Résumé du contenu de la page N° 1
L8145
Please keep this instruction sheet for future reference,
as it contains important information.
Requires four “AA” (LR6) and six “AAA” (LR03) alkaline
batteries (not included) for operation.
An adult must install batteries and set-up this system for use.
Tool required for battery installation: Phillips screwdriver
(not included).
TV not included.
TV image quality may vary.
Résumé du contenu de la page N° 2
Battery Installation Base Unit • Locate the battery compartment on the bottom of the base unit. • Loosen the screw in the Hint: We recommend battery compartment door using alkaline batteries with aPhillips screwdriver. for longer battery life. Remove the battery compartmentdoor . • Insertfour “AA” (LR6) alkalinebatteries. • Replacethe batter y compartment door and tighten thescrew with a Phillips screwdriver. 1,5V x 4 Do not over-tighten. “AA” (LR6
Résumé du contenu de la page N° 3
Battery Safety Information Inexceptional circumstances, batteries mayleak fluids that can cause a chemical burninjur y or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of differenttypes: alkaline, standard (carbon-zinc)or rechargeable (nickel-cadmium). • Insert batteries as indicated insidethe battery compartment. • Remove batteries during long periodsof non-use. Always remove exhausted batteries from theproduct. Dispos
Résumé du contenu de la page N° 4
® Connecting Your Star Station to Your TV or VCR Two Microphones Camera ROM Cartridge Play/Pause Reset Power Light Power/Volume Track Forward/Back Important!Y our TVor VCR must have audio andvideo input jacks.
Résumé du contenu de la page N° 5
No t e: The photo above shows a combination TV/VCR/DVD with input jacks on the front. Your TV or VCR may have input jacks on the back. ® • Position Star Station near yourTV (or 1 VCR) or on thefloor infront of your TV . ® Important!Do not place Star Station on topof your TV .Keep excess cable off the floor and out ofthe way. • Make sure the power/volumedial on 2 ® Star Station is off.The power light should be off. • Turn your TV or VCR o
Résumé du contenu de la page N° 6
• Insertthe ROM cartridge into theslot in 4 ® Star Station . Note:For proper function, turn ® Star Station off before inserting ROMcartridges. • Rotate the power/volume dial to turn 5 power on. The powerlight turns on. Hint: Donot turn the volumeall the way up. Start at a lower setting. • Turnyour TVor VCR on. Power/Volume Dial Power Light • To find the picturetransmitted on your 6 TV screen, set your TV's or VCR's mode selector to INPUTo
Résumé du contenu de la page N° 7
No Image? ® Ifyou do not see an image on your TV screen transmitted from Star Station , try the following: 1. Verify that your audio and video cable is fully insertedinto your TV or VCR. 2. Press the channel down button on the TV or VCR andcheck for an INPUT channel below channel 2. 3. Use the menu system on your TVor VCR to find INPUT or SOURCE. Change to INPUT or SOURCE. 4. If you are stillunable to see an image, refer to yourTV or VCR instruction manual. Hints About Li
Résumé du contenu de la page N° 8
• Slidethe power/volume switch on 7 themicrophone to either low or high Power Light volume.The power light turns on. Hint:The microphone power/volume switch Power/Volume controlsthe volume of your voice. Switch • Press theplay/pause button to start 8 the music. Press again topause. Play/Pause • Use the trackforward and back buttons Button to move aheador back through thesongs onthe ROM Cartridge. • Start singing! • Be sure
Résumé du contenu de la page N° 9
Recording Your Performances ® If Star Station isconnected to your VCR, youcan record performances.Simply insert a blank tape and pressrecord on your VCR. VCR not included. Connection to an External Music Source ® You can connect Star Station to an external music source such as a portable music player or stereo so you can sing-along to other music! 1. Turnthe power/volume dialon ® Star Station off. 2. Remove theROM Cartridge from
Résumé du contenu de la page N° 10
Troubleshooting Guide PROBLEM CAUSE SOLUTION No image on the TV TV or VCR is not set to Pressthe channel downbutton on theVCR properinput orTV and check for anINPUT channel below channel2. Use the menu system on your TV or VCR to find INPUT or SOURCE. Change to INPUT or SOURCE. Consult your TV's or VCR’s instruction manual. ® ® Batteries in Star Station Replacethe batteries in Star Station with areweak or dead four, new “AA” (LR6) alkalinebatteries.
Résumé du contenu de la page N° 11
Connecting to a TV or VCR and TV INPUT TV AUDIO IN White LEFT RIGHT TV OR Red VIDEO IN VCR Yellow Note: Input jacks may be on the back of your TV or VCR. One (1) Year Limited Warranty Mattel Australia Pty., Ltd., (658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia) warrants to the original owner that this product is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year f
Résumé du contenu de la page N° 12
Consumer Information Visit us on-line at www.service.fisher-price.com AUSTRALIA: MattelAustralia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312. NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland. ASIA: Mattel EastAsia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©2008 Matt
