Résumé du contenu de la page N° 1
!"### #$% %& #' (&% "
Résumé du contenu de la page N° 2
Copyright 2001, 2002, 2003 Hughes Network Systems, Inc., a Note on recording programming – Most television programs and wholly owned subsidiary of Hughes Electronics Corporation. All films are copyrighted. This means that someone has legal rights rights reserved. This publication and its contents are proprietary to governing the reproduction and distribution of this material. In certain Hughes Network Systems, Inc., a wholly owned subsidiary of Hughes circumstances, copyright law may apply to
Résumé du contenu de la page N° 3
Important Safety Instructions For your safety and protection, read this entire Owner's Manual before you attempt to install or use your satellite system. In particular, read this safety section carefully. Keep this safety information where you can refer to it if necessary. Heed Cautions–All cautions on the product and in the operating instructions should be adhered to. Follow Instructions–All operating and use instructions should be followed. THESE CAUTIONS AND SYMBOLS APPEAR ON THE BACK OF TH
Résumé du contenu de la page N° 4
INSTALLATION ® Polarization – This DIRECTV Receiver is equipped with a plug that will Example of Antenna Grounding according to the National fit into the power outlet only one way. Do not modify the plug defeating this Electrical Code instructions contained in “Radio and Television feature. If the plug does not fit, contact your electrician to replace your Equipment”. outlet. To prevent electric shock, do not use this plug with an extension cord or outlet unless you can fully insert the blade
Résumé du contenu de la page N° 5
SERVICE ® Servicing–Do not attempt to service this DIRECTV Receiver yourself as Safety Check–Upon completion of any service or repairs to this opening or removing covers may expose you to dangerous voltage or other DIRECTV Receiver, ask the service technician to perform safety checks hazards. There are no user serviceable parts inside. Refer all servicing to recommended by the manufacturer to determine that the DIRECTV Receiver qualified service personnel. is in safe operating condition. Cond
Résumé du contenu de la page N° 6
Federal Communications Commission (FCC) Regulatory Information Declaration of Conformity– Standards to which Conformity is declared: FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party’s Name: Hughes Network Systems, Inc. Address: 11717 Explor
Résumé du contenu de la page N° 7
Contents Listing unviewed purchases . . . . . . . . . . . . . . . 25 Getting Started . . . . . . . . . . . . . . . . . . . . . . . 1 Adjusting audio settings . . . . . . . . . . . . . . . . . . . . 25 Setup overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Setting default and alternate audio . . . . . . . . . . 25 Attach the satellite antenna cable . . . . . . . . . . . . 2 Using TruSurround . . . . . . . . . . . . . . . . . . . . . 26 Connect your TV. . . . . . . . . . . . . .
Résumé du contenu de la page N° 8
viii Contents
Résumé du contenu de la page N° 9
Getting Started 1 This chapter explains how to: ® You may connect a second • Connect the DIRECTV Satellite Dish Antenna to your DIRECTV DIRECTV Receiver to the unused Receiver (this page). LNB output. These instructions • Connect your DIRECTV Receiver to your TV (see page 3). also apply to an additional • Find antenna azimuth and elevation settings for your location (see page 4). receiver. • Test the DIRECTV System operation (see page 5). How to use this manual This manual uses these typogr
Résumé du contenu de la page N° 10
You can configure your system several ways, depending on what additional Attach the satellite components (such as a VCR, DVD player, or A/V receiver) you select. For now, antenna cable however, use the simplest configuration to check your antenna and cabling. ® • Ensure that the DIRECTV Receiver is not plugged into an electrical outlet. • Attach the RG-6 coaxial antenna cable to the SATELLITE IN connector on the back of the DIRECTV Receiver. Refer to the appropriate figure below. 7 9 A ;
Résumé du contenu de la page N° 11
Depending on your TV, you can connect it to the receiver in one of four ways: Connect your TV • Component (Y,Pb,Pr,-HAH-SA only) video cable (best picture quality) or • S-Video cable (excellent picture quality) or • Video cable (very good picture quality) or • Coaxial cable (good picture quality) You will also want to use a pair of audio cables (L/R) to provide stereo sound. If your TV does not have standard A/V jacks, you will hear monophonic audio. This is acceptable for the procedures descr
Résumé du contenu de la page N° 12
This section explains how to determine the proper antenna position, expressed Determine antenna in degrees of azimuth (horizontal) and elevation (vertical). Use the receiver front angles panel controls shown below to complete this procedure.
* *
0
" ' ! 12" % ( 4 4 4 1. Press the front panel MENU button to display the MAIN MENU below. 2. Use the button to highlight the System Setup tab.
Résumé du contenu de la page N° 13
When you have aligned your dish antenna to the azimuth and elevation angles Testing your system shown on the Install pane, highlight the Signal tab. Signal quality is indicated by a scale at the bottom of the pane and with an audible indication. The frequency and tempo of the tone increase with signal strength. To perform the Transponder Use this procedure to test the signal strength from the satellite transponder: test: 1. Select the System Setup tab from the MAIN MENU 2. Highlight the Signa
Résumé du contenu de la page N° 14
An occasional “0” indication may be Results should generally resemble those in the figure, but the actual values will considered normal. vary somewhat from those shown in the figure depending on your geographic location and specific installation. However, if your results are very different from these examples (i.e, rows of zeros or single-digit numbers) or you receive no signal indication: • Highlight the Install tab on the INSTALLATION menu. Verify your settings. • Re-enter your ZIP code i
Résumé du contenu de la page N° 15
Adding system components 2 ® You can configure your DIRECTV Receiver several ways depending on the additional audio/video components you want to use. This chapter explains how to: • Connect a terrestrial (broadcast) TV antenna (this page). • Connect and set-up a VCR (see page 8). • Integrate a DIRECTV Receiver into your audio or A/V system (see page 9). Connecting At this point, you should have: additional system Verified that your system is operating properly. components Connected your DIRECT
Résumé du contenu de la page N° 16
® Connect the VCR Control (Model HAH-SA only) The DIRECTV Receiver can control your VCR for Cable unattended recording, using the VCR Control Cable provided. 1. Plug the VCR control cable into the rear panel VCR CONTROL jack. 2. Temporarily position the other end over the VCR’s remote control sensor (normally a small dark plastic window on the VCR front panel). The remote control sensor may be labeled or identified in your VCR manual. If it is not identified, scan the front of the VCR with yo
Résumé du contenu de la page N° 17
If either command does not function, try other codes listed for your VCR brand. If you are unsuccessful after trying all available codes, recheck your VCR Control Cable connections and IR emitter placement. 9. Remove the temporary mounting tape. Attach the emitter permanently using the peel-and-stick backing. This will not interfere with normal VCR operation. ® You can integrate the DIRECTV Receiver into your entertainment system to Connecting a home take advantage of enhanced audio and vid
Résumé du contenu de la page N° 18
10 Adding system components
Résumé du contenu de la page N° 19
Using the remote control 3 This chapter explains how to: • Use the HRMC-11, HRMC-12, and HRMC-13 remote control functions. (see page 13) • Program the remote to work with other system components. (see page 14) • Install and replace the remote control batteries. (see page 15) % !
2&&= %>) !
2&&) !
# ! ! $ "
5
5 % ) " 4
5
Résumé du contenu de la page N° 20
% !
2&&= %>) ( !
2&&) # ! ! $ " "
5
5 % ) 4
5
5 5
) - ! # #
*&
%
&
5
=
>) # -! *
5
555) & '
(#)% *
