Instruction d'utilisation Metra Electronics 99-7009

Résumé du contenu de la page N° 1

INSTALLATION INSTRUCTIONS FOR PART 99-7009
APPLICATIONS
Mitsubishi Endeavor
2004-2010
99-7009
KIT FEATURES
DIN Head Unit Provisions
ISO DIN Head Unit Provisions
KIT COMPONENTS
A) Radio Housing B) ISO Brackets C) Trim Plate
C
A
B


WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:


Antenna Adapter:



T OOLS REQUIRED:
Phillips Screwdriver Socket Wrench
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004-2010 METRA ELECTR

Résumé du contenu de la page N° 2

99-7009 Dash - Mitsubishi ---------------------------------- Kit - ISO Head Unit Provision with Pocket ---------------------------- - DIN Head Unit Provision with Pocket ---------------------------- Final Assembly ------------------------------------------------------ Notes ---------------------------------------------------------------- KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in

Résumé du contenu de la page N° 3

DY A SH DISA SSEMBL 99-7009 2004-2010 MITSUBISHI ENDEAVOR A Disconnect the negative battery terminal 1 to prevent an accidental short circuit. 2 Unsnap and remove entire panel sur- rounding radio and A/C controls. (Figure A) Remove (1) 10MM nut from the rear support 3 on the top left of radio on cross bar behind B dash. (FIGURE B) 4 Remove (3) Phillips screws to remove factory radio chassis (Figure C) Remove (4) Phillips screws from the pock- 5 C et at the bottom of the radio

Résumé du contenu de la page N° 4

Résumé du contenu de la page N° 5

Résumé du contenu de la page N° 6

Résumé du contenu de la page N° 7

Résumé du contenu de la page N° 8

INST997009 1-800-221-0932 www.metraonline.com Rev. 04-26-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7009