Instruction d'utilisation JL Audio SB-N-350/10W3v2

Résumé du contenu de la page N° 1

®
Stealthbox
INSTALLATION GUIDE START
HERE
for the
STEP 1: Remove all contents from center
console, rear cargo area, rear glove box com-
SB-N-350/10W3v2
➔ ➔ ➔
partments, lastly slide and tilt the seats to the
(2003-Up 350Z, Will not fit the 350z
front of the car.
Roadster, Infiniti G35 Coupe & Sedans)
STEP 3: Remove the driver’s side and pas-
STEP 2: Remove the driver’s side and pas-
senger’s side door sill panels.
senger’s side rear interior cargo quarter pan-
els.
*Carefully pulling directly

Résumé du contenu de la page N° 2

Cont. From Previous Page ➔ ➔➔➔ STEP 7: Disconnect the white wiring plug at the STEP 8: With the shifter trim panel moved to STEP 9: Engage the emergency brake, by pulling STEP 10: Lift at the rear of the console and care- rear of the A/C controls. one side. Remove the pair of Philip head screws at up on the handle. fully pull unit over the emergency hand brake arm. the front edge of the console. ➔➔ ➔ STEP 11: Disconnect the wiring harness at the STEP 12: Carefully guide the shifter boot trim STE

Résumé du contenu de la page N° 3

➔ Cont. From Previous Page ➔ ➔➔ ➔ ➔ STEP 18: Pull back the carpet in the front section STEP 15: Remove the pair of Philip head STEP 16: Remove the pair of 10mm head bolts at STEP 17: Remove the numerous 10mm head the rear of the glove box. bolts securing the front edge of the glove box liner. of the cargo area to reveal the metal floor. screws securing the passenger side glove box’s door latch. Remove the child seat anchor hooks, reinstall factory bolts without hook. Repeat this STEP for the dri

Résumé du contenu de la page N° 4

Cont. From Previous Page CONGRATULATIONS! INSTALL COMPLETE. ➔ ➔➔ ➔ STEP 24: Set the Stealthbox into position in the STEP 25: The socket cup set screws are protruding STEP 26: Reassemble the vehicle’s panels in vehicle. Placing the socket cup set screws through the into the glove box/factory woofer area. Place the sup- reverse order of disassembly. cut carpet and existing holes from STEP19 & 20. plied fender washer, lock washer and hex nut onto each socket cup set screws. Indentified by the black