Résumé du contenu de la page N° 1
Operator’s Manual
2-Cycle Trimmer
Model CC 3075
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
P/N 769-01388 (2/05)
Résumé du contenu de la page N° 2
INTRODUCTION THANK YOU TABLE OF CONTENTS Thank you for buying this quality product. This modern Service Information . . . . . . . . . . . . . . . . . . . . . . . . .2 outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. Rules for Safe Operation . . . . . . . . . . . . . . . . . . . . .3 This operator’s manual provides you with easy-to- understand operating instructions. Read the whole Know Your Unit . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 3
RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your SYMBOL MEANING attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding. The safety warnings do not by Failure to obey a DANGER: themselves eliminate any danger. The instructions or safety warning will warnings they give are not substitutes for proper result in serious injury to yourself or to accident prevention measures. others. Always follow the safety p
Résumé du contenu de la page N° 4
RULES FOR SAFE OPERATION • Always stop the engine and allow it to cool before filling • Keep hands, face, and feet at a distance from all the fuel tank. Never remove the cap of the fuel tank, or moving parts. Do not touch or try to stop the cutting add fuel, when the engine is hot. Never operate the unit attachment when it is rotating. without the fuel cap securely in place. Loosen the fuel • Do not touch the engine or muffler. These parts get tank cap slowly to relieve any pressure in the tank.
Résumé du contenu de la page N° 5
RULES FOR SAFE OPERATION SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING SYMBOL MEANING • THROWN OBJECTS AND • SAFETY ALERT SYMBOL ROTATING CUTTER CAN CAUSE Indicates danger, warning, or SEVERE INJURY caution. May be used in conjunction with other symbols or pictographs. WARN
Résumé du contenu de la page N° 6
RULES FOR SAFE OPERATION KNOW YOUR UNIT APPLICATIONS With the optional brushcutter accessory kit: As a trimmer: • Cutting weeds and light bush of up to 1/2 inch in diameter • Cutting grass and light weeds. • Edging Spark Plug Starter Rope Grip • Decorative trimming around trees, fences, etc. Other optional accessories may be used with the CC3075. Refer to Operating the EZ-Link System for Fuel Cap a list of add-ons. Shaft Grip On/Off Stop Control Air Filter Cover Throttle Control D-Handle EZ-Link
Résumé du contenu de la page N° 7
ASSEMBLY INSTRUCTIONS 5. While holding the unit in the operating position INSTALL AND ADJUST THE D-HANDLE (Fig. 2), move the D-handle to the location that 1. Remove the screws and bottom clamp piece that provides you the best grip. were installed on the D-handle for shipping. 6. Tighten the clamp screws evenly, until the D-handle 2. Place D-handle over the shaft housing and onto the is secure. bottom clamp (Fig. 1). Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip. 3. Sta
Résumé du contenu de la page N° 8
OIL AND FUEL INFORMATION Thoroughly mix the proper ratio of 2-cycle engine oil OIL AND FUEL MIXING INSTRUCTIONS with unleaded gasoline in a separate fuel can. Use a 40:1 Old and/or improperly mixed fuel are the main reasons fuel/oil ratio. Do not mix them directly in the engine fuel for the unit not running properly. Be sure to use fresh, tank. See the table below for specific gas and oil mixing clean unleaded fuel. Follow the instructions carefully for ratios. the proper fuel/oil mixture. NOTE:
Résumé du contenu de la page N° 9
STARTING/STOPPING INSTRUCTIONS Start/ Stop/ Operate this unit only in a On (I) Off (O) WARNING: well- ventilated outdoor area. Carbon monoxide exhaust fumes can be lethal in a confined area. Avoid accidental starting. WARNING: Make sure you are in the starting position when pulling the starter rope (Fig. 5). To avoid serious injury, the operator and unit must be in a stable position while starting. Throttle STARTING INSTRUCTIONS Fig. 3 1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. S
Résumé du contenu de la page N° 10
OPERATING INSTRUCTIONS OPERATING THE EZ-LINK™ SYSTEM 2. While firmly holding the add-on, push it straight into the EZ-Link™ coupler (Fig. 7). The EZ-Link™ system enables the use of these optional Add-Ons. NOTE: Aligning the release button with the guide recess will help installation (Fig. 6). Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC Release Button EZ-Link™ Coupler Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE Primary Hole
Résumé du contenu de la page N° 11
OPERATING INSTRUCTIONS NOTE: Do not rest the Bump Head™ on the ground HOLDING THE TRIMMER while the unit is running. Always wear eye, Some line breakage will occur from: WARNING: hearing, foot and • Entanglement with foreign matter body protection to reduce the risk of injury when operating this unit. • Normal line fatigue Before operating the unit, stand in the operating position • Attempting to cut thick, stalky weeds (Fig. 9). Check for the following: • Forcing the line into objects such as w
