Instruction d'utilisation Audiovox 1187001PL

Résumé du contenu de la page N° 1

INSTALLATION INSTRUCTIONS
FOR
55-0401x-121 SERIES 1187001PL
2001 DURANGO
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM



These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be re

Résumé du contenu de la page N° 2

MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY SCREW, #8 X 9/16" PWH 2 1 SCREW, # 10 X 1/2" HWH,TEK 2 2 SCREW, 6-32 X 3/4" ,PPH 6 3 WASHER, 3.5 mm 4 4 MOUNTING BRACKET 1 5 CONSOLE 1 6 TEMPLATE 1 7

Résumé du contenu de la page N° 3

I. PREPARATION OF VEHICLE INTERIOR 1. Remove and retain rear A/C controls by pulling downward. Disconnect wire harness. See Figure 1. Set controls in a safe place for reuse later. FIGURE 1 2. Cut template (item 7 pg 2) in area #1. Locate and tape template to the headliner. Make sure template is centered left to right in vehicle and mark area to be cut. Remove template and trim headliner. Cut template areas #2 & #3

Résumé du contenu de la page N° 4

4. Carefully pull (3) A/C wire harness clips from roof brace to extend length of wire harness. It may be necessary to lower the driver’s side of headliner at rd the “B” pillar to gain access to the 3 clip. See Fig. 4 Use caution when pulling on wire harness and pulling downward on headliner. The connector should reach the rear cut-out in headliner when all clips are released. FIGURE 4 5. Install and route all video and audio cables, and any other added component req

Résumé du contenu de la page N° 5

8. Remove and retain mounting bracket and screws (items 5&3 pg2) from console (item 6 pg2). Use rubbing alcohol to clean sheet metal in the cut– out area in headliner. Wipe surface dry with a clean cloth. Remove protective tape from adhesive strips on mounting bracket (item 5 pg2). Make sure bracket is centered prior to pressing tape against roof surface. Once the tape is applied to the roof, DO NOT REMOVE AND REPOSITION or the tape will not stick properly. Install using (2)

Résumé du contenu de la page N° 6

II. INSTALLATION OF CONSOLE 11. Raise console (item 6 pg 2) into approximate position against headliner. Connect O.E. wiring to A/C control. 12. Insert plastic flange on rear of console into opening in headliner. Make sure console is centered left to right. See Figure 9. 13. Secure console secure front of console using