Résumé du contenu de la page N° 1
INSTALLATION & OPERATIONAL MANUAL
1HFD & HFC SERIES ELECTRIC FRYERS
With KleenScreen PLUS® Filtration Systems
MODELS:
1HF50D ML-136500
1HF85CF ML-136819
1HF85CF Shown - Computer Control
ENERGY STAR® Qualified
For additional information on Hobart or to locate an authorized parts
and
Résumé du contenu de la page N° 2
HFD, HFCF SERIES ELECTRIC FRYER IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRIC EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. Improper installation, adjustment, alteration, service or maintenan
Résumé du contenu de la page N° 3
HFD, HFCF SERIES ELECTRIC FRYER TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY………………………………………. 2 INTRODUCTION…………………………………………………………… 4 GENERAL…………………………………………………………… 4 ORDERING PARTS………………………………………………… 4 FRYER CAPACITIES………………………………………………. 4 UNPACKING………………………………………………………… 4 INSTALLATION…………………………………………………………...…… 5 CODES AND STANDARDS……………………………………….. 6 ASSEMBLY …………..…………………………………………… 6 ELECTRICAL CONNECTIONS………………………………….. 7 LEVELING THE FRYER………………………………………..…… 8 OPERATI
Résumé du contenu de la page N° 4
HFD, HFCF SERIES ELECTRIC FRYER INTRODUCTION GENERAL Hobart Fryers are produced with quality workmanship and material. Proper installation, usage and maintenance will result in years of satisfactory performance. Before installing the fryer, thoroughly read this manual and carefully follow all instruction. This manual is applicable to model listed on the cover page. Procedures in this manual will apply to all models unless specified. Pictures and illustrations can be of any mo
Résumé du contenu de la page N° 5
HFD, HFCF SERIES ELECTRIC FRYER Do not use the door or its handle to lift the fryer. MODEL - GMO Kw per Fry Tank Width Inch (cm) Total Shortening lbs. (kg) System Each Fry Tank 1HF50D 17 15.5" (39) 50 (23) 1HF85CF 24 21.0" (53) 85 (39) Voltage ranges are: 208, 3 Phase - 50 – 60 Hz 240, 3 Phase - 50 – 60 Hz 480, 3 Phase - 50 – 60 Hz The number preceding the model number of the fryer refers to the number of f
Résumé du contenu de la page N° 6
HFD, HFCF SERIES ELECTRIC FRYER CODES AND STANDARDS The fryer must be installed in accordance with: In the United States: State and local codes, or in the absence of local codes, with: National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection Association, Batterymarch Park, Quincy, MA. 02169-7471. In Canada: Local codes CSA C22.1 Canadian Electric Code L4W 5N6. ASSEMBLY The fryer must be restra
Résumé du contenu de la page N° 7
HFD, HFCF SERIES ELECTRIC FRYER Australia, use only the caster supplied by the manufacturer for the fryer device. The fryer must be installed using a hose assembly restraining device to limit the movement of the appliance in accordance with AS1869. The fryer must be installed with a connector (not supplied by Hobart) complying with the above codes. The fryer must be installed with restraining means to guard against transmission of strain to the connector. See illustration.
Résumé du contenu de la page N° 8
HFD, HFCF SERIES ELECTRIC FRYER LEVELING THE FRYER Check the level of the fryer by placing a level on top of the fryer after electrical connections have been made. Ensure that the fryer is level front-to-back and side-to-side in the final installed position. If using casters, lock the wheels after unit is level. OPERATION Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compoun
Résumé du contenu de la page N° 9
HFD, HFCF SERIES ELECTRIC FRYER Wipe tank completely dry with a soft, clean cloth. FILLING TANK WITH SHORTENING Close the drain valve. Fill the fryer tank with shortening. Hobart recommends using liquid shortening. Shortening level should be between the MIN and MAX lines in the fryer tank. Shortening will expand when heated. Do not fill the fryer tank past the MAX line. Press the melt switch to liquid or solid shortening. Add fresh short
Résumé du contenu de la page N° 10
HFD, HFCF SERIES ELECTRIC FRYER Batter covered foods should be dropped carefully, one by one, into shortening or basket. If you use the basket, first dip the basket into the shortening to reduce batter-build up on basket surfaces. When frying is completed, remove basket or product. Hang basket on rear hanger. Fry Basket Capacity: HF50: Recommended pounds per basket are 2.5 lbs. (1.1 kg). HF85: Recommended pounds per basket are 3.5 lbs. (1.6 kg).
