Résumé du contenu de la page N° 1
User Instruction & Installation Manual
L560 Remote Control 2/3Kw
Tungsten Halogen Searchlight
Product Reference Number:
A2651 – Variable Speed Motor Unit 2/3Kw 115/240v
Manufacturers details: Distributor details:
Francis Searchlights Ltd
Union Road, Bolton
Lancashire, BL2 2HJ, UK
Tel: +44 (0) 1204 558960
Fax: +44 (0) 1204 558979
http://www.francis.co.uk
E-mail: sales@francis.co.uk
Manual Part Number: C21514
Issue : 5
Résumé du contenu de la page N° 2
CONTENTS 1 - Introduction 2 - Safety Precautions 3 - Technical Information 4 - Unpacking and Installation Instructions 5 - Electrical Installation 6 - Operating Instructions 7 - Fault Finding 8 - Maintenance and Servicing 9 - Wiring Diagram & General Assembly 10 - Spare Parts List
Résumé du contenu de la page N° 3
1 - Introduction It is imperative that this manual is read carefully and understood before installing your equipment. For your future reference please keep this manual in a safe place. Thank you for specifying a product from the Francis Searchlights range. All Francis products are designed to give complete customer satisfaction and are manufactured to the highest engineering standards in order to ensure optimum performance and service life. The Francis Lite range combines features proven over ma
Résumé du contenu de la page N° 4
2 - Safety Precautions The following instructions must be adhered to, in order to ensure a safe working environment and the safety of the user. Note: When unpacking or manoeuvring the searchlight into its fixing position, suitable lifting points must be used in order to prevent damage to the equipment or personal injury. Prevent rain, snow, condensation and water droplets from contacting the lamp as this may cause bulb failure and possible shattering; Quartz halogen bulbs run with a high inte
Résumé du contenu de la page N° 5
3 - Technical Information This product has been designed to operate in accordance with the product specification. The L560RC searchlight has the following features: All marine grade materials and fixings; Parabolic formed aluminium reflector; Powder coated / Stove enamel paint finish; 385° horizontal rotation; Vertical movement ±20°; Motor speed 20 °/sec fast, 10 °/sec slow (Pan) 0-10 °/sec fast, 0-5 °/sec slow (Tilt); Effective weather sealing to IP66; Toughened front glass; The searchl
Résumé du contenu de la page N° 6
4 - Unpacking and Installation Instructions The following instructions should be read and fully understood prior to installing the equipment to ensure that the correct procedures are followed and all safety precautions are observed. Note: If the equipment has been in storage for a considerable amount of time, it is advisable to conduct a routine maintenance check on all parts before installation. Safety Precautions This equipment should not be connected to an electrical supply before being insta
Résumé du contenu de la page N° 7
5 - Electrical Installation For safety purposes, only competent personnel should perform the electrical installation. All equipment should be installed to current Electrical Regulations and Standards. In order to obtain the maximum light output from the searchlight, it is essential that the full operating voltage of the lamp fitted be applied to the lampholder contacts. Method of Electrical Connection 1) Disconnect the supply before working on the electrical system; 2) The searchlight must be
Résumé du contenu de la page N° 8
Installation Guidelines A typical installation and connection routine for the L560RC 2/3Kw searchlight is as follows: Referring to wiring diagram C22978, a supply is fed to the control panel, which then provides a common feed to the motor gearbox and the searchlight. Cables required to be connected by the customer: - 2 4 core 1.5mm cable from the Motor Gearbox to the Control Panel. 2 12 core 0.5mm cable from the Motor Gearbox to the Control Panel. (Customer may need to provide a suitable jun
Résumé du contenu de la page N° 9
6 - Operating Instructions This equipment is designed for use out of doors, in free air. Never place anything on, or cover the searchlight when in use as this may present a hazard. The searchlight can be remotely positioned via the joystick control panel, with the facility for movement up, down, left and right. The speed of movement depends on the more pressure applied to the joystick the faster the searchlight moves. When in the desired position the joystick should be released so that it return
Résumé du contenu de la page N° 10
weaken the bulb material. Should the bulb be inadvertently touched, remove fingerprints with methylated spirit and a clean, soft paper towel. The bulb should then be wiped with distilled water. NOTE: ALWAYS WEAR MASK AND GLOVES DURING CLEANING); In all circumstances the lamp manufacturers data should be referred to when dealing with lamps. When fitting the lamp: - Always isolate the equipment from the supply when inserting a lamp; - Ensure the circuit is suitably fused; - Ensure the lamp is of t
Résumé du contenu de la page N° 11
7- Fault Finding All fault finding must be conducted by a competent person or qualified Electrical Engineer. Failure of Lamp to light Causes: 1) Power not supplied; 2) Fuse blown; 3) Failed lamp Remedy: 1) Check voltage at supply. If supply is not present the fault is at the customer supply. If power is present, see remedy 2; 2) Check fuse for visual failure. If none noticeable check fuse for continuity using a multi-meter. If fuse found to be faulty, replace with new part and test equipment ag
Résumé du contenu de la page N° 12
8 - Maintenance and Servicing In order to prolong the service life and performance of your searchlight, the following maintenance guidelines are recommended: Maintenance checks should be conducted before very voyage or at least every three months; Before checking, disconnect the equipment from the supply; Visually inspect the condition of the equipment; Any major or minor structural damage should be rectified immediately in order to reduce sympathetic wear; After inspection it may be necess
Résumé du contenu de la page N° 13
9 - Wiring Diagram and General Assembly Drawing Number Description C22978 Wiring Diagram Lite Range Variable Speed 20 Amp A2651 L560RC 2/3Kw 115/240v Variable Speed General Assembly drawing Control Panel Assembly
Résumé du contenu de la page N° 14
Résumé du contenu de la page N° 15
Résumé du contenu de la page N° 16
Résumé du contenu de la page N° 17
10 - Spare Parts List The following spare parts can be ordered directly from the manufacturer: Part Number Description Searchlight Spares D1823 115v 2Kw G38 Tungsten Halogen Lamp D4604 220/240v 2Kw G38 Tungsten Halogen Lamp D9843 115v 3Kw G38 Tungsten Halogen Lamp D22559 220/240v 3Kw G38 Tungsten Halogen Lamp C23002-00 Selector Switch 20Amp – On/Off C22347-00 Joystick C20550-00 Latch C20881-00 Front Glass C20569-00 Front Glass Gasket C21051-00 Reflector C22268-01 Breather unit C09868-00 Lamphold
