Résumé du contenu de la page N° 1
FWV470
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
Résumé du contenu de la page N° 2
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel. Appliance information: Please enter the details on the appliance rating plat
Résumé du contenu de la page N° 3
Icemaker Display Control Panel Water Nozzle Ice Drawer Ice Water Tray Drip Tray
Icemaker control panel ON OFF 1 2 3 4 5 6 1. On button 2. Off button 3. Water glass button – this button dispenses a small amount of water. 4. Water jug button – this button dispenses a large amount of water. 5. Manual water button – this button dispenses water as lon
Résumé du contenu de la page N° 4
The Icemaker Before first use: 1. Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you. 2. Turn on the machine at the power switch on the left side of the machine The machine will automatically start a drain cycle, which will take approximately five minutes. During this process, the display will show ICE OFF WATER EMPTY. 3. Push the machine back into the housing. 4. Switch on the machine by pressing the button. 5 The machine is now ready for us
Résumé du contenu de la page N° 5
The Icemaker To make ice The icemaker will make ice automatically once it is switched on and will continue to make ice until the ice compartment is full. Whenever ice is removed, the icemaker will make more ice until the compartment is full again. To dispense water The amount of water dispensed from the water nozzle is controlled by three different buttons. – water glass – water jug – manual setting – this button dispenses water as long as the button is pressed. To change the preset button
Résumé du contenu de la page N° 6
Care and maintenance Always disconnect the appliance from the power before any cleaning or maintenance. As the icemaker has a stainless steel or enamel surface, you should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Stainless steel can be effectively cleaned by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth. Proprietary stainless steel cleaners are avail
Résumé du contenu de la page N° 7
Troubleshooting Problem Solution: WATER MISSING shows in the display Check the water supply is connected and switched on ICE FAULT WATER READY shows in the display Turn the icemaker off with , and the main switch on the side, before at first switch on switching it on again. The dispensed water has an unpleasant taste Ensure that only water pipes suitable for drinking water are used ICE FAULT shows in the display Turn the icemaker off with remove some ice and turn it on again. We recommend
Résumé du contenu de la page N° 8
2 min. 200cm Installation IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY SUITABLY 600 QUALIFIED PERSON. We recommend that you seek the assistance of another individual when 450 min installing this appliance. 560 This appliance requires a mains water supply and a connection to the drain/ 450 min 392.5 waste system (drain connection is not supplied) 19 492.5 458 436 1. Slide the base unit into the housing ensuring the dimensions are correct as per figure 1. 440 595 2 min. 200cm 2.
Résumé du contenu de la page N° 9
7. Connect the drain pipe as shown in fig 6 and the other end to an appropriate drain, for example a laundry standpipe or under sink spigot . Drain connections to the plumbing side are not supplied. 8. Insert the appliance into the housing, ensuring that the runners on the machine are located in the runners on the base unit. Then slide the appliance fully into the housing. i Please note: Due to the weight of this appliance, the housing unit m
Résumé du contenu de la page N° 10
Electrical information Warning! This appliance must be earthed. Green & Yellow to Earth Brown to A Live 13 Amp B Fuse Cord Clamp Blue to Neutral The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in
Résumé du contenu de la page N° 11
10
Résumé du contenu de la page N° 12
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
