Résumé du contenu de la page N° 1
SW1010, SW1212, SW1515
1 Mitek Plaza
Powered Home Subwoofer
Winslow, IL 61089
Owner’s Manual
815-367-3000
800-225-5689
21A6279
Résumé du contenu de la page N° 2
CARE AND MAINTENANCE Your speakers are designed to work with a wide range of electronic components. As little as 20 watts per channel can provide enough power for most applications. If you have a large room or prefer louder listening levels, more power may be required. Caution: When choosing an amplifier, do not exceed the power rating of the speaker. If you hear very high levels of audible distortion you are exceeding the capabilities of the system. Damage can occur from this distorti
Résumé du contenu de la page N° 3
SAFETY SYMBOLS AND STATEMENTS SPECIFICATIONS SW1010 SW1212 SW1515 Amplifier Type: Class A/B Class A/B Class D Amplifier Power: 100 Watts 130 Watts 250 Watts Frequency response: 33-120Hz 27-120Hz 27-120Hz Inputs: Line level Line level Line level High level High level
Résumé du contenu de la page N° 4
IMPORTANT SAFETY INSTRUCTIONS IN CASE OF TROUBLE 1. Read Instructions – All the safety and operating should be routed so that they are not likely to be Your new subwoofer, once set-up and adjusted, should give you years of listening instructions should be read before the product is walked on or pinched by items placed upon or against opened. them, paying particular attention to cords at plugs, enjoyment with your favorite movies and music. However, if you should experience convenience rec
Résumé du contenu de la page N° 5
OPERATION After you have connected your subwoofer, adjusted it for proper operation with the rest of your system, and experimented to find the best location for it, it’s time to sit back and enjoy it. As you do, here are some hints for getting the most out of your subwoofer. POWERED HOME SUBWOOFER A) The subwoofer’s level control is designed to adjust the balance between your subwoofer and main stereo speakers and should not be used as a substitute OWNER’S MANUAL for the bass or loudness c
Résumé du contenu de la page N° 6
CONGRATULATION... SET-UP AND ADJUSTMENT After you have selected an initial location for your subwoofer and have connected ... on your purchase of a MTX powered home subwoofer system. Your new subwoofer is one of the most exciting home entertainment electronic products it into your system, have a seat in your normal listening position and have available, adding impact and realism to recorded music and the wide variety of someone help you with the following adjustments: movies to be found o
Résumé du contenu de la page N° 7
B) For use with A/V preamps and receivers that have 5.1 channel line level UNPACKING/PRE-ISTALLATION INSTRUCTIONS outputs. If your preamplifier or receiver has a single “subwoofer” output or “LFE” output, Unpack your new subwoofer carefully, keeping the carton and packing material connect a shielded cable from the preamplifier output to either one of the for future use. Check the condition of your unit, reporting any damage which may subwoofer line level inputs. Refer to Figure E. have occu
Résumé du contenu de la page N° 8
Installation using line level inputs EXPLANATION OF FEATURES AND CONTROLS A) Using a preamp or receiver with line level outputs. If a preamplifier output is available on your receiver, or you have a preamplifier, Refer to figure A. connect it to the stereo line level RCA type input jacks on your subwoofer. Use 1) Polarity switch: This two position switch allows the best match of acoustic quality shielded cables and connectors. Connect one set of shielded cables from output between the sub
Résumé du contenu de la page N° 9
B) For amplifiers with two sets of speaker connections. An alternate method of connecting your subwoofer and main speakers is possible if you have a receiver or amplifier that can accommodate two sets of speakers that can be switched on at the same time and be connected in parallel. (Note that some receivers and amplifiers connect “A” and “B” sets of speakers in series, not parallel. A series wiring will not allow this alternate connection method for your 3 9 subwoofer. Consult the owner’s
Résumé du contenu de la page N° 10
WIRING AND CONNECTIONS PLACEMENT OR POSITIONING Turn off all power to your subwoofer and other equipment before making Your new subwoofer will work well in a variety of locations. However, placement any connections. in your listening room will affect its performance. Since the wavelengths of sound reproduced by your subwoofer are large compared to its size, those sounds are omni-directional in nature. This means that locating your subwoofer in relation Installation using speaker level inpu
