecting ribbon

Résumé du contenu de la page N° 3

1. Remove the unit front cover as 3. Remove six ribbon cables described in the previous pro- from the board. At this cedure. Remove two ribbon time, mark the ribbon cables from the board. cables so that you can identify each of them and re-connect them correctly later. 2. Remove eight fixing screws on the rack mount hardware, and remove the rack mount hardware. Do not remove any screws or hardware other than those shown in the pi

Résumé du contenu de la page N° 4

ADVARSEL! Lithiumbatteri—Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandoren. VARNING Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion. VAROITUS Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan suosi