Instruction d'utilisation Arcam Logo

Résumé du contenu de la page N° 1

Handbook
Manuel
Handbuch
Handleiding
logo

Résumé du contenu de la page N° 2

CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. safety WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated ‘dangerous voltage’ guidelines within the product’s enclosure that may be of sufficient

Résumé du contenu de la page N° 3

contents safety guidelines ......................................E-2 ... and congratulations for buying the Arcam Logo sub-bass loudspeaker system. Important safety instructions .................E-2 Logo can extend the bandwidth of your main (satellite) speakers by accurately revealing the low Safety compliance ..........................................E-2 thank frequency components of stereo and surround-sound programme sources. It also offers a separate but concurrent LFE (low frequency e

Résumé du contenu de la page N° 4

Indicator LED Positioning the unit Connecting to a sound source An indicator LED is positioned across < Place the Logo speaker unit on a level, firm Check that your sound processor/receiver is switched the top edge of Logo’s cabinet. surface, avoiding direct sunlight and sources of off before connecting Logo. Failure to do this may When the indicator LED is off, it heat or damp. result in both speaker and amplifier damage. indicates that the speaker is completely < Do not place Logo in a

Résumé du contenu de la page N° 5

speaker positioning The advice given here is a general guideline for setting up speakers. standing speakers), or in corners. The speaker drivers Refer to the documentation supplied with your speakers for ��� should be at, or a little above, ear level when seated. � more precise positioning and installation information, and see If possible, centre your seating area between the � � www.dolby.com/consumer/home_entertainment/roomlayout.html for surround speakers. usefuI information on listening-

Résumé du contenu de la page N° 6

Sub/full range+sat system This is a surround-sound system (such as Arcam’s Solo Movie 5.1) where full range L and R speakers LS are combined with satellite (or with full range) rear RS PRE OUT SUB speakers. The system should be connected with PRE OUT RIGHT both the SUb, SUbWOOFER or LFE output connected to PRE OUT LEFT connection IN LFE and Left/Right preamplifier outputs attached to IN L/IN R on Logo. In such systems, Logo can be set up to work with two crossover frequencies. One frequen

Résumé du contenu de la page N° 7

The subwoofer’s has two jobs: firstly to reproduce accurately and with sufficient power the sub-bass that other Recommended settings for use ‘smaller’ speakers cannot (the centre speaker is almost always a ‘small’ speaker); and secondly to reproduce the with Muso speakers ‘.1’ or low frequency effects (LFE) track of 5.1 or 7.1 material. Arcam’s Muso satellite speakers ideally For optimum results, the subwoofer must be set up in the correct relation to the other speakers in the system. compl

Résumé du contenu de la page N° 8

Worldwide Guarantee Technical specifications This entitles you to have the unit repaired free of charge, during the first two years after purchase, at System design One-way speaker, with 10 litres internal volume. The cabinet is solidly any authorised Arcam distributor provided that it constructed from machined MDF with internal bracing. was originally purchased from an authorised Arcam Drive unit 10” (254mm) subwoofer drive unit with long excursion, magnetically dealer or distributor. The