Résumé du contenu de la page N° 1
READ AND SAVE THESE INSTRUCTIONS
™
MIDWAY ECO
Model No.
54” Ceiling Fan
CF955BS 00
Owner's Manual
CF955ORB 00
Net Weight: 22.7 Lbs.
CF955WW 00
ENERGY STAR
LIMITED WARRANTY
What The Warranty Covers:
This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials.
You must be the original purchaser or user of the product to be covered.
What The Period Of Coverage Is:
As it applies to the motor, this warranty will
Résumé du contenu de la page N° 2
WARNING ! WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
Résumé du contenu de la page N° 3
This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. 14 One Phillips head screwdriver One stepladder 50-100 ft. 12 One 1/4” blade screwdriver One wire stripper Three wire connectors (supplied) One 3/16” hex wrench (supplied) WARNING ! Before assembly your ceiling fan, refer to section on MATERIALS proper method of wiring your fan (page 6). If you fee
Résumé du contenu de la page N° 4
How to Put Your Ceiling Fan Together 1. Remove the hanger ball by loosening the setscrew 4. Make sure the grommet is properly installed in the in the hanger ball until the ball falls freely down the coupling cover then slide the coupler cover on the downrod (Figure 1). Remove the clevis pin from the downrod until it rests on the motor housing. Place downrod, then remove the hanger ball. Retain the the ceiling cover over the downrod. Be sure both pin and hanger ball for reinstallation in step 5.
Résumé du contenu de la page N° 5
8. To ensure proper blade assembly, make sure the Electrical Requirements label on the blades are facing the bottom of the Your new ceiling fan will require a grounded electrical ceiling fan. Slide blade through center slot in fan supply line of 120 volts AC, 60 Hz, 15 amp circuit. housing. Mount blade to fan housing using three 3/16-24 x 1/2” slotted Phillips washer head blade The outlet box must be securely anchored and screws (Figure 5). capable of withstanding a load of at least 50 pounds.
Résumé du contenu de la page N° 6
How to Wire WARNING ! Your Ceiling Fan To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable If you feel that you do not have enough electrical for Fan Support”, and use screws supplied with wiring knowledge or experience, have your fan outlet box. Most outlet boxes commonly used for installed by a licensed electrician. support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a ! qualified electrician i
Résumé du contenu de la page N° 7
5. Secure the ceiling cover in place by sliding Preset Memory Feature lockwashers over the threaded studs and installing Your Emerson remote control receiver is equipped the two knurled knobs (supplied). (Figure 12.) with a preset memory feature. If the electrical supply Tighten the knurled knobs securely until the ceiling to the receiver is controlled through a wall switch, cover fits snugly against the ceiling and the hole in when the switch is turned off, the control will the ceiling cover is
Résumé du contenu de la page N° 8
Programming the Ceiling Fan Operation of Your Receiver Remote Control 1. Restore electrical power to the outlet box by turning the electricity on at the main fuse box. IMPORTANT Fan installation and programming of the 2. Flip the wall switch to the ON position to supply electronic controls must be completed, including electricity to the outlet box circuit. the installation of the fan blades, before testing of 3. Press and hold the “SET” button on the back of the the remote control. transmitter f
Résumé du contenu de la page N° 9
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER ! BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. 2. Loose power line connections to the fan, or loose 2. Check line wire connections to fan and switch wire switch wire connections in the switch housing. connections in the switch housing. WARNING: Make sure main p
Résumé du contenu de la page N° 10
Accessories Maintenance IMPORTANT CARE INSTRUCTIONS 1. Downrod Extension Kits (see store or catalog). for your Ceiling Fan Periodic cleaning of your new ceiling fan is the only WARNING ! maintenance that is needed. The use of any other control not specifically When cleaning, use only a soft brush or lint free cloth approved for this fan could result in fire, shock and to avoid scratching the finish. personal injury. Abrasive cleaning agents are not required and should be avoided to prevent damag
Résumé du contenu de la page N° 11
Repair Parts 2 1 3 5 14 4 17 6 7 3 4 15 2 5 1 6 16 9 8 18 13 19 11 10 12 11 U.L. Model No.: CF955
Résumé du contenu de la page N° 12
Repair Parts Listing Key Model Numbers No. Description CF955BS 00 CF955ORB 00 CF955WW 00 — Hanger Ball Assembly, 761655-17 761655-32 761655 Consisting of: 1 Hanger Bracket — — — 2 Hanger Ball — — — 3 Downrod — — — — Parts Bag Containing: 762029-2 762029-1 762029-2 4 Wire Connector (3) — — — 5 Stud, Threaded, 1-1/4" (2) — — — 6 Lockwashers (2) — — — 7 Knob, Knurled (2) — — — 8 Pin, Clevis — — — 9 Clip, Hairpin — — — 10 Screw, 3/16-24 x 1/2” (16) — — — 11 Lower Housing Assembly 763746 763746-2 763
