Résumé du contenu de la page N° 1
CUSTOMER NOTICE
Please retain this booklet and write in the serial number of your CD5433 for
identification. The serial number is labeled or stamped on the chassis.
Serial No.
MODEL CD5433
ESN E5 High-Power CD Receiver with
Multi Control and Remote
DIVISION OF FUJITSU TEN CORP. OF AMERICA
19600 SOUTH VERMONT AVENUE, TORRANCE, CA 90502
(310) 327-2151 OWNER'S MANUAL
We appreciate your purchase of this receiver.
090001-1443A700
Please read through this manual for correct operation.
0303 (Y.O)
Résumé du contenu de la page N° 2
For your safety in using the CD5433 Warnings and caution signs, illustrated below, are posted throughout this manual as well as on the CD5433. They show safe and correct ways to handle the product so as to prevent personal injury to you and others and avoid damage to property. IMPORTANT Before reading through the manual, take time to read through and learn the important information listed in this section. RECORD YOUR “KEY CD” This sign indicates a situation in which incorrect handling through di
Résumé du contenu de la page N° 3
Warning • Do not place the vinyl storage bag over a person. It may cause a serious accident or death by suffocation. • Do not adjust the controls while driving the car. To adjust the controls, stop the car in a safe location. • To prevent accidents, store batteries for the remote control out of the reach of small children. In case a child swallows a battery, consult a physician immediately. • Do not disassemble or rebuild this product. Doing so may cause an accident, fire or electrical shock. •
Résumé du contenu de la page N° 4
Warning • To prevent a short circuit from occurring, disconnect the battery's negative terminal before installing this product. Otherwise, an electric shock or injury may result. • When using an existing nut and/or bolt from the vehicle to ground this product, do not use any that secure parts of the steering or braking systems. Otherwise, an accident may result. • Bundle cables and harnesses with electrical tape or wire ties to prevent them from interfering with moving parts. If they should enta
Résumé du contenu de la page N° 5
Caution • Play the audio at a moderate volume level that permits you to hear sounds from outside the car. Driving without being able to hear outside sounds may result in an accident. • Keep foreign objects out of the disc slot. They may cause fire or electrical shock. Another possibility is that discs may be damaged or become stuck. • Do not stick your fingers or hands into the disc slot. Doing so may cause personal injury. • This product must be operated only as on-board equipment, or it may c
Résumé du contenu de la page N° 6
Caution • Avoid installing this product in places where it may get wet, such as near windows, or in places that are moist or dusty. Presence of liquid, moisture or dust inside this product can cause short circuiting, resulting in smoke or fire. • Do not install this product in locations where it cannot be fastened securely, such as places subject to frequent vibration. Otherwise, it may become dislodged and cause an accident or injury. • Do not block this product's vent or heat sink. If either i
Résumé du contenu de la page N° 7
Table of Contents Operating precautions...............................................10 Notes on operation.......................................................................10 About compact discs ....................................................................11 About cleaning a CD ....................................................................13 Names of controls and parts ....................................14 ESN (Key CD) security operating procedure ..........15 How to program
Résumé du contenu de la page N° 8
How to operate the MP3 player ................................43 About MP3....................................................................................43 Listening to MP3 file.....................................................................46 Advancing to the next track (file) or returning to the beginning of the track (file) being played ..........................................................47 Skipping to the next or previous folder.........................................47 Ret
Résumé du contenu de la page N° 9
How to operate the receiver with an optional CD changer connected..............................................70 Listening to a CD..........................................................................70 Advancing to the next track or returning to the beginning of the track being played ..................................................................70 Fast Forward/Rewind ...................................................................70 Playing the beginning of tracks (SCAN).........
