Résumé du contenu de la page N° 1
User’s Manual
LA-122 Universal Remote Antenna Kit
Listen Technologies Corporation
8535 South 700 West, Suite A
Sandy, Utah 84070-2515 USA
Telephone: +1.801.233.8992
Toll-Free (USA): 1.800.330.0891
Fax: +1.801.233.8995
E-mail: info@listentech.com
V.020603. Listen and the Listen logo are registered trademarks of Listen Technologies Corporation. Document #LM-122
Copyright © 2002 Listen Technologies Corporation. All Rights Reserved. 1
Résumé du contenu de la page N° 2
R LA-122 Universal Antenna Kit www .ListenT ech.com Mounting Options: Wall Mount (to your electrical box) Direct Wall Mount F Ceiling Mount D In-Wall or In-Ceiling Mount Mast Mount E B A C Use With: LT-800-072 Stationary Transmitter LT-800-216 Stationary Transmitter LR-100-072 Stationary Receiver / Power Amplifier LR-100-216 Stationary Receiver / Power Amplifier Kit Includes: A. Wall / Electrical Box Mounting Plate B. Mounting Bracket C. Antenna Module and 25 feet (7.6 m) RG58 coaxial cabl
Résumé du contenu de la page N° 3
R LA-122 Universal Antenna Kit www .ListenT ech.com Table of Contents Contents of Kit ............................................................................... page 2 Specifications ................................................................................ page 3 Architectural Specifications .......................................................... page 3 Important Things to Note Before Starting .................................... page 4 Selecting an Antenna Location ......
Résumé du contenu de la page N° 4
R LA-122 Universal Antenna Kit www .ListenT ech.com Important Things to Note Before Starting Your Installation Coaxial Cable If you plan to use your own coaxial cable instead of the provided cable, you must use cable and connectors rated at 50 ohms. Although cable used for cable TV installations looks similar to this cable, it won’t work with your Listen system. If you need to run cable over a greater length than 50 feet for 216 MHz applications or greater than 100 feet for 72 MHz applications,
Résumé du contenu de la page N° 5
R LA-122 Universal Antenna Kit www .ListenT ech.com Antenna Orientation The antenna’s pattern is hemispherical, meaning that it has an “active” side and a ground side. The active side directs the signal toward the receivers, so it is essential that the active side be oriented toward the area where the receivers will be used. The Antenna Module’s ground side has the word “GROUND” molded into the plastic. See Diagram A. If it is necessary to locate an antenna low on a wall, the ground side shoul
Résumé du contenu de la page N° 6
R LA-122 Universal Antenna Kit www .ListenT ech.com Selecting an Antenna L Selecting an Antenna Location ocation Selecting an Antenna L Selecting an Antenna L Selecting an Antenna Location ocation ocation The location and configuration of your antenna mount will determine the quality of your signal; therefore, there are some important factors to consider. º Where will the receivers be located? Ideally, the antenna will be centrally positioned above that area. º Where will the transmitter or sta
Résumé du contenu de la page N° 7
R LA-122 Universal Antenna Kit www .ListenT ech.com Dipole Antenna Mounting Options Mount to an Electrical Box in a Wall See Diagram B at right The antenna may be mounted to a single or dual gang duplex box, or to a square or hexagonal junction box. Attach the kit’s Mounting Plate to the electri- cal box (see photo, right). The cover plate has a number of holes and slots to accomodate a wide variety of electrical boxes. Next, secure the Mounting Bracket to the plate and connect your antenna as
Résumé du contenu de la page N° 8
R LA-122 Universal Antenna Kit www .ListenT ech.com Mounting Inside a Wall or Ceiling See Diagrams D and E The antenna may be hidden inside a wall or ceiling. IMPORTANT: Do not install the antenna inside a metal wall or ceiling, as this would obstruct the signal. You will use a flexible dipole (the floppy wires) in this configuration. Select the correct wires for your configuration (72 MHz or 216 MHz). Connect one antenna wire to the ground side of the Antenna Module using one of the Hex Kep
Résumé du contenu de la page N° 9
