Résumé du contenu de la page N° 1
Model MS4150RS
AM/FM/CD/CD-ROM Navigation Radio
Owner’s and
Installation Guide
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
CONTENTS SAFETY AND WARNINGS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 INSTALLATION INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Route & Sound – Navigating and listening to an audio CD . . . . . . . . . . . . . . 9 How does the navigation system work
Résumé du contenu de la page N° 4
CONTENTS C-IQ – INTELLIGENT CONTENT ON DEMAND . . . . . . . . . . . . . . . . . . . . . . . 31 C-IQ - Your key to map, traffic and travel information . . . . . . . . . . . . . . . . 31 NAVIGATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Main menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Destination in
Résumé du contenu de la page N° 5
SAFETY AND WARNINGS Notes about the Operation Guide The following reading aids are used to simplify this Operation Guide: requests you to do something. shows the unit’s reaction. provides additional information ✎ – identifies a list. Safety instructions and warnings contain important information for the safe use of the A unit. Failure to observe this information may result in a risk of damage or injury. Therefore, please observe this information with particular care. Class 1 laser product CA
Résumé du contenu de la page N° 6
SAFETY AND WARNINGS Guidelines and recommendations for safe use of the Navigation Radio Glance at the display only when necessary and safe to do so. If prolonged viewing of A the screen is necessary, pull over and stop in a safe and legal manner. A Do not input destinations, change settings or access any functions requiring a prolonged view of the display and/or remote control while you are driving. Pull over and stop in a safe and legal manner before attempting to access the system. Make certai
Résumé du contenu de la page N° 7
INSTALLATION INSTRUCTIONS IMPORTANT INFORMATION A Only trained specialists may install the unit. A Observe automotive industry quality standards. Fire hazard! When drilling, care must be taken not to damage concealed wiring harnesses, A the fuel tank and fuel lines. Never drill into supporting or safety-relevant body parts. A A Only install in vehicles with 12V on-board voltage and negative earth. Risk of malfunction, damage and vehicle fire if installed in unsuitable vehicles (e. g. heavy goods
Résumé du contenu de la page N° 8
INSTALLATION INSTRUCTIONS Connection overview, ISO chamber A, Fig. 2: Note: The cable colors correspond to the VDO Dayton standard. Pin Wire color Connection A1 Orange Input speedometer signal / SDVC A2 Green Switch input reversing signal (+12 volts) A3 Purple Switch input telephone mute function A4 Red/Yellow + 12 V permanent positive; terminal 30 A5 Blue Switch output for automatic antenna / relay motor antenna A6 Grey Switch input pilot light A7 Red +12 V ignition positive; terminal 15 (witho
Résumé du contenu de la page N° 9
INSTALLATION INSTRUCTIONS Connection overview ISO chamber B (loudspeakers), Fig. 3: Note: The cable colors correspond to the VDO Dayton standard. Pin Wire color Connection to loudspeaker B1 Blue + Rear right (RR+) B2 Blue/black - Rear right (RR-) B3 Grey + Front right (FR+) B4 Grey/black - Front right (FR-) B5 Green + Front left (FL+) B6 Green/black - Front left (FL-) B7 White + Rear left (RL+) B8 White/black - Rear left (RL-) Use only loudspeakers of 4 Ohms impedance. A A Do not connect the lo
Résumé du contenu de la page N° 10
INSTALLATION INSTRUCTIONS Installing the GPS antenna, Fig. 7 The GPS antenna may be installed in the passenger compartment, for example on the dashboard or the rear shelf. The antenna needs to have unrestricted “visual contact” to the sky. Clean the mounting surface and attach the antenna with the double-sided adhesive – tape. – Vehicles with metallised windows should have the antenna installed on the trunk lid, on the roof or in the plastic bumper. Note: To guarantee the functioning of the ante
Résumé du contenu de la page N° 11
INSTALLATION INSTRUCTIONS Initial operation, Fig. 12 1. Reconnect the battery. 2. Restore complete functioning of the electrical system (clock, trip computer, alarm sys - tem, airbag, immobiliser, etc.). 3. Switch on the ignition. 4. Insert the map CD in the radio. To register the system and enable map, travel and/or traffic info, see the operating instructions, Section “C-IQ”, ➽ page 31. 5. Park the vehicle outdoors to ensure unimpeded GPS reception. 6. Switch on the ignition and the radio. 7.
