Instruction d'utilisation Eureka 2997-2999 Series

Résumé du contenu de la page N° 1

!
!
m
!
a
a
u
k
k
2997-2999 Series
O OW WN NE ER R’’S S G GU UIID DE E
G Gu uíía a d de ell D Du ue eñ ño o
L Le e G Gu uiid de e d du u P Pr ro op pr riié ét ta aiir re e
Before Returning, Call
Eureka Customer Service
Antes de enviar de regreso, Ilame al Servico al Cliente de Eureka
Avant de le retourner, appelez le service à la clientèle Eureka
HELPLINE LÍNEA DE AYUDA LIGNE D’AIDE
1-800-282-2886
8 a.m. to 7:30 p.m. (CST), Monday - Friday
10 a.m. to 6:30 p.m. (CST), Saturday - Sunday
8 a.

Résumé du contenu de la page N° 2

Where to Find Important Vacuum Information Please Retain Record the model, type and serial number below. Date of Purchase____________ (keep your receipt) Model & Type______________________________ Serial Number_____________________________ This information is located on the rating plate on the lower back side of the vacuum. Refer to these numbers when ordering parts, accessories or when service is needed. Before You Start Your Vacuum Cleaner Refer to Quick Start Guide for assembly and use.This

Résumé du contenu de la page N° 3

ENGLISH IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. • Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. ! • Do not allow to be used as a toy. Close attention is necessary wh

Résumé du contenu de la page N° 4

How to Identify Parts of Vacuum Cleaner Quick Release Handle Cord Wrap Cord Retainer Handle Height Power Cord Adjustment Power Paw On ( I ) / Off (O) Switch Bottom Cord Foam & Filter Frame Wrap Hose Connector Self-Cleaning Duster Filter Screen Dusting (located above dust cup) Brush Duster Activation Dust Cup Lever Hose Nested Crevice Tool Dust Cup Lever & Extension Wand Lower Hose Handle HEPA Filter Compartment Headlight Release Height Adjustment Knob Edge Kleener Window Brush Roll Cover

Résumé du contenu de la page N° 5

ENGLISH How to Use Accessories ! Vacuum Cleaner handle must be in upright position. Be sure to raise height adjustment setting before using attachments. Replace hose into hose retainer after using accessories. Telescopic Self-Cleaning Duster – Available on some models Furniture, blinds, pictures and high-reach areas. Can be used in short or extended positions. 1) Activate static charge: Push power switch ( I ) on and push lever down for 10 seconds to clean or charge duster. 2) Turn vacuum off

Résumé du contenu de la page N° 6

How to Maintain Your Vacuum Cleaner ! Make sure vacuum cleaner is turned off and power cord is unplugged Maintain Brush Roll – Call Eureka Customer Service HELPLINE – Part number 62365-4 Motor can become hot with normal use. Do not remove end caps. Remove hair and threads from brush roll periodically. Check EXT-U Belt if Cut or Out of Shape – Part number 61120C Avoid touching the motor shaft when checking brush roll belt. ! 1) Use handle release to lower handle flat onto floor (Fig. 1). 2) Rem

Résumé du contenu de la page N° 7

ENGLISH How to Clear a Blockage Make sure vacuum is turned off and power cord is unplugged. ! Hose Blockage 1) Remove hose from hose retainer. Flexing the hose will loosen any blockage (Fig 1). 2) Base hose – remove 2 screws and brush roll cover. Clear blockage from base hose. Check for debris in brush roll and replace screws and cover (Fig 2). 3) Hose connector – twist hose from connector. Remove blockage and replace hose. For better access, unclip sides and clear blockage. Clip back into p

Résumé du contenu de la page N° 8

Thermal Cut-Off This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, push the on/off switch to off (O) and unplug the vacuum. Check the vacuum for a possible source of overheating such as a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and turn on the switch. If the vacuum s