Résumé du contenu de la page N° 1
Wired / Wireless
ADSL 2/2+ Router
ADE-3400v3 / ADE-4400v3 / ADW-4401v4
User's Manual
1
Résumé du contenu de la page N° 2
Copyright Copyright © 2007 by PLANET Technology Corp. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of PLANET. PLANET makes no representations or warranties, either expressed or implied, with respect to the contents here
Résumé du contenu de la page N° 3
Federal Communication Commission (FCC) Radiation Exposure Statement This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation. R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL OF
Résumé du contenu de la page N° 4
Table of Contents 1. INTRODUCTION ........................................................................................................................................... 6 1.1 Feature ................................................................................................................................6 1.2 Package Contents .............................................................................................................. 8 1.3 Physical Details .......................
Résumé du contenu de la page N° 5
3.6.2 Firewall.................................................................................................................................... 43 3.6.2.1 IP/Port filtering ............................................................................................................. 43 3.6.2.2 Mac Filtering................................................................................................................. 44 3.6.2.3 URL Block.....................................................
Résumé du contenu de la page N° 6
1. Introduction The PLANET Wired / Wireless ADSL 2/2+ Router, the ADE-3400v3 / ADE-4400v3 / ADW-4401v4, provides office and residential users the ideal solution for sharing a High-Speed ADSL 2/2+ broadband Internet connection on the 10/100Mbps Fast Ethernet Interface and the 54Mbps wireless network. It can support downstream transmission rates up to 24Mbps and upstream transmission rates up to 3.5Mbps. The product supports PPPoA (RFC 2364 - PPP over ATM Adaptation Layer 5), PPP over Ethern
Résumé du contenu de la page N° 7
Advanced Internet Functions Virtual Servers This feature allows Internet users to access Internet servers on your LAN. The required setup is quick and easy. DMZ Support The device can translate public IP addresses to private IP address to allow unrestricted 2-way communication with Servers or individual users on the Internet. This provides the most flexibility to run programs, which could be incompatible in NAT environment. Firewall Supports simple firewall with NAT technology and p
Résumé du contenu de la page N° 8
1.2 Package Contents ‧ ADE-3400v3 / ADE-4400v3 / ADW-4401v4 Unit x 1 ‧ Power Adapter x 1 ‧ Quick Installation Guide x 1 ‧ User’s Manual CD x 1 ‧ RJ-11 cable x 2 ‧ RJ-45 cable x 1 ‧ Splitter x 1 ‧ Antenna x 1 (ADW-4401v4) 1.3 Physical Details Front Panel of ADE-3400v3 Front Panel LED definition LED State Description ON When the router is powered on and in ready state. PWR Red The devise is being turned on and booting. OFF When the router is powered off. Link ON Successful conne
Résumé du contenu de la page N° 9
network. Flashing Modem is trying to establish a connection to telecom’s network. Data Flashing Data is transferred between Router and Internet. ON Link LAN Flashing TX or RX activity. Rear Panel Rear Panel Port and Button Definition Connector Description POWER The power button is for turn on or turns off the router. Button Power Power connector with 10V DC 1.0 A The reset button can restore the default settings of device. To restore factory Reset defaults, keep the device powered
Résumé du contenu de la page N° 10
Front Panel of ADE-4400v3 Front Panel LED definition LED State Description Green When the router is powered on and in ready state. PWR Red The devise is being turned on and booting. OFF When the router is powered off. ON Successful connection between ADSL modem and telecom's Link network. Flashing Modem is trying to establish a connection to telecom’s network. Data Flashing Data is transferred between Router and Internet. ON Link LAN 1-4 Flashing TX or RX activity Rear Panel Re
Résumé du contenu de la page N° 11
defaults, keep the device powered on and push a paper clip into the hole. Press down the button over 5 seconds and then release. Power Power connector with 12V DC 1.5 A Router is successfully connected to a device through the corresponding port Ethernet (1, 2, 3, or 4). If the LED is flashing, the Router is actively sending or receiving 1-4 data over that port. The RJ-11 connector allows data communication between the modem and the Line ADSL network through a twisted-pair phone wire.
Résumé du contenu de la page N° 12
Front Panel of ADW-4401v4 Front Panel LED definition LED State Description Green When the router is powered on and in ready state PWR Red The devise is being turned on and booting OFF When the router is powered off ON Successful connection between ADSL modem and telecom's Link network Flashing Modem is trying to establish a connection to telecom’s network ON The Wireless Interface is ready WLAN Flashing The Wireless data is transmitting OFF The Wireless Interface is disable ON Lin
Résumé du contenu de la page N° 13
Rear Panel Port and Button Definition Connector Description POWER The power button is for turn on or turns off the router. Button The reset button can restore the default settings of device. To restore factory Reset defaults, keep the device powered on and push a paper clip into the hole. Press down the button over 5 seconds and then release. Power Power connector with 12V DC 1.5 A Router is successfully connected to a device through the corresponding port Ethernet (1, 2, 3, or 4). If
Résumé du contenu de la page N° 14
2. Installation This chapter offers information about installing your router. If you are not familiar with the hardware or software parameters presented here, please consult your service provider for the values needed. 2.1 System Requirement 1. Personal computer (PC) 2. Pentium III 266 MHz processor or higher 3. 128 MB RAM minimum 4. 20 MB of free disk space minimum 5. RJ45 Ethernet Port 2.2 Hardware Installation Please connect the device to you computer as follow: If connecting t
Résumé du contenu de la page N° 15
Figure 2 ADE-4400 / ADW-4401 connection diagram If do not need to connect to the splitter, Connect the modem to wall jack with a telephone cable. Use Ethernet cable to connect “LAN” port of the modem and network adaptor of your computer. 2.3 Configuring the Network Properties Configuring PC in Windows XP 1. Go to Start / Control Panel (in Classic View). In the Control Panel, double-click on Network Connections 2. Double-click Local Area Connection. 3. In the Local Area Connecti
Résumé du contenu de la page N° 16
4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration. 16
Résumé du contenu de la page N° 17
Configuring PC in Windows 2000 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and Dial-up Connections. 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window click Properties. 4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration.
Résumé du contenu de la page N° 18
Configuring PC in Windows 98/Me 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Configuration tab. 2. Select TCP/IP NE2000 Compatible, or the name of your Network Interface Card (NIC) in your PC. 3. Select the Obtain an IP address automatically radio button. 4. Then select the DNS Configuration tab. 5. Select the Disable DNS radio button and click OK to finish the configuration. 18
Résumé du contenu de la page N° 19
3. Web Configuration Management Determine your connection settings Before you configure the router, you need to know the connection information supplied by your ADSL service provider. Connecting the ADSL Router to your network Unlike a simple hub or switch, the setup of the ADSL Router consists of more than simply plugging everything together. Because the Router acts as a DHCP server, you will have to set some values within the Router, and also configure your networked PCs to accept the I
Résumé du contenu de la page N° 20
Once you have powered on ADE-3400v3 / ADE-4400v3 / ADW-4401v4, system will boot up and connect to DSLAM automatically. In login dialog, enter “admin” as user name and “admin” as default password. After log in, you will see the following page. The default screen is Wizard setting screen. You can configure the device step by step. 3.1 ADSL Router Status The Status screen display system information of your Router. It includes the System, LAN, WLAN, WAN, Port Mapping, Statistic and ART Table
