Instruction d'utilisation AT&T XANBOO XG1000

Résumé du contenu de la page N° 1

STARTER KIT
INSTALLATION MANUAL
© 2007 AT&T Knowledge Ventures. All rights reserved.

Résumé du contenu de la page N° 2

INTRODUCTION TO YOUR FIRST TIME SETUP /// AT&T REMOTE MONITOR STARTER KIT /// Thank you for your purchase of the AT&T Remote Monitor Starter Kit. The XG1000 Controller PREPARATION: (the terms “Controller” and “Gateway” should be viewed as synonomous), a small dedicated YOUR STARTER KIT CONTAINS THE FOLLOWING ITEMS: computer, allows you to access and control cameras and other devices in your home, and make ■ XG1000 Controller [X1] with AC Power Supply [A1] and Ethernet Cable [E1] this inform

Résumé du contenu de la page N° 3

HARDWARE INSTALLATION: 4. Bring your IP Camera [C1], AC Power Supply [A2], HomePlug Turbo PLC Ethernet Adapter [H2], and Ethernet Cable [E3] to the location in your home that you wish to install your IP Camera [C1]. FOLLOW THE STEPS BELOW SET UP YOUR AT&T REMOTE MONITOR STARTER KIT: 1. Take the XG1000 Controller AC Power Supply [A1] from your controller box. Connect one end of the Ethernet Cable [E3] to the LAN port of the IP Camera [C1] and connect Plug the small end into the port marked P

Résumé du contenu de la page N° 4

CONTROLLER REGISTRATION: 4. When the controller registration has completed, you will see a confirmation message as 1. When you purchased your AT&T Remote Monitor system, you created a remote account in the following picture. After you successfully register your controller you may be prompted to with a UserID and Password. Using a web browser on a PC connected to the same follow instructions in order to improve performance. local network as your XG1000 Controller, go to site http://www.attr

Résumé du contenu de la page N° 5

USING THE SYSTEM WITH A CORPORATE FIREWALL /// LIVE VIDEO /// If you are using the AT&T Remote Monitor system in an environment that is protected For each discovered camera you will see a Snapshot of the view associated with the camera when by a corporate firewall, you may need to make some settings that will allow you to get the best you click on the ‘LIVE VIDEO’ tab. This snapshot image is for identifying the camera; it is not updated performance out of your system. The great majority of use

Résumé du contenu de la page N° 6

XG1000 CONTROLLER /// OPTIMIZING YOUR VIDEO PERFORMANCE: To ensure that your video performance is optimized INDICATORS: you can port forward your router. To do so, please There are ten indicators on the front of the controller. repeat the controller registration process (refer to the instructions, steps 1-4, found on pages 5 and 6 of this manual) where you will be prompted with instructions on port forwarding. POWER INDICATOR You will be notified during controller registration if your video pe

Résumé du contenu de la page N° 7

BOOT SEQUENCE MOBILE OPTION: When the controller is first powered up, the bottom five LED’s on the front panel go If you have a JAVA enabled wireless phone from AT&T you can access the system from through a boot-up sequence. The lights start out as Red, go to Amber and then Green. just about anywhere. Just use your phone’s web browser to download and install The process takes about three minutes. the application from http://attrm.com/j2me and enter your Remote Monitor UserID and Password when