Résumé du contenu de la page N° 1
RGSSFP
Self Service / Food Prep Case
p/n IGFP-RGSSFP-0008
INSTALLATION & OPERATION GUIDE
/Chino
Installation
& Operation
RGSSFP
Manual
Rev.0008
Self Service / Food Prep Case
Résumé du contenu de la page N° 2
IGFP-RGSSFP-0008 General Instructions THIS BOOKLET CONTAINS INFORMATION ON: RGSSFP Table of Contents The RGSSFP is a food prep case with refrigerated self- General Instructions ................................................. 2 service merchandising in the front, and hot and/or cold Cut & Plan Views ....................................................... 3 food prep area on top. Its large food prep counter makes Installation ................................................................. 3 fo
Résumé du contenu de la page N° 3
Rev.0008 HUSSMANN CHINO PRODUCT CONTROL Product temperature should always be maintained at a The serial number and shipping date of all equipment has constant and proper temperature. This means that from been recorded in Hussmann’s files for warranty and re- the time the product is received, through storage, prepa- placement part purposes. All correspondence pertaining ration and display, the temperature of the product must to warranty or parts ordering must include the serial num- be controlled
Résumé du contenu de la page N° 4
IGFP-RGSSFP-0008 INSTALLING CONDENSATE DRAIN REFRIGERATION LINES Poorly or improperly installed condensate drains can se- LIQUID SUCTION riously interfere with the operation of this refrigerator, 3/8" O.D. 5/8" O.D. and result in costly maintenance and product losses. Please NOTE: The standard coil is piped at 5/8" (suction); however, follow the recommendations listed below when installing the store tie-in may vary depending on the number of coils and the draw the case has. Depending on the cas
Résumé du contenu de la page N° 5
Rev.0008 EXPANSION VALVE ADJUSTMENT Electrical Expansion valves must be adjusted to fully feed the evapo- WIRING COLOR CODE rator. Before attempting any adjustments, make sure the Self Contained cases are wired using a terminal block. evaporator is either clear or very lightly covered with frost, Remote cases are wired as follows: STANDARD CASE WIRE COLOR CODE and that the fixture is within 10°F of its expected operat- CODIGO DE COLORES DE LOS ALAMBRES PARA LAS VITRINAS ESTANDAR CODE COULEUR PO
Résumé du contenu de la page N° 6
IGFP-RGSSFP-0008 specified. Field wiring from the refrigeration control panel mum visibility and product life at the factory. The use to the merchandisers is required for refrigeration ther- of higher output fluorescent lamps (H.O. and V.H.O.), mostats. Most component amperes are listed in the “Case will shorten the shelf life of the product. Specs” section, but always check the serial plate. IMPORTANT STEPS BALLAST LOCATION 1. Do not set temperature too cold, as this causes Ballasts are located
Résumé du contenu de la page N° 7
Rev.0008 Ammonia. • When cleaning the inside of the cases, we recom- Soap and hot water are not enough to kill this bacteria. A mend that the glass be fully opened and covered to sanitizing solution must be included with each cleaning pro- prevent solutions from splashing onto the glass and cess to eliminate this bacteria. ruining the coating on the inside. 1. Allow cases to come to room temperature 2. Scrub thoroughly, cleaning all surfaces, with soap and PLEXIGLASS & ACRYLIC CARE hot water.
Résumé du contenu de la page N° 8
IGFP-RGSSFP-0008 Maintenance ELECTRICAL PRECAUTIONS BEFORE SERVICING – Always disconnect electrical power at the main disconnect when servicing or replacing any electrical component This includes (but not limited to) Fans, Heaters, Thermostats, and Lights. REPLACING FLUORESCENT LAMPS Fluorescent lamps are furnished with a shatterproof pro- tective coating. The same type of lamp with protective coating must be used if replaced. This lamp has been treated to resist breakage and must be replaced wi
Résumé du contenu de la page N° 9
Rev.0008 Specifications 9 TEMPERATUREDISCHG. FAN SIZE DEFROST 115 V. ELECTRICAL CIRCUITS SELF CONTAINED UNIT DATA / SEE CROSS REF. BTU AVG AIR T-STAT/ TYPE & FREQ. SELF CONTAINED REQ’D EVAP PRODDISC VELOC CUT IN OF NUMBER & E E FANS STD. RECEP- LOW PRESSURE Length PER FT. TMP TMP TMP @FPM SETTINGS COIL OF MOTORS DURATION (EPR) FANS WARMERS LIGHTS TACLE CONTROL & SETTINGS H.P. VOLTS AMPACITY RGSSFP 4' Deli 650 18° 36° 28° 175 EPR Forced 7" x 20° 40 min. .33 .6 .3 .56 top only 15.0 35# Out 1/3 11
