Résumé du contenu de la page N° 1
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 1
Owner’s Manual
Résumé du contenu de la page N° 2
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 2 INTRODUCTION Drive + Play Warnings Distraction Warning Thank you for purchasing Harman Kardon’s Drive + Play™, an elegant mobile audio solution that provides the driver with Do not connect or disconnect your iPod or program Drive + Play ® total iPod control, including full music browsing capability. while driving. Always be careful and attentive to your vehicle We’ve organized this manual to make installation and operation and the traffic around
Résumé du contenu de la page N° 3
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 3 INSTALLATION INSTALLATION Choosing Installation Locations IMPORTANT: Drive + Play should be installed according to Parts List these instructions and relevant regulations. No part of this Drive + Play includes the following components and parts: system should obstruct the driver’s view of the road or • Text Display With Universal Mounting Base and Attached vehicle controls or information displays necessary for Cable (3m) safely operating the vehicl
Résumé du contenu de la page N° 4
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 4 Wireless FM Transmission Choosing Installation Locations (continued) This method is the most convenient and requires the least Electronics Enclosure Location wiring. After setup, you simply tune your radio to the assigned The Electronics Enclosure contains the wireless FM transmitter FM frequency to listen to your iPod. Drive + Play has a built-in and the power supply for the three components. You can install FM transmitter and its software provid
Résumé du contenu de la page N° 5
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 5 INSTALLATION Wiring Diagram iPod Text Display Control Knob Audio Input/Output Jacks Tip = LEFT RIGHT = Ring Sleeve = GROUND 3.5mm Stereo Mini-Plug Cable iPod Cable Head Unit/Radio Electronics Enclosure Wireless FM Transmitter Side Back or or Antenna In Aux. L/R In 12-Volt Power 3.5mm Stereo Cable Harness Line Out Cable or Third-Party (not included) CD Changer Interface (optional) or CD Changer L/R In 2A Fuse Wired Auxiliary FM Adaptor Device (opt
Résumé du contenu de la page N° 6
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 6 b. Select another viewing angle position (middle or top). Installing Components Reassemble the parts in reverse order and tighten the Installing the Electronics Enclosure recessed hex screw. At the selected site, install the Electronics Enclosure. Use either the enclosed cable ties or mounting screws, as shown below. 3mm Hex Key Display Base Display Assembly 2. At the base, using the 1.5mm hex key, loosen (but do not remove) the hex setscrew. Inst
Résumé du contenu de la page N° 7
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 7 INSTALLATION b. At the proposed site, wipe the surface and exposed 1. Place the Control Knob at the site and check the operation mounting plate with one of the enclosed alcohol pads. angle with the default 30° base. If it meets your needs, Allow both to dry. then skip to step 2. Otherwise, change the base as follows: c. Remove the protective tape from one side of one of the a. Using a Phillips screwdriver, remove the two screws enclosed adhesive p
Résumé du contenu de la page N° 8
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 8 Installing Components Control Knob Installing the Control Knob (continued) With 0° Base 2. At the base (below the cable), using the 1.5mm hex key, loosen (but do not remove) the hex setscrew. 3. To install the Control Knob with adhesive tape, perform the following steps or skip to step 4: a. Insert the mounting plate, rotate it 180°, and tighten Arrow the hex setscrew. Mounting Control Knob Plate With 0° Base 5. Route the attached cable to the Ele
Résumé du contenu de la page N° 9
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 9 OPERATION Drive + Play operates much like the iPod itself. The Control • Drive + Play will tell your iPod to play the same selection Knob mimics the iPod’s Click Wheel, and its software uses a as when it was last turned off. If you plugged your iPod similar menu-select system. Before you use Drive + Play, into Drive + Play while it was playing, Drive + Play will tell you’ll need to set it up for the first time. After you perform the iPod to play t
Résumé du contenu de la page N° 10
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 10 • When Large Fonts are enabled, you can also enable Initial Setup (continued) or disable Auto Scroll, which automatically scrolls a Setting AUX Input text message longer than 16 characters in the Now To route an audio signal from a device (e.g., cell phone or Playing screen: satellite radio; see Wiring Diagram on page 5) connected to Drive + Play Menu > Settings > Display Settings > Auto Drive + Play’s auxiliary input to your mobile audio sys
Résumé du contenu de la page N° 11
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 11 OPERATION Setting the Sleep Timer Now Playing Drive + Play is equipped with a sleep timer that delays its Song Title power off by a default of 2 seconds after the ignition is Artist turned off. You can set a different delay time as follows: TO1 0:00 NOTE: Sleep Timer only works when the Drive + Play’s ACC wire is connected to the ignition switch’s accessory terminal (see Wiring Diagram on page 5). • Drive + Play Menu > Settings > Sleep Timer > s
Résumé du contenu de la page N° 12
Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 12 TROUBLESHOOTING TECHNICAL SPECIFICATIONS Dimensions of Electronics Enclosure: Problem: 6" (152.0mm) x 1-1⁄4" (32.4mm) x 2-5⁄8" (66.4mm) (W x H x D) Message = iPod Disconnected Maximum Mounting Diameter of Text Display: Solution: 1-13⁄16" (46.2mm) • Check that the iPod Connection Cable is connected Maximum Mounting Diameter of Control Knob: between the Electronics Enclosure and the iPod. 1-13⁄16" (45.9mm) Problem: Fuse Rating: 2A Message = AUX is