Résumé du contenu de la page N° 10
Operating precautions Operating precautions Notes on operation • For your safety, play only at volume levels that allow outside sounds to be heard. • We recommend using with this player a disc with the logo shown to the left. • You can play music CDs(CD-R/CD-RW) on this player. Be sure to use discs that have been properly processed. Depending on the editing equipment used, some discs may not play prope
Résumé du contenu de la page N° 11
Operating precautions About compact discs • The signal recorded on a compact disc is read by a laser beam, so nothing touches the disc surface. A scratch on the recorded surface or a badly warped disc may cause deteriorated sound quality or intermittent playback. Observe the following precautions to ensure high quality sound performance: • Do not leave an ejected disc in the disc slot for very long; the disc may warp. Discs should be stored in their cases and kept away from high temperature and
Résumé du contenu de la page N° 12
Operating precautions About brand new CDs About CD accessories • You may notice that some brand • Do not use accessories new discs are rough around the (stabilizers, protective seals, laser center hole or outside edge. lens cleaners, etc.) sold for Remove the rough edges with “improving sound performance” the side of a ballpoint pen, etc. or “protecting CDs.” The changes Rough edges may prevent in CD thickness or outside proper loading in the deck. dimensions made by these Flakes from the rough
Résumé du contenu de la page N° 13
XXXX XXXX NO GOOD Operating precautions About borrowed CDs About irregularly-shaped CDs • Do not use a CD with glue or • Specially-shaped CDs, like remnants of adhesive tape or heart-shaped or octagonal CDs, labels. They may cause the CD cannot be played. Do not to get stuck inside or damage attempt to play them, even with the deck. an adapter, since they may damage the player. How to remove CDs • When removing the ejected disc, pull it straight out along the slot. Pressing downward in the proc
Résumé du contenu de la page N° 14
Names of controls and parts Names of controls and parts Front view With the front open Never place an object or rest your hands or the like on the front panel. Caution [DISC] button Switches disc modes and switches to AUX mode. [E-COM] button* Activates and deactivates mute. [OPEN] button Opens/closes front panel and adjusts angle. Selects radio preset channels and performs disc mode Buttons [1] to [6] functions. [SOUND] button Turns the sound adjustment mode ON/OFF. Turns screen adj
Résumé du contenu de la page N° 15
ESN (Key CD) security operating procedure ESN (Key CD) security operating procedure Button [6] [FUNC] button How to program the Key CD Check that the Power is OFF. 1 Press and hold button [6], then the [FUNC] button, and 2 hold both for more than one second. A [SEC] message appears, then in two seconds it will change to [DISC]. The front panel opens; the CD5433 is now ready to accept your Key CD in the CD slot. Insert the CD into the slot. 3 The front panel closes. A [SEC] message appears, the
Résumé du contenu de la page N° 16
ESN (Key CD) security operating procedure Button [6] [FUNC] button How to cancel the Key CD Turn OFF the Power. 1 Press and hold button [6], then the [FUNC] button, and 2 hold both for more than one second. A [SEC] message appears, then in two seconds it will change to [DISC]. The front panel opens; the CD5433 is now ready to accept your Key CD in the CD slot. Insert your Key CD into the slot. 3 The front panel closes. A [CANCEL] message appears, the front panel opens, then the Key CD is eject
Résumé du contenu de la page N° 17
ESN (Key CD) security operating procedure How to change the Key CD First, cancel the existing Key CD. 1 Refer to “How to cancel the Key CD.” Next, program a new Key CD. 2 Refer to “How to program the Key CD.” How to resume normal operation (ESN security lock out) If power is disconnected while ESN security is active (a Key CD was programmed), operation is disabled until power is restored and the unit unlocked. Follow this procedure to resume normal operation. When the power is turned on afte
Résumé du contenu de la page N° 18
ESN (Key CD) security operating procedure Button [6] [FUNC] button What happens if an incorrect CD is inserted? An [ERR] message will be appear, then change to a 1 flashing [DISC], then the CD will be ejected. You will have five uninterrupted attempts to insert the correct CD. After the 5th incorrect attempt, the display reads [HELP]. 2 If [HELP] appears on the screen, press button [6], then 3 the [FUNC] button, and hold them for five seconds. Press the [FUNC] button. 4 You will have five more
Résumé du contenu de la page N° 19
ESN (Key CD) security operating procedure Button [2] Button [4] [FUNC] button How to turn the security indicator on/off Once ESN security is activated, the indicator flashes whenever the vehicle’s ignition is turned off, warning potential thieves that the unit is protected. However, if you do not want this visible deterrent, it may be turned off. With the power OFF, press button [2], then the [FUNC] 1 button and hold both for more than one second. [IND. FLASH] or [IND. -----] appears on the dis
Résumé du contenu de la page N° 20
Basic operation Basic operation [PWR] button This section covers basic operating procedures. For additional details, please refer to the sections on specific functions. Turning the power on and off Turning the power on and off. When the power is turned on, the state used when the power was turned off such as CD and tuner playing is restored. When the vehicle has no ACC position on the ignition switch, care is needed when turning off the deck. Follow Step 2 or Step 3 when turning off the power.
