Résumé du contenu de la page N° 1
LD- 15
Series Spa
Manufactured
by
Résumé du contenu de la page N° 2
This OWNER’S MANUAL has been designed to familiarize you with your Spa operations and general maintenance. We suggest that you take some time to carefully review it. Please keep this manual available for reference. If you have any questions regarding your spa set-up, operation or mainte- nance, please contact DM Technical Support at the numbers below. Owner’s Record DATE PURCHASE: __________________________________ SERIAL NUMBER: __________________________________ To contact our Technical Serv
Résumé du contenu de la page N° 3
IMPORT ANT SAFETY INSTRUCTIONS WHEN INSTALLING AND USING THIS ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWA YS BE FOLLOWED, INCLUDING THE FOLLOWING: 1. WARNING : To reduce the risk of injury do not permit children to use this product unless they are closely supervised at all times. 2. DANGER! RISK OF ACCIDENTAL DROWNING. Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents, ensure that children cannot use a hot tub or spa unless they a
Résumé du contenu de la page N° 4
C. Before entering a spa, the user should measure the water temperature with an accurate thermometer, since the tolerances of water temper- ature regulating devices vary. D. The use of alcohol, drugs, or medication, before or during spa use, may lead to unconsciousness with the possibility of drowning. E. Persons suffering from obesity or with a medical history of heart disease, low or high blood pressure, circulation system problems, or diabetes should consult a physician before using a spa.
Résumé du contenu de la page N° 5
W ARNINGS Prolonged immersion in water that is warmer than normal body temperature can result in a dangerous condition known as HYPERTHERMIA. The causes, symptoms, and effects of hyperthermia may be described as follows: Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6 degrees F. The symptoms of hyperthermia include dizziness, fainting, drowsiness, lethargy, and an increase in the internal temperature of th
Résumé du contenu de la page N° 6
INST ALLA TION INSTRUCTIONS Site Selection/Preparation The spa must be installed on a structurally strong, solid and reasonably level surface.The site should allow for drainage away from the equipment compartment in which the elec- trical components are housed. Take into account the following when considering prospective sites: LOCAL CODES: There may be certain restrictions and/or requirements that are particular to your locality. DELIVERY PASSAGEWAY: Doors, halls, stairs, etc. may pose obstr
Résumé du contenu de la page N° 7
Getting Started: NOTE: For best results, read each step carefully and entirely before proceeding to the next. FILL YOUR SPA Wipe the interior of the spa with a damp, soft cloth to remove any residue that may be on the surface. Fill with a garden hose. As the spa is filling check in the equipment access area for any leaks. On occasion, it may be necessary to hand tighten a union fitting that may have come loose during transit. Also check that the gate valves are pulled out to the open position
Résumé du contenu de la page N° 8
CONTROLS & OPERA TING INSTRUCTIONS This new electronic system control provides reliability, user settings, and simple opera- tion at the touch of a button. PROGRAMMING YOUR SPA Note that this electronic system comes ready with factory defaults that will filter and heat to a preset temperature of 102º F. To program your new spa controller, follow the simple steps below: 1.) Hold down the PROG button for 5 seconds. Note the display will start to flash 102 F. Then release the button. 2.) Use the
Résumé du contenu de la page N° 9
SPECIAL FEA TURES: AUTOMATIC FILTRATION: This spa is set to filter your water anytime the Jet/Pump is running. AUTO HEAT: Heat is generated and transferred into the water by capturing the heat emitting from the motor. This economical transference of heat will continue until the desired temperature is achieved. The spa control system will monitor the water temperature twenty-four hours a day and will cycle the jet/pump on and off whenever the need for heat is called for. SPA SIDE RESET: This
Résumé du contenu de la page N° 10
SPA MAINTENANCE Your spa is manufactured with the highest quality and most durable materials available. A spa care and maintenance program is recommended to increase your comfort, maintain the spa’s reliability and protect your investment. 1) DRAINING YOUR SPA Detergent residues from bathing suits as well as soap film from your body may gradually accumulate in the water. Foam inhibitors will suppress the foam but will not remove the soap from the water. Eventually, the soap build-up in the wa
Résumé du contenu de la page N° 11
3) FILTER MAINTENANCE Maintenance is the most critical factor in keeping your spa water clean. To clean the filter: NEVER RUN SPA WITHOUT FILTER A. Remove the cartridge and spray it with a garden hose. It will be necessary to rotate the cartridge while spraying so as to thoroughly remove the debris lodged between the filter pleats. B. After allowing to dry, inspect the cartridge for calcium deposit (scaling) or an oil film. Rapid