Résumé du contenu de la page N° 1
L i b e r t y
Wood Stove
Owner's Manual
• Freestanding Stove
• Mobile-Home Approved
• Alcove Approved
• Hearth-Stove Approved
Save these instructions
for future reference
SAFETY NOTICE:
If this appliance is not properly installed, a house fire may
result. For your safety, follow the installation directions.
Contact local building or fire officials about restrictions and
installation inspection requirements in your area.
Copyright 2007, T.I.
$10.00 100-01164
Listed
4050922
Tested to: U
Résumé du contenu de la page N° 2
2 Introduction Introduction We welcome you as a new owner of a Lopi Liberty wood-burning stove. In purchasing a Lopi Liberty you have joined the growing ranks of concerned individuals whose selection of an energy system reflects both a concern for the environment and aesthetics. The Lopi Liberty is one of the finest appliances the world over. This manual will explain the installation, operation, and maintenance of this appliance. Please familiarize yourself with the Owner's Manual before ope
Résumé du contenu de la page N° 3
Table of Contents 3 Maintaining Your Appliance General Information Daily Maintenance............................................. 24 Introduction & Important Information...................... 2 Remove Ash .................................................... 24 Safety Precautions ............................................ 4 Clean The Glass ............................................... 24 Features & Specifications.................................... 6 Monthly Maintenance ......................
Résumé du contenu de la page N° 4
Gas 4 Safety Precautions The viewing door must be Gasoline or other flammable closed and latched during liquids must never be used to operation. start the fire or "Freshen Up" the fire. Do not store or use gasoline or other flammable liquids in the vicinity of this Never block free airflow through appliance. the air vents on this appliance. This appliance is designed and Ashes must be disposed in a approved for the burning of cord metal container with a tight lid wood only. Do not attempt to a
Résumé du contenu de la page N° 5
Safety Precautions 5 When installed in a mobile home, this appliance must be Do not place clothing or other bolted to the floor, have outside flammable items on or near this air, and not be installed in the appliance. Mobile bedroom (Per H.U.D. requirements). Check with local Home building officials. Never try to repair or replace Do not make any changes or any part of this appliance unless modifications to an existing instructions are given in this masonry fireplace or chimney to manual. All
Résumé du contenu de la page N° 6
6 Features & Specifications Installation Options Features • Freestanding • EPA Phase II Approved • 3.1 Cubic Foot Firebox Volume • Freestanding in an Alcove • Single Operating Control • Freestanding in a Mobile Home • Accepts Logs Up to 24" Long • Freestanding Hearth Stove • Steel Plate Construction (5/16" & 3/16") • Heavy Duty Refractory Firebrick • Optional High-Tech Blower Heating Specifications Approximate Maximum Heating Capacity (in square feet)* 1,500 to 2,500 Maximum BTU's per Hour (Cord
Résumé du contenu de la page N° 7
Stove Installation (for qualified installers only) 7 SAFETY NOTICE: Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. Contact local building or fire officials about restrictions and installation inspection requirements in your area. Planning The Installation We suggest that you have an authorized Travis Industries dealer install your stove. If you install the stove yourself
Résumé du contenu de la page N° 8
8 Stove Installation (for qualified installers only) Floor Protection Requirements • Stove must be placed on the Travis Industries legs or Pedestal. • Floor protection must extend 6" to the sides and rear of the stove and 16" to the front of the stove (42" wide by 43" deep - see Figure 2 and Figure 3). • Floor protection must be non-combustible and at least .018" thick (26 guage). Stove Placement Requirements Clearances may be reduced by methods specified in NFPA 211, listed wall shields, pipe s
Résumé du contenu de la page N° 9
Corner Wall Stove Installation (for qualified installers only) 9 Back Wall Clearance B Top View - Straight Installation Clearance E AAAAAAAAAAAAA 6” Min. 30” A AAAAAAAAAAA A Clearance A A AAAAAAAAAAA A 6” Min. 6-1/4” A AAAAAAAAAAA A Clearance D A AAAAAAAAAAA A A AAAAAAAAAAA A 21” Measure rear and side A AAAAAAAAAAA A clearances from the nearest A AAAAAAAAAAA A edge of the stove top. A AAAAAAAAAAA A NOTE: vent diameter may vary depending on brand A AAAAAAAAAAA A and model. A AAAAAAAAAAA A A A
Résumé du contenu de la page N° 10
10 Stove Installation (for qualified installers only) Chimney Requirements • DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. • Chimney connector must be a minimum 24 MSG black or 26 MSG blued steel (6" diameter). Chimney must be used from the first floor or wall penetration to the chimney cap. • Use 6" diameter type UL 103 HT chimney from one manufacturer (do not mix brands) or code approved masonry chimney with a flue liner. • Chimney connector and chimney must be fastened
