Résumé du contenu de la page N° 1
Installation Instructions / Owner's Manual
MP6600
AM/FM HIGH POWER SLIDE DOWN DETACHABLE FACE
MP3 / COMPACT DISC PLAYER
60W x 4
CD-R/RW
Résumé du contenu de la page N° 2
1
Résumé du contenu de la page N° 3
INTRODUCTION Congratulations on your purchase of a Profile state-of-the-art single disc CD/MP3 player. Your selection of a Profile car audio product indicates a true appreciation of fine musical reproduction. Whether adding to an existing system or including your Profile CD/MP3 player in a new system, you are certain to notice immediate performance benefits. FEATURES 60W x 4 Power Output Power Level Meter MP3 Playback Multi-Color LCD CD-R/CD-RW Capability Infrared Remote Control Dual RCA L
Résumé du contenu de la page N° 4
SAFETY PRECAUTIONS Secure the CD/MP3 player. When installing your CD/MP3 player in the vehicle, make sure it is mounted properly in the dash, using an after market installation kit if needed. When using the supplied mounting bracket, it is a must that you also use the supplied back brace to support the back of the CD/MP3 player. Use caution when mounting the CD/MP3 player. Remember there are many electrical wires, vacuum lines, brake lines and air bag deployment wires. Make sure you know
Résumé du contenu de la page N° 5
CARE AND MAINTENANCE Cleaning the CD/MP3 player. When cleaning the vehicle, be sure not to get any water in or on the CD/MP3 player. Clean only the exterior surface of the unit with a dry, clean soft towel using no chemical solvents. Operating in extreme temperatures Sometimes the unit will not operate in extreme, hot or cold temperatures. If this is the case, wait until the temperature in the vehicle is normal, then resume operation. Protect your CD’s. When not using the disc player, it
Résumé du contenu de la page N° 6
FUSES ELECTRICAL AND SIGNAL CONNECTIONS Before making the following connections, take time to look over the vehicle’s wiring and determine the location and wires you will be connecting to. If you do not wish to cut or tap into the vehicles existing factory wiring, there are wiring kits available at your car audio retailer that will allow you to plug directly into the factory wiring harness. Make sure to test all wires before connecting to the CD Player. ! Connect Black wire to chassis gro
Résumé du contenu de la page N° 7
FUSES TWO SPEAKER SYSTEM BLACK LEFT CHANNEL (WHITE) FRONT WIRES RCA’S LOW LEVEL SIGNAL OUTPUT RIGHT CHANNEL (RED) FOR CONNECTION TO REAR LEFT CHANNEL (WHITE) GREY AMPLIFIERS OR SIGNAL RCA’S WIRES RIGHT CHANNEL (RED) PROCESSORS ANTENNA CONNECTOR FUSES 15A (VIOLET WIRE) 1A (RED WIRE) BROWN GREY FRONT LEFT FRONT RIGHT SPEAKER SPEAKER (4 OHM) (4 OHM) BLACK/WHITE PINK CONSTANT +12V NOT USED NOT USED BATTERY +12V NOT USED NOT USED WHITE +12V REMOTE OUTPUT FOR AMPLIFIER TURN-ON SWITCHED +12V OR POW
Résumé du contenu de la page N° 8
MOUNTING THE CD/MP3 PLAYER There are two different ways to mount the CD / MP3 Player. In most Japanese vehicles you can use the factory mounting brackets, taking advantage of the ISO/DIN opening. If your vehicle does not have ISO/DIN opening, you can mount the CD/MP3 Player using the supplied DIN sleeve and rear support bracket. When considering your mounting location, make sure the unit will be level. If you cannot mount the CD/MP3 Player level, due to your vehicle’s design, make sure
Résumé du contenu de la page N° 9
Attach the back brace to the CD/MP3 player using the supplied hardware. Then attach the other end of the brace to a firm mounting surface (i.e. Dash brace, fire wall, e.t.c.) This will brace the back of the CD/MP3 player to ensure solid mounting to prevent theft and provide optimal CD play. Once the CD/MP3 player is secured, fit the trim ring over outside edge of the radio until it snaps into place. Insert the face plate with the right side first. Angle in the right side slightly the
Résumé du contenu de la page N° 10
ISO/DIN MOUNTING If you own a Japanese vehicle, you can use the mounting screw holes on the side of the CD/MP3 player to attach to the factory mounting brackets. ! Detach the removable face of the MP6600 by depressing the release button ! Remove the outside trim ring by gently pulling at both outer edges (See page 10). ! Remove the side retaining plates by unscrewing the two phillips screws. ! Remove the brackets from the factory radio, paying close attention to their position. ! Att
Résumé du contenu de la page N° 11
