Résumé du contenu de la page N° 1
Operator's Manual /
Sit
CUTOFF SAW
Model No.
351.268500
CAUTION: Read and follow
all Safety Rules and Operating
Instructions before First Use
of this Product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
www, sears.condcraftsman
17682.02 Draft (09/20/02)
Résumé du contenu de la page N° 2
PREPARE WORK AREA FOR JOB • Keep work area clean. Cluttered work areas invite accidents. Warranty .................................. 2 Safety Rules .............................. 2-3 • Do not use power tools in dangerous environments. Do not use power tools in damp or wet locations. Do Unpacking ................................. 3 not expose power tools to rain. Installation ............................... 3-4 • Work area should be properly lighted. Operation ................................. 4
Résumé du contenu de la page N° 3
• Know your tool. Learn the tool's operation, applica- ELECTRICAL CONNECTIONS tion and specific limitations. WARNING: Make sure unit is off and disconnected • Handle workpiece correctly. Protect hands from from power source while motor is being mounted, con- possible injury. nected, reconnected or any time wiring is inspected. • Turn machine off if it jams. Abrasive wheel jams Cutoffsaw is assembledwith an approvedline cord to use 115 volts. when it digs too deeply into workpiece. (Motor force k
Résumé du contenu de la page N° 4
EXTENSION CORDS • Keep hands away from the abrasive wheel and all moving parts. • The use of any extension cord will cause some drop • Always wear eye protection or face shield. in voltage and loss of power. • Wires of the extension cord must be of sufficientsize CLAMPING WORKPIECE to carry the current and maintain adequate voltage. Refer to Figure 3. • Use the table to determine the minimum wire size The vise is designed to keep the workpiece steady (A.W.G.) extension cord. while it is being cu
Résumé du contenu de la page N° 5
• Insert open end wrench over flats of shaft (Fig. 3, Key No. 26) and hold shaft steady. • Insert two-prong wrench into holes in wheel nut (Fig. Refer to Figure 3. 3, Key No. 56) and remove the wheel nut by turning WARNING: Make certain that the saw is disconnected counterclockwise. from the power source before attempting to service or • Cutoff saw comes with 22ram bore abrasive wheel remove any component. installed. If replacement abrasive wheel has 20mm For proper maintenance: bore, replace 22
Résumé du contenu de la page N° 6
CORRECTIVE ACTION SYMPTOM POSSIBLE CAUSE(S) Wheel cuts (crooked) 1. Work not positioned 1. Adjustvise angle 2. Hand pressure too great 2. Reduce pressure 3. Work not secure 3. Tighten vise 4. Loose abrasive wheel 4. Reinstall wheel according to instructionsunder "Replacing Abrasive Wheel", page 5 5. Dull or clogged abrasive wheel 5. Replace abrasive wheel 6. Wheel washer loose or worn 6. Tighten or replace 7. Abrasive wheel worn or chipped 7. Replace abrasive wheel Bad cuts (rough) 1. Too much h
Résumé du contenu de la page N° 7
Service Record Craftsman 6" Cutoff Saw DATE MAINTENANCE PERFORMED REPLACEMENT PARTS REQUIRED ] 7
Résumé du contenu de la page N° 8
Model351.268500 Figure 3 - Replacement Parts Illustration for 6" Cutoff Saw 12 4 13 45 59 16 40 31 45 5O 4_ r 58 48 35 35
Résumé du contenu de la page N° 9
KEY KEY NO. PART NO. DESCRIPTION QTY. NO. PART NO, DESCRIPTION QTY. 1 17635.00 32 17660.00 Housing, Left side 1 Base 1 2 17636.00 33 17661.00 Housing, Right side 1 Rubber Foot 4 3 17637.00 Pin 1 34 08504.00 5-0.8 x 20mm Flat Head 4 4 17638.00 Brush Cap 2 Screw 5 17639.00 Carbon Brush 2 35 STD840508 5-0.8mm Hex Nut* 4 6 17640.00 Brush Holder 2 36 17664.00 Vise Jaw with Protractor 1 7 17641.00 Stator 1 37 17663.00 Moving Jaw 1 8 17642.00 Armature 1 38 17662.00 Guide Plate 1 9 STD315485 39 17665.00
Résumé du contenu de la page N° 10
Your Home For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and i;i_iiiiii owner's manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters. i!_I !i!i_ 1-800-4-MY-HOME ® (1-800-469-4663) Call anytime, day or night (U.S.A. and Canada) www.sears.com www.sears.c
