Résumé du contenu de la page N° 1
R9944
3 Band Mains Table Radio
Please read this manual before use
ROBERTS
Sound for Generations
Résumé du contenu de la page N° 2
Contents Important Information............................................................................................................................................................... 1 Controls ................................................................................................................................................................................ 2-3 Mains Operation ......................................................................................................
Résumé du contenu de la page N° 3
Controls (Front) 1 2 3 4 7 6 5 1. Loudspeaker 5. Tuning control 2. Dial scale 6. Waveband switch 3. Dial pointer 7. On/Off and Volume control 4. Tuning indicator If you need any further advice, please call our Technical Helpline on :- 2 020 8758 0338 (Mon-Fri)
Résumé du contenu de la page N° 4
Controls (Rear) 8 910 15 14 13 12 11 8. External FM antenna socket 12. Headphone socket 9. External AM antenna terminals 13. Record/Line out socket 10. Mains socket 14. Auxiliary/Line in socket 11. External DC input socket 15. FM Antenna switch 3
Résumé du contenu de la page N° 5
Mains operation 1. Place your radio on a flat surface. 2. Plug the mains lead into the Mains socket located on the rear of your radio ensuring that the plug is pushed fully into the socket. 3. Plug the other end of the mains lead into a wall socket and switch on the wall socket. If you need any further advice, please call our Technical Helpline on :- 4 020 8758 0338 (Mon-Fri)
Résumé du contenu de la page N° 6
Operating your radio FM 1. Switch on your radio by rotating the Volume control until a click is heard. 2. Set the Waveband switch to the FM position. 3. Adjust the Volume control until a hissing sound is heard. 4 4 2 4. Rotate the Tuning control to select the desired station. The 1 Tuning indicator will light when the station is correctly tuned. On FM the Tuning scale is marked in Megahertz (MHz). 5. Your radio is fitted with an internal FM antenna - if reception is not satisfactory an externa
Résumé du contenu de la page N° 7
Operating your radio AM (Medium and Long wave) 1. Switch on your radio by rotating the Volume control until a click is heard. 2. Set the Waveband switch to the MW or LW position. 3. Adjust the Volume control until a hissing sound is heard. 4 4. Rotate the Tuning control to select the desired station. The 4 2 1 Tuning indicator will light when the station is correctly tuned. On MW and LW the Tuning scale is marked in kilohertz (kHz). 5. Your radio is fitted with an internal AM (MW and LW) antenna
Résumé du contenu de la page N° 8
Headphone, Auxiliary and Record sockets 1. The Headphone Socket (3.5mm) located on the rear of your radio is for use with either headphones or an earpiece. Inserting the headphone plug automatically mutes the internal loudspeaker. 2. The Record/Line out socket on the rear of your radio is for use with a tape recorder/mini disc or to allow connection to line input of a Hi Fi system. The signal on the Record/Line out socket is unaffected 1 by the volume control. 3. The Auxiliary/Line in socket on
Résumé du contenu de la page N° 9
Specifications Circuit Features Power Requirements Loudspeaker 75mm 8ohms Mains AC 230 volts, 50Hz only Output Power 7W into 8ohms DC 12V DC @ 1Amp centre pin positive Headphone socket 3.5mm dia mono 5mW+5mW output Auxiliary/ Line Input socket 3.5mm dia sensitivity 150mV @47kohms Record out socket 3.5mm dia output impedance 2.2kohms Frequency Coverage FM 87.5-108MHz MW 522- 1629kHz LW 144- 281kHz The Company reserves the right to amend the specification without notice. If you need any further a
Résumé du contenu de la page N° 10
Mains supply The R9944 will operate from a supply of AC 230 volts, 50Hz only. The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK. DO NOT cut off the mains plug from this equipment. If the plug The wire coloured BROWN must be connected to the terminal marked fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved L or coloured RED. extension lead or adaptor. If in doubt c
Résumé du contenu de la page N° 11
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. Procedure: Any claim under thi
Résumé du contenu de la page N° 12
ROBERTS RADIO TECHNICAL SERVICES 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri) Issue 1