REMOVING THE CD PLAYER In order to remove the CD/MP3 player you will first need to release and detach the front panel. PUSH RELEASE BUTTON TO DETACH THE FRONT PANEL Remove the CD/MP3 player’s trim ring by applying pressure with your finger tips, then gently pull out away from the dash. PLACE FINGER TIPS HERE Insert the provided removal key into the opening on the top left side of the CD/MP3 player. Push the key inward until they snap into place. Firmly grab the key and slowly pull the CD
Résumé du contenu de la page N° 12
OPERATING THE SLIDE DOWN FACE PUSH RELEASE BUTTON TO SLIDE DOWN THE FRONT PANEL. THE FRONT PANEL WILL SLIDE DOWN AUTOMATICALLY. TO CLOSE PANEL, PUSH IN AND UP ON THE LOWER RIGHT EDGE 11
Résumé du contenu de la page N° 13
LOCATION AND FUNCTION OF CONTROLS 60W x 4 CD-R/RW RESET POWER - Press the power button once to turn the CD/MP3 player on. Press the power button again to turn the CD Player off. DISC PLAY - Gently insert the compact disc with the label side facing up into the slot. The disc will automatically be loaded into the unit and start playing the first track of the disc. The digital display will indicate the track number. MUTE - Press the “MUTE” button to silence the CD/MP3 player. Press a secon
Résumé du contenu de la page N° 14
DISPLAY / CLOCK ADJUSTMENT- Press this button , the LCD will display the clock for about 2 seconds, then return to the previous display mode. For clock adjustment, press and hold the “DISP” button until the display flashes. Press the tuning up button to adjust the hours. Press the tuning down button to adjust the minutes. FUNCTION SELECT - Like the DSP button, the “SEL” button allows you to display different functions. Press the “SEL” repeatedly to move the display through Volume
Résumé du contenu de la page N° 15
TUNING CONTROLS - Use the up and down buttons to make the following adjustments SELECT STATIONS - Press and immediately release a tune button or to move a radio frequency number down or up one step. Press and hold a tune button or for several seconds to seek to the next clear station. SKIP TRACKS - Press a tune button or to move to the previous or the next track on the CD. The Track number will show on the di
Résumé du contenu de la page N° 16
BD/LD AMS MODE SCAN - Press the “SCAN” to search for radio stations. PAUSE - Press the “PAUSE” button to stop CD play. Press again to resume normal play. FACE PLATE RELEASE - Press the release button to remove the face plate. RESET BUTTON - The reset button is located under the face plate and can be activated by using a ballpoint pen or small metal object. The reset button should be pressed for the following reasons: The installation is complete, All the function Buttons do not
Résumé du contenu de la page N° 17
THE MP3 FUNCTIONS LOADING THE MP3 DISC Load the Disc as usual, once loaded the MP3 disc will show “MP3 T01” on the display then the message “reading”. Once the disc is loaded the first track will play. The basic operation of the MP3 is the same as the CD operations as explained in the “Location and function of controls” section of this manual. These functions include track up/down, shuffle, cd scan and repeat. Listed below are additional operations specific for MP3’s including direct trac
Résumé du contenu de la page N° 18
DIRECTORY OR TRACK NAME ACCESS. Under MP3 play mode, press the “AMS/MU” (menu) twice and the display will show “*”. Enter the name of directory or track . After entering name of directory or track, press the “ENTER” key to confirm. The illustration below shows the distribution of alphabetical characters using the head units function buttons. Y,Z, SPACE Next Character J,K,L M,N,O P,Q,R D,E,F S,T,U A,B,C 60W x 4 CD-R/RW G,H,I MOVE CURSOR _, -,+ ENTER V,W,X Previous Character If partial Direc
Résumé du contenu de la page N° 19
TROUBLE SHOOTING THE SYSTEM The following chart will help in solving most problems that may occur. Should any problem persist after you have made these checks, please consult your nearest Profile retailer. Before going through this check list, refer back to the wiring and operating procedures. ERROR CODES E1, E2 The unit cannot be operated because of trouble. Press the "RESET" button . If the indi cator still appea rs after pressi ng the "RESET" button, y our unit needs repai r. E1
Résumé du contenu de la page N° 20
SYMPTOM CAUSE SOLUTION The compact The installation angle is Adjust the angle of the unit to less than 30 disc skips. greater than 30 degrees degrees The disc player is installed Check to see if the unit is fastened securely incorrectly with the back brace supporting the rear of the unit. The compact disc is Clean the compact disc with a compact disc extremely dirty or defective cleaning solution or replace the defective disc. compact disc. Condensation build-up on the Leave the disc player
