Instruction d'utilisation Winegard VS-0503

Résumé du contenu de la page N° 1

®

WINEGARD
ENTERTAINMENT SELECT
MODEL VS-0503/VS-5312

Model shown has five inputs, three outputs.




FEATURES:
• Simple push button controls allow you to send signals • Low profile housing blends
from any one of 5 different inputs to 2 TVs and VCR. nicely with other electronic
• 5 Inputs are Satellite Receiver, TV Antenna, VCR, components; fits easily in
overhead cabinets.
Cable TV & Auxiliary.
• 3 Outputs: Main TV, TV 2, VCR. • Shielded circuitry for high
isolation and lo

Résumé du contenu de la page N° 2

COAX CABLE CONNECTIONS STEP 1. Connect the coax cable from the output on the switch box marked “To Main TV” to the antenna input connection on the back of the main TV. STEP 2. Connect the coax cable from the output on the switch box marked “To TV 2” to the antenna input connection on the back of the second TV. STEP 3. Connect the coax cable from the output on the switch box marked “To VCR” to the input connection on the back of the VCR. STEP 4. Connect the coax cable from the o

Résumé du contenu de la page N° 3

OPERATION Once all the connections have been properly made to the control box, you are ready to watch your favorite programming. USING THE BUTTONS ON THE FRONT OF THE CONTROL BOX VIEWING STEP 1. To view signals from an amplified TV Antenna, first press the TV Antenna POWER button to the ON position. This provides +12 volt power to the TV antenna amplifier located inside the antenna housing. To view the TV antenna signal on the main TV, simply press the TV ANT button located above t

Résumé du contenu de la page N° 4

TROUBLESHOOTING If the unit doesn’t switch properly between inputs, ( TVs, VCR, SAT, CABLE, etc.), be sure the coax is connected to the proper jacks on the back of the control box. Make sure the center conductors of the coax cables are not bent and are making good contact. See “Installing Coax Connectors” below. If you are using the +12 VDC and light does not turn ON when pushing the power button, go through the following steps. 1. Be sure the unit is wired into a +12 VDC source and that