Résumé du contenu de la page N° 12
MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE NOTE: Maintenance, replacement, or repair of the emission control devices and system may be Perform these required maintenance procedures at the performed by any non-road engine repair frequency stated in the table. These procedures should establishment, individual or authorized service also be a part of any seasonal tune-up. dealer. NOTE: Some maintenance procedures may require In order to assure peak performance of your engine, special t
Résumé du contenu de la page N° 13
MAINTENANCE AND REPAIR INSTRUCTIONS For Use with Single For Use with SplitLine™ 9. Insert the end of the line into the open hole in the Line ONLY or Single Line inner reel and pull the line tight to make the loop as small as possible (Fig. 17). Slotted Holes 10. Before winding, split the line back about 6 inches. 11. Wind the line in tight even layers in the direction indicated on the inner reel. NOTE: Failure to wind the line in the direction indicated will cause the cutting attachment to opera
Résumé du contenu de la page N° 14
MAINTENANCE AND REPAIR INSTRUCTIONS INSTALLING A PREWOUND REEL Tab 1. Hold the outer spool with one hand and unscrew the Air Filter bump knob clockwise (Fig. 12). Inspect the bolt Cover inside the bump knob to make sure it moves freely. Replace the bump knob if damaged. 2. Remove the old inner reel from the outer spool (Fig. 12). 3. Remove the spring from the old inner reel (Fig. 12). 4. Place the spring in the new inner reel. NOTE: The spring must be assembled on the inner reel before reassem
Résumé du contenu de la page N° 15
MAINTENANCE AND REPAIR INSTRUCTIONS CARBURETOR ADJUSTMENT Idle Speed Screw The idle speed of the engine is adjustable through the air filter/muffler cover (Fig. 23). NOTE: Careless adjustments can seriously damage your unit. An authorized service dealer should make carburetor adjustments. Check Fuel Mixture Old and/or improperly mixed fuel is usually the reason for improper unit performance. Drain and refill the tank with fresh, properly-mixed fuel prior to making any adjustments. Refer to Oil a
Résumé du contenu de la page N° 16
MAINTENANCE AND REPAIR INSTRUCTIONS REPLACING THE SPARK PLUG CLEANING Use a Champion RDJ7Y spark plug, or equivalent. The To avoid serious correct air gap is 0.025 inch (0.65 mm). Remove the plug WARNING: personal injury, after every 25 hours of operation and check its condition. always turn your trimmer off and allow it to cool 1. Stop the engine and allow it to cool. Grasp the plug before you clean or maintain it. wire firmly and pull it from the spark plug. Use a small brush to clean off the
Résumé du contenu de la page N° 17
TROUBLESHOOTING ENGINE WILL NOT START CAUSE ACTION Empty fuel tank Fill fuel tank with properly mixed fuel Primer bulb wasn't pressed enough Press primer bulb fully and slowly 10 times Engine is flooded Squeeze the trigger and pull the starter rope Old or improperly mixed fuel Drain gas tank and add fresh fuel mixture Fouled spark plug Replace or clean the spark plug The outside temperature is below 40º F Pull the starter rope up to 10-15 times The outside temperature is above 90º F Squeeze the
Résumé du contenu de la page N° 18
SPECIFICATIONS ENGINE* Engine Type.......................................................................................................................................... Air-Cooled, 2-Cycle Stroke.................................................................................................................................................... 1.25 in. (31.75 mm) Displacement........................................................................................................................
Résumé du contenu de la page N° 19
California / EPA Emission Control Warranty Statement Your Warranty Rights and Obligations The California Air Resources Board, the Environmental Protection Agency and Cub Cadet LLC (Cub Cadet) are pleased to explain the emission control system warranty on your 2005 and later small off-road engine. New small off-road engines must be designed, built and equipped to meet stringent anti-smog standards. Cub Cadet must warrant the emission control system on your small off-road engine for the periods o
Résumé du contenu de la page N° 20
MANUFACTURER’S LIMITED WARRANTY FOR: No implied warranty, including any implied warranty of The limited warranty set forth below is given by Cub Cadet merchantability or fitness for a particular purpose, LLC with respect to new merchandise purchased and used applies after the applicable period of express written in the United States, its possessions and territories. warranty above as to the parts as identified. No other Cub Cadet LLC warrants this product against defects in express warranty or g
