Instruction d'utilisation Kenwood SIRIUS DT-7000S

Résumé du contenu de la page N° 1

Résumé du contenu de la page N° 2

Table of contents Selecting music ............................................................................................................8 Congratulations ............................................................................................................2 Box contents.................................................................................................................2 Setting and using stream presets.......................................................................

Résumé du contenu de la page N° 3

This plug will fit into the outlet only one way. This is a antenna discharge unit, size of grounding conductors, Safety precautions (continued) safety feature. If you are unable to insert the plug fully into location of antenna discharge unit, connection to ground- FCC Warning the outlet, try reversing the plug. If it should still fail to fit, ing electrodes, and requirements for the grounding elec- This equipment may generate or use radio frequency contact your electrician to replace your obso

Résumé du contenu de la page N° 4

Connecting the DT-7000S to your audio system Use the cables supplied with the DT-7000S to make these connections. About the RS-232C connection: The RS-232C connection is provided to allow the DT-7000S to be controlled by compatible 3rd-party control systems. Kenwood recom- mends that this connection only be used by experienced professional system installers. DO NOT connect the RS-232C connection to a computer—it is NOT COMPATIBLE with person- al computers. 4 DT-7000S Instruction Manual

Résumé du contenu de la page N° 5

Résumé du contenu de la page N° 6

Résumé du contenu de la page N° 7

Installing batteries in the remote 1. Remove the battery cover as shown in diagram #1 (right). 2. Install two AAA batteries as shown in diagram #2 (right). •Observe the polarity markings on the inside of the battery compartment 3. Replace the battery cover. Using the remote Basic operation • The supplied batteries are for operational checks, and may not last as long as After you have acti- alkaline batteries. vated your SIRIUS subscription, the • If the remote-controllable distance begins to

Résumé du contenu de la page N° 8

Résumé du contenu de la page N° 9

Résumé du contenu de la page N° 10

Résumé du contenu de la page N° 11

Résumé du contenu de la page N° 12

Résumé du contenu de la page N° 13

Troubleshooting guide Problem Possible Cause Solution No power on DT-7000S (display not illuminated) Power cord is not properly connected Make sure the power cord is properly connected Audio and/or digital cable is not properly connected Make sure cable is properly connected No sound Incorrect input selected on receiver/controller Select the receiver/controller input that the DT-7000S is connected to Check the Antenna Signal screen (see page 12); Signal is weak or can’t be found Change the ant

Résumé du contenu de la page N° 14

14 DT-7000S Instruction Manual

Résumé du contenu de la page N° 15

15 DT-7000S Instruction Manual

Résumé du contenu de la page N° 16