R LA-122 Universal Antenna Kit www .ListenT ech.com Mounting to a Mast or Conduit The antenna may be mounted to a mast, pole or section of vertical conduit. A mast made of non-conductive material works best; however, if you must use a metal mast, be sure to orient the antenna mount so the mast is not between the antenna and the designated receiving area. The Mounting Plate is not required, but will provide a stronger mount for the antenna. Secure two commercially available conduit clamps (not i
Résumé du contenu de la page N° 10
R LA-122 Universal Antenna Kit www .ListenT ech.com Connecting the Dipole Antenna You have two choices of antenna with the dipole option: the rigid dipole, which has the two extendable arms, or the flexible dipole, which has the “floppy” wires with securing rings at the ends. Rigid dipole pieces screw onto the connectors at the top and bottom of the Antenna Module. Flex- ible dipole wires are secured using Hex Kep nuts and a fiber washer as indicated on page 9. If you don’t have enough room t
Résumé du contenu de la page N° 11
R LA-122 Universal Antenna Kit www .ListenT ech.com Monopole Antenna Mounting Options Mount to a Grounded Electrical Box, Ceiling or Floor A monopole (single element) antenna may Hex Kep nut be mounted to a grounded light box or junc- Nuts from ground side tion box in a ceiling or floor using the Mount- of Antenna Module ing Plate and Mounting Bracket. Ground side of BEFORE STARTING, reverse the Antenna Antenna Module Module on the Mounting Bracket, then install the Hex Kep nut on the ground pos
Résumé du contenu de la page N° 12
R LA-122 Universal Antenna Kit www .ListenT ech.com Mount to a Metal Surface Using the Ground Plane and Shorting Plate See Diagram J Screws from Antenna Module Ground Plane It is often convenient to place an antenna on top of a metal equipment rack. In order Ground side of Antenna Module for the antenna to function properly, it must be secured to the equipment rack using the Shorting Plate Grounding Plate and Grounding Base. Nuts from ground side of Antenna Module Hex Kep nut The Mounting Brack
Résumé du contenu de la page N° 13
R LA-122 Universal Antenna Kit www .ListenT ech.com Mounting a Monopole Antenna to a Metal Beam or Metal Ceiling See Diagram K Follow the instructions for mounting to a metal equipment rack, orienting the antenna downward rather than upward. Mounting a Monopole Antenna to a Non-Conductive Surface See Diagram L Follow the instructions for mounting to a Diagram K. Inverse mounting of a monopole. metal equipment rack, however, there are two additional steps: 1. Connect a length of flexible antenn
Résumé du contenu de la page N° 14
R LA-122 Universal Antenna Kit www .ListenT ech.com T T T T Troubleshooting roubleshooting roubleshooting roubleshooting roubleshooting I’m not hearing anything in my receiver. 1. Make sure the receiver’s batteries aren’t dead, that it is turned on, set to the right channel, and the volume has been turned up. 2. Make sure your transmitter or stationary receiver has been powered up and set to the right channel, and the desired audio has been applied. 3. Make sure the coaxial cable has been tightl
Résumé du contenu de la page N° 15
R LA-122 Universal Antenna Kit www .ListenT ech.com My signal is strong but it is distorted. 1. Make sure your transmitter or stationary receiver is on the same channel as the receivers. 2. Make sure you are not too close to the antenna. 3. Lower the level of the audio signal being fed into the transmitter. If you are still having problems after checking the above items, call Listen for help. We are available from 8 AM to 5 PM Mountain time, Monday through Friday, at 1.800.330.0881 or 801.233.
Résumé du contenu de la page N° 16
R LA-122 Universal Antenna Kit www .ListenT ech.com W W Warranty arranty arranty W Warranty arranty Listen Offers a Limited Lifetime Warranty, Including a Performance Guarantee. Listen Technologies Corporation (Listen) warrants its transmitters and receivers (LT-700, LT-800, LR-100, LR-300, LR-400, LR-500, LR-600, etc.) to be free from defects in workmanship and material under normal use and conditions for the useful lifetime of the product from date of purchase. All other products and accessor