Résumé du contenu de la page N° 11
Stove Installation (for qualified installers only) 11 Chimney Termination Requirements • Must have an approved cap (to prevent water from entering) • Must not be located where it will become plugged by snow or other material • Must terminate at least 3' above the roof and at least 2' above any portion of the roof within 10' (see Figure 5) AA Chimney must extend 2' Slanted Roofs above any portion of the roof A AA Chimney must within 10' of the chimney extend 3' above the roof AA Chimney must
Résumé du contenu de la page N° 12
12 Stove Installation (for qualified installers only) Alcove Installation Requirements Whenever the stove is placed in a location where the ceiling height is less than 7' tall, it is considered an alcove installation. Because of the reduced height, the special installation requirements listed below must be met. • Chimney connector and chimney must be one of the following types: AMERI-TEC model DCC with model HS chimney DURAVENT model DVL with DURATEC or DURA-PLUS chimney METALFAB model DW conne
Résumé du contenu de la page N° 13
Stove Installation (for qualified installers only) 13 Mobile Home Requirements • Outside air must be installed - see "Outside Air Requirements" on page 11 • Chimney connector and chimney must be one of the following types: AMERI-TEC model DCC with model HS chimney DURAVENT model DVL with DURATEC or DURA-PLUS chimney METALFAB model DW connector with TG chimney SECURITY model DP connector with SECURITY model ASHT or S2100 chimney Standard Masonry Chimney with any one of the above listed connectors
Résumé du contenu de la page N° 14
14 Stove Installation (for qualified installers only) AA Chimney Cap Standard Ceiling (See the section "Chimney AA with a Factory Follow the chimney Termination Requirements" manufacturer's instructions for more details) Built Chimney and clearances for roof penetrations. A storm collar A and flashing are required Chimney Sections (some require a radiation } shield). A A Insulation AA AAA AA Follow the chimney manufacturer's instructions Minimum Air Space to AA AA AA and clearances fo
Résumé du contenu de la page N° 15
} Stove Installation (for qualified installers only) 15 AA Exterior Factory Follow the chimney Chimney Cap AA manufacturer's Built Chimney (See the section "Chimney instructions and Termination Requirements" clearances for roof for more details) penetrations. A storm NOTE: A collar and flashing are Exterior chimneys are Chimney Sections required (some subject to greater } require a radiation Minimum Air Space to A A moisture and creosote shield). Combustibles (See accumulation due to
Résumé du contenu de la page N° 16
16 Stove Installation (for qualified installers only) NOTE: The chimney must have a clay Hearth Stove Direct tile liner. If it does not, the installation must use a positive connection (full Connection reline). The entire fireplace and Clay chimney must be clean, undamaged, Liner and meet all local building codes (UBC, NOTE: etc.). Damage must be repaired prior Stainless steel Direct connections require to installation. The chimney must be chimney connector installation of an airt
Résumé du contenu de la page N° 17
Operating Your Appliance 17 Safety Notice If this appliance is not properly installed, a house fire may result. For your safety, follow the installation directions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. Read and follow all of the warnings on pages 4 and 5 of this manual. Before Your First Fire Verify the Installation Before starting the stove, verify that the stove is properly installed and all of the requirements in th
Résumé du contenu de la page N° 18
18 Operating Your Appliance Bypass Operation The bypass controls the flow of smoke inside the heater. When pulled out, smoke goes directly up the flue, creating more draft. When pushed in, the smoke goes around the baffle, utilizing the secondary combustion and making the heater more efficient. • When starting or re-loading, pull the bypass out. • During normal operation, push the bypass in. Bypass Pulled Out Used for starting and re-loading Use the included pull tool AA to operate the bypass
Résumé du contenu de la page N° 19
Operating Your Appliance 19 Starting a Fire Since the dawn of time man has debated the best way to start a fire. Some use the boy-scout "tee-pee", some prefer the "tic-tac-toe" stack. Either way, review the hints and warnings below to ensure proper fire starting. • Make sure the air control is pushed in and by-pass pulled out. If additional air is needed, open the doors 1/4" during the first five minutes of start-up. Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter f
Résumé du contenu de la page N° 20
20 Operating Your Appliance Adjusting the Burn Rate Use the air control slider to control the burn rate of the stove. See the illustration below for details. Use the air control to change the burn rate. AAAA AAAA Low Burn High Burn (air control closed) (air control open) AAAA AA AAAA AA Approximate Air Control Settings Overnight Burn Fully out to 9/32" open Medium Burn 9/32" open to 5/16" open Medium High Burn 5/16" open to 7/16" open High Burn 7/16" open to pushed fully in The air control be
