Instruction d'utilisation TP-Link TR-966D

Résumé du contenu de la page N° 1

User's Guide
TR-966D
10/100Mbps WDM Fiber Bridge

Résumé du contenu de la page N° 2

COPYRIGHT & TRADEMARKS Table of Content Specifications are subject to change without notice. Package Contents........................................................................1 is a registered trademark of TP-LINK Introduction...................................................................................1 Technologies Co., Ltd. Other brands and product names Features........................................................................................1 are trademarks or registered tr

Résumé du contenu de la page N° 3

Package Contents The following contents should be found in your box:  One WDM Fiber Bridge  One AC adapter  This User’s Guide  Warranty card Introduction The TR-966D product is 10/100Mbps WDM Fiber Bridge. By deploying WDM technology (Wavelength Division Multiplexer), only single-mode fiber is needed to transmit and receive optical Ethernet packets. The TR-966D mediates between a 10/100Base-TX segment and a 100Base-FX segment. It is primarily designed for large, more high speed/ban

Résumé du contenu de la page N° 4

 Auto-detection of half/full duplex transfer mode for RJ45 port. TR-966D 10/100M WDM Fiber Bridge  Auto-negotiation of 10/100Mbps rate and Auto-MDIX for TR-966D Front Panel RJ45 port.  Fiber port only support full duplex transfer. 2. Rear Panel  Extend fiber distance up to 20km for fiber port. The rear panel of the TR-966D consists of one AC power  Easy-to-view LED indicators provide status to easily monitor connector, two 10/100Mbps RJ45 ports and two SC Fiber

Résumé du contenu de la page N° 5

 T1_Link/ Act/ T2_Link/ Act(Green): Steady green  Make sure that the length of twisted pair cable (Category- indicates that a valid link exists. Flashing green indicates 5) between 10/100Base-TX device and converter is not that the TR-966D is receiving or transmitting data from the longer than 100 meters. RJ-45 port.  Connect one end of twisted pair cable to RJ45 jack on the  F1_Link/Act/ F2_Link/Act (Green): Steady green TR-966D and the

Résumé du contenu de la page N° 6

71035589 Appendix Specification General Standard IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX/100Base-FX Topology Star Protocol CDMA/CD Data Transfer Ethernet: 10Mbps(Half Duplex); Rate 20Mbps(Full Duplex) Fast Ethernet: 100Mbps(Half Duplex); 200Mbps(Full Duplex) Ports 2 10/100Mbps RJ-45 ports 2 SC Fiber ports ( F1: 1310/1550 nm Single- mode single Fiber F2: 1550/1310 nm Single-mode single Fiber) LED indicator POWER Powe