Résumé du contenu de la page N° 11
HFD, HFCF SERIES ELECTRIC FRYER Programming the Solid State Control HOBARTCORP F-32964 Rev. C (May 2012) -11-
Résumé du contenu de la page N° 12
HFD, HFCF SERIES ELECTRIC FRYER Programming the Computer Control HOBARTCORP F-32964 Rev. C (May 2012) -12-
Résumé du contenu de la page N° 13
HFD, HFCF SERIES ELECTRIC FRYER TURNING OFF THE FRYER Open the door to the fryer. Press the power switch to the OFF position. EXTENDED SHUTDOWN 1. Open the door to the fryer. Press the power switch to the OFF position. 2. Thoroughly drain the fryer. Refer to DRAINING THE FRYER. 3. Clean the fryer according to CLEANING. 4. Turn off the main gas shutoff valve. FILTERING THE OIL Hot oil and hot parts can cause burns. Use care when operating,
Résumé du contenu de la page N° 14
HFD, HFCF SERIES ELECTRIC FRYER DRAINING THE TANK 1. Open the door to the fryer. The power must remain ON for the fryer to filter correctly. 2. Insert the drain extension into the drain valve. Tighten only hand tight. 3. Direct the drain spout into the container that you want to drain the shortening into. 4. Open the drain valve slowly allowing the oil to drain into the container. When the container is full or the fryer tank is empty, close the drain valve. Repeat this ste
Résumé du contenu de la page N° 15
HFD, HFCF SERIES ELECTRIC FRYER 9. Drain the tank according to DRAINING THE TANK. Rinse thoroughly with clear, hot water. All traces of cleaner must be removed. Dry the tank thoroughly. 10. Close the drain valve and add shortening. Follow the FILLING TANK WITH SHORTENING procedure in this manual. The fryer is now ready for use. Press the start button to begin heating the shortening. CLEANING Hot oil and hot parts can cause burns. Use care when operating,
Résumé du contenu de la page N° 16
HFD, HFCF SERIES ELECTRIC FRYER KleenScreen Plus® Filtration System Installation and Operational Manual for “HFF” Models 1HF85CF Shown Electric KleenScreen PLUS® Models 8 1HF85CF ML-136819 HOBARTCORP F-32964 Rev. C (May 2012) -16-
Résumé du contenu de la page N° 17
HFD, HFCF SERIES ELECTRIC FRYER Filtering Instructions for KleenScreen PLUS® Fryers General The KleenScreen PLUS® filtration system filters the oil as it is pumped back into its’ respective tank(s). Only one tank can be drained and filtered at a time. Under no circumstances should both tanks be drained at the same time. Assembly After unpacking, wash the filter pan, crumb basket and filter screen assembly. Make sure you remove the insert located inside the filter scree
Résumé du contenu de la page N° 18
HFD, HFCF SERIES ELECTRIC FRYER Fully assembled filter screen assembly: Fig. 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig. 3 Micro-Filtration Fabric Envelope Assembly: Same Suction Tube Fabric Envelope Insert (Different from Screen Assembly) Fabric Envelope Closing Clip Same Knurled Knob Fig. 4 HOBARTCORP
Résumé du contenu de la page N° 19
HFD, HFCF SERIES ELECTRIC FRYER INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREEN PLUS® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RATE WE RECOMMEND YOU CHANGE YOUR FILTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE). Step 1 Discard all oil from the filter vessel, (see pages 23 or 24). When the filter pan is empty, use a spatula and scrape off all debris left on the filter envelope and in the filter pan. Step 2 Unscrew “S” Tube from fil
Résumé du contenu de la page N° 20
HFD, HFCF SERIES ELECTRIC FRYER Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank. Never run water or boil out solution through filter and motor / pump. Doing so will void your fryer warranty. FILTERING PROCEDURE Oil Temperature shoul
