Instruction d'utilisation Legacy Car Audio LCD36

Résumé du contenu de la page N° 1

®
LEGACY
OWNER’S MANUAL
LCD36
MANUALLY TUNED STEREO RADIO WITH
COMPACT DISC PLAYER DIGITAL

Résumé du contenu de la page N° 2

CONTENTS Installation .....................................................................................................3 Remove The Unit From The Dash Board ....................................................4 Operation.......................................................................................................5 General Operation ................................................................................................5 Radio Operation........................................

Résumé du contenu de la page N° 3

INSTALLATION Here is the installation diagram. DASH BOARD HEX NUT METAL MOUNTING STRAP SPRING WASHER TAPPING SCREW HEX BOLT PLAIN WASHER CONSOLE MOUNTING HOUSING Precautions 1. Choose the mounting location where the Fire Wall unit will not interfere with the normal driving functions of the driver. 2. Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibra

Résumé du contenu de la page N° 4

REMOVE THE UNIT FROM THE DASH BOARD 1. Remove the metal strap attached to the back of the unit. 2. Disconnect all the wires of the unit and the antenna plug. 3. Remove the handle frame from the trim plate. 4. Insert the screw driver into the slot as shown, and slide the unit out of the dash board while holding the trim plate. 5. Remove the screw driver from the slot. SLOT SLEEVE SCREW DRIVER TRIM PLATE HANDLE FRAME 4

Résumé du contenu de la page N° 5

OPERATION 3 5 13 16 7 12 1 4 18 14 15 11 10 9 6 2 17 8 GENERAL OPERATION • ON/OFF Press POWWR button (1) to turn on the unit. Press it again to turn it off. • BALANCE Rotate the button (2) clockwise or anti-clockwise to adjust sound balance between left and right speakers. • VOLUME Rotate the button (3) clockwise or anti-clockwise to adjust volume level. • TONE CONTROL Rotate the button (4) clockwise or anti-clockwise to obtain the desired sound quality. • SELECT MODE Press MOD button (5) to cha

Résumé du contenu de la page N° 6

RADIO OPERATION • BAND Press BND button (7) to change bands as below: FM AM • SELECT STATION Rotate the TUNING knob (8) clockwise or anti-clockwise to adjust the frequency upward or downward. • LOCAL/DISTANT Press the LOC/RPT button (9) to select between local setting for reception of strong station and distant setting for reception of weak stations when tuning. • MONO/STEREO In FM band, press MON/INT button (10) to select mono or stereo reception for radio stations. You can sometimes improve re

Résumé du contenu de la page N° 7

CD OPERATION • DISC PLAY Gently insert a compact disc with the label side facing up into the disc slot (13). The disc is then automatically loaded into the unit and starts playing with the first track of the disc. The digital display will indicate the track number and the time of the track. • EJECT Press (eject) button (12) to stop CD play and eject CD from the slot. Receiver switches to radio operation. • PAUSE CD During CD playing, press button (11) to temporarily stop playing. Press it agai

Résumé du contenu de la page N° 8

WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR RCA CABLE Rch RED POWER BLUE ANTENNA Lch WHITE FUSE RED IGNITION B(+) WHITE GREY LEFT RIGHT SPEAKER SPEAKER BLACK GROUND/SPK.COMMON SPECIFICATION General Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 163 (D) x 51 (H) mm Maximum Output Power : 7 W X 2 CD Player Signal to Noise Ratio : More than 60 dB Channel Separation : More than 60 dB Frequency Response : 100 Hz - 15 KHz Radio Section FM Frequency Range : 88