Instruction d'utilisation JL Audio Stealthbox SB-F-FLX/10W3v3

Résumé du contenu de la page N° 1

SB-F-FLX-10W3v3 INSTR_SKU# 011293
Installat Ion

d I F F I C u l t Y :

If you choose to perform the installation yourself, it is absolutely vital that
®
out
the Stealthbox be properly mounted to the vehicle according to these
o F
instructions. Failure to mount the enclosure properly presents two problems:
I n s t a l l a t I o n G u I d e
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
35
caused by the force exerted by the woofer(s).
SB-F-FLX/10

Résumé du contenu de la page N° 2

SB-F-FLX-10W3v3 INSTR_SKU# 011293 s t e P 4 S T E P 8 Remove the interior plastic trim panel, you can leave the This is the back of the grille completely removed showing all sections of the panel that the seatbelts go through as of the welds that needed to be removed. shown. s t e P 5 S T E P 9 Remove the OEM subwoofer/amplifier as shown. Run the Looking at the panel from the front, trim all of the edges wire for the Stealthbox® to this general location (indicated by of the opening so that on

Résumé du contenu de la page N° 3

SB-F-FLX-10W3v3 INSTR_SKU# 011293 s t e P 1 2 I n C l u d e d H a R d W a R e Using a Unibit® or, a 9/16” drill bit, drill out the two holes 2) 3/8-16 x 2 1/4” Allen Head Set Screw 2) 3/8-16 Speed Clip as marked in the previous step. do not d RIll dee PeR t Han 1/2” or you run the risk of scarring (or penetrating) 2) 3/8 x 2” Fender Washer 2) 3/8” Split Lock Washer 2) 3/8-16 Hex Nut the outer sheetmetal of the car. s P e C I F I C a t I o n s Enclosure Type: Acoustic Suspension (sealed)