Résumé du contenu de la page N° 1
™
V. (Versus )
Bare Floor Vacuum
USER’S GUIDE
76T8 SERIES
3 Safety Instructions
4 Product View
5 Assembly
Operation
6
Maintenance and Care
7-8
Troubleshooting
9
10 Consumer Services
11 Replacement Parts
12 Warranty
ug110-4060_76T8_608.indd 1 ug110-4060_76T8_608.indd 1 6/18/08 3:43:52 PM 6/18/08 3:43:52 PM
Résumé du contenu de la page N° 2
Thank you for buying a BISSELL V. (Versus) Bare Floor Vacuum Everything we know about floorcare went into the design and construction of this complete, high-tech home cleaning system. We trust that it will bring you many years of satisfaction. It is backed with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a question, you’ll receive fast, considerate assistance. My great-grandfather invented the f
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic ■ Keep openings free of dust, lint, hair and precautions should be observed, including anything that may reduce airflow. the following: ■ Turn off all controls before plugging or unplugging vacuum cleaner. READ ALL INSTRUCTIONS ■ Use extra care when cleaning stairs. BEFORE USING YOUR ■ Do not pick up flammable materials (lighter fluid, gasoline, kerosene, etc.) or use in the presence of VACUUM. explosive liqu
Résumé du contenu de la page N° 4
Product view Handle Quick Release Cord Wrap Power Cord Hose Holder Power Switch Quick Release Cord Wrap Upper Tank Stretch Hose Dirt Container Crevice Tool ® Lock ‘n Seal Lever Pre-Motor Filter Hose Base Foot Pivot Foot 4www.bissell.com 800.237.7691 ug110-4060_76T8_608.indd 4 ug110-4060_76T8_608.indd 4 6/18/08 3:43:54 PM 6/18/08 3:43:54 PM
Résumé du contenu de la page N° 5
Assembly Tool required: Phillips screwdriver 1. Slide upper handle onto unit. Insert one screw into hole and tighten until snug. Screw will be taped directly above cord wrap on back of handle. 2. Wrap power cord around cord wrap. 3. Store crevice tool on back lower left side of unit by snapping into place. Store the crevice tool on vacuum as shown. Crevice Tool Foot assembly No tools are required for assembly. 1. Slide foot pivot into suction path on body of unit until pivot clicks into
Résumé du contenu de la page N° 6
Operation Transporting your cleaner Place unit in upright position and tip back to roll on rear wheels. Power switch Power switch is located just below handle on left side of dirt container. Push switch “ON” (I) to vac- uum, and “OFF” (0) when cleaning is complete. Power Switch Handle positions 1. Upright – For storage and above floor cleaning with crevice tool. 2. Normal cleaning – Lightly press foot of vacuum and pull handle back to detent. How to use your bare floor vacuum The bare floor
Résumé du contenu de la page N° 7
Maintenance and care Emptying the dirt container Dirt container should be emptied before debris reaches the “full” line on front of container. 1. Unplug unit from electrical outlet. ® 2. Slide Lock ‘n Seal lever to “unlock” position. 3. Grasp clear dirt container and pull out to ® remove from vacuum. Lock 'n Seal Lever 4. Empty dirt into trash can. 5 . Put dirt container back in vacuum and slide lever to “lock” position. Note: Dirt container needs to align with notch inside of unit in orde
Résumé du contenu de la page N° 8
Maintenance and care Clearing clogs Low suction or poor pickup may be due to a clog in dirt cup. If this occurs, follow these steps to check for and clear clog: 1. Unplug unit from electrical outlet. Ensure power is OFF. 2. Empty dirt container. 3. Check upper tank for build up or clogs. 4. Remove separator grill and check suction inlet for clog. 5. Grasp hose grip and lift to separate from suction opening. Check for clog in base or hose. 6. Release twist n’ snap hose from unit by turnin
Résumé du contenu de la page N° 9
W ARNING: Troubleshooting To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing. Vacuum won’t turn on Possible cause Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker 2. Check fuse or reset breaker Vacuum won’t pick up debris or low suction Possible cause Remedies 1. Crack or hole in hose 1. Check hose and replace if needed 2. Hose is loose 2. Make sure both ends of hose are fully inserted 3. Foot is loose 3.
Résumé du contenu de la page N° 10
BISSELL Consumer Services For information about repairs or replacement parts, or questions about your warranty, call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. EST Saturday 9 a.m. — 8 p.m. EST Or write: BISSELL HOMECARE, INC PO Box 3606 Grand Rapids MI 49501 ATTN: Consumer Services Or visit the BISSELL website - www.bissell.com When contacting BISSELL, have model number of unit available. Please record your Model Number: ___________________ Please record your
Résumé du contenu de la page N° 11
Replacement parts Item Part No. Part Name 1 203-0198 Upper Handle with Cord Wrap Clip 2 203-0201 Stretch Hose Assembly 3 203-0202 Dirt Container 4 203-0203 Separator Grill 5 203-0204 Pre-Motor Filter Tray 6 603-1281 Pre-Motor Filter 7 203-0205 Wiper 8 203-0206 Brush 9 203-0207 Foot Assembly 10 203-0208 Crevice Tool 11 203-0209 Hose Holder with Screw 12 203-0213 Screw for Handle 1 2 3 4 5 6 7 8 9 10 11 12 11 www.bissell.com 800.237.7691 ug110-4060_76T8_608.indd 11 ug110-4060_76T8_608.i
Résumé du contenu de la page N° 12
Warranty - BISSELL V. (Versus) Bare Floor Vacuum This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below. Limited One Year Warranty Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL Hom