Résumé du contenu de la page N° 12
INSTALLATION INSTRUCTIONS Drive through several intersections and monitor the current vehicle position in the “ Car Position ” information menu. Once the displayed position agrees with the actual car position, calibration is complete. Note: The system can also be calibrated without enabling the contents of the C-IQ. However, no directional information will be provided. The current vehicle location can then be checked in the emergency menu (see operating instructions, page 51). Hotline Technical
Résumé du contenu de la page N° 13
Résumé du contenu de la page N° 14
GENERAL INFORMATION Comments After transport of the vehicle by train or ferry, the navigation system may require a few minutes for exact positioning. After disconnecting the vehicle battery, up to 15 minutes may be required for exact positioning. For this, the vehicle must be outdoors and the system must be switched on in order to receive transmissions from the GPS satellites. The digital road map To be able to plan a route to a destination address, the navigation system not only requires the cu
Résumé du contenu de la page N° 15
SAFETY The system has the following safety functions to prevent theft: Security code The navigation radio can be protected against theft with a security code. The unit is disabled as soon as it is disconnected from the voltage supply (e.g. if it is stolen). It can only be reactivated by entering the security correct code. The security code can be activated/deactivated and changed. For further information see “INITIALIZATION”, option “Security Code” ➽ page 30. Anti-theft protection LED When the n
Résumé du contenu de la page N° 16
PREFACE RDS (Radio Data System) Many FM stations transmit RDS information. The navigation radio evaluates the RDS telegram and offers the following advantages: PS (Program Service Name): Display of station name, – – PTY (Program TYpe): Station selection by program type, ➽ 24 – AF (Alternative Frequency): Automatic retuning to of best alternative frequency, – TA (Traffic Announcement): Traffic announcements , ➽ 18 – EON (Enhanced Other Networks): Automatic fading in of traffic announcements on ot
Résumé du contenu de la page N° 17
INFO OPERATION Control elements 15 14 13 12 11 10 9 MUTE BAND ALT-R 1 RADIO NAV MS 4150 CD.C SOUND CLEAR 2 8 14 25 36 POWER VOLUME SCAN 3 4 5 6 7 1 o . . . . . . . . . . . . Release button for operating panel 2 SOUND . . . . . . . . Opens the “SOUND” menu. ➽ page 20 3 POWER/VOLUME . Press: Switching on / off . . . . . . . . . . . . . . Turn: Setting the volume 4 INFO . . . . . . . . . . Opens the “INFORMATION” menu. ➽ page 18. 5 1 ... 6 . . . . . . . . . Radio mode: Briefly press preset buttons
Résumé du contenu de la page N° 18
OPERATION Displays In radio mode: TA/TMC: Traffic Announcements / TMC (see “INFORMATION” menu) Time CD icon flashes: route is being 1:29 pm x planned. Do not remove map CD! Waveband FM A RADIO DX 6 Preset number Frequency 105.9 Selected search sensitivity (for automatic search tuning) Radio 1 Program (Station) name Selected search mode (only with RDS stations) In CD player mode: Time 3:29 pm CD title (if entered) Rnd.: Random playback JIMMY HENDRIX Rnd. With CD Text available: Artist Rpt.: Repea
Résumé du contenu de la page N° 19
OPERATION Inserting a CD 1. Open the front panel. 2. Insert the CD into the drive (printed side up). For audio CDs, playback starts automatically. 3. Close the front panel. Removing a CD 1. Open the front panel. 2. Press the eject button. 3. Carefully remove the CD and close the front panel. Switching on / off Press the POWER/VOLUME knob to switch the unit on or off. Volume A When setting the volume, please make sure that traffic noises (horns, sirens, emergency vehicles, etc.) are still audib
Résumé du contenu de la page N° 20
OPERATION Menu operation Cursor The currently selected line or field on the screen is Menu title designated as the cursor. The cursor is identified by Active option 2 an inverse field (bright letters on black background). Active option 3 Move the cursor by turning the right rotary con- Active option 4 trol. Confirm by pressing the right rotary control. Active option 5 To confirm, the cursor will be displayed briefly as a frame around the selected field. Currently non-available options appe