Résumé du contenu de la page N° 10
IGFP-RGSSFP-0008 Electrical Schematics 10 CAP UNUSED LEAD F32T8 / SPX30 CANOPY LIGHT BALLAST FULHAM REAR STORAGE WH3-120-L COIL BOHN VA-007-0 FP28T5 / 830 BALLAST FULHAM M WH3-120-L SHELF LIGHTS FP28T5 / 830 BALLAST FULHAM WH3-120-L FP28T5 / 830 FRONT EVAPORATOR FAN M SNAP-IN RECEPTACLE SUCTION SOLENOID T-STAT S LIGHT SWITCH ORANGE BLACK/WHITE YELLOW BROWN ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. Revisions: Drawn By: Adrián E. Crisci Project Title: Draw
Résumé du contenu de la page N° 11
Rev.0008 11 F25T8 / SPX30 CANOPY LIGHTS F25T8 / SPX30 BALLAST FULHAM WH3-120-L REAR STORAGE COIL BOHN VA-012-0 FP21T5 / 830 BALLAST FULHAM SHELF LIGHTS M LEFT SIDE WH3-120-L FP21T5 / 830 FP21T5 / 830 BALLAST FULHAM SHELF LIGHTS WH3-120-L RIGHT SIDE FRONT EVAPORATOR FANS FP21T5 / 830 M M SNAP-IN RECEPTACLE SUCTION SOLENOID T-STAT S LIGHT SWITCH ORANGE BLACK/WHITE YELLOW BROWN ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. Drawn By: Project Title: Drawing No.:
Résumé du contenu de la page N° 12
IGFP-RGSSFP-0008 12 F32T8 / SPX30 CANOPY LIGHTS F32T8 / SPX30 BALLAST FULHAM WH3-120-L REAR STORAGE COIL BOHN VA-012-0 FP28T5 / 830 BALLAST FULHAM M WH3-120-L SHELF LIGHTS FP28T5 / 830 LEFT SIDE BALLAST FULHAM WH3-120-L FP28T5 / 830 BALLAST FULHAM WH3-120-L SHELF LIGHTS FP28T5 / 830 RIGHT SIDE FRONT EVAPORATOR FANS BALLAST FULHAM WH3-120-L M M SNAP-IN RECEPTACLE SUCTION SOLENOID T-STAT S LIGHT SWITCH ORANGE BLACK/WHITE YELLOW BROWN ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. ~115 VAC / 50-60 Hz. ~
Résumé du contenu de la page N° 13
Rev.0008 13 F32T8 / SPX30 CANOPY LIGHTS F32T8 / SPX30 CAP UNUSED F32T8 / SPX30 BALLAST FULHAM WH5-120-L REAR STORAGE COIL BOHN VA-012-0 FP28T5 / 830 BALLAST FULHAM M WH3-120-L SHELF LIGHTS FP28T5 / 830 LEFT SIDE BALLAST FULHAM WH3-120-L FP28T5 / 830 BALLAST FULHAM WH3-120-L SHELF LIGHTS FP28T5 / 830 FRONT EVAPORATOR FANS CENTER BALLAST FULHAM WH3-120-L FP28T5 / 830 M M M BALLAST FULHAM WH3-120-L SHELF LIGHTS FP28T5 / 830 RIGHT SIDE BALLAST FULHAM WH3-120-L SNAP-IN RECEPTACLE SUCTION SOLENOID T-S
Résumé du contenu de la page N° 14
IGFP-RGSSFP-0008 14
Résumé du contenu de la page N° 15
Rev.0008 Appendices APPENDIX A. – Temperature Guidlines insulated according to the manufacturer’s recommendations. 1.3 A clogged waste outlet blocks refrigeration. The installer is The refrigerators should be operated according to the manufacturer’s responsible for the proper installation of the system which published engineering specifications for entering air temperatures for dispenses condensate waste through an air gap into the building specific equipment applications. Table 1 shows the typi
Résumé du contenu de la page N° 16
IGFP-RGSSFP-0008 only in Fahrenheit shall be accurate to 2°F. The thermometer manufacturer? Is the refrigerator charged with the proper should be checked for proper calibration. (It should read 32°F refrigerant and lubricant? Does the system use the recommended when the stem is immersed in an ice water bath). compressor? b) LOCATION – The probe or sensing element of the thermometer should be located in the airstream where the air first enters APPENDIX D. – Recommendations to user the display or
Résumé du contenu de la page N° 17
Rev.0008 Limited Warranty This warranty is made to the original user at the original installation site and is not transferable. Hussmann merchandisers are warranted to be free from defect in material and workmanship under normal use and service for a period of one (1) year from the date of original installation (not to exceed fifteen (15) months from the date of shipment for the factory). Hussmann Impact Modular Coils are warranted for a total of five (5) years based upon the above criteria. H
Résumé du contenu de la page N° 18
IGFP-RGSSFP-0008 Service Record Last service date: By: The MODEL NAME and SERIAL NUMBER is required in order to provide you /Chino with the correct parts and information for your particular unit. Additional copies of this publication may be obtained by contacting: They can be found on a small metal plate on the unit. ® Hussmann Chino Please note them below for future reference. 13770 Ramona Avenue • Chino, California 91710 MODEL: (909) 628-8942 FAX (909) 590-4910 SERIAL NUMBER: (800) 395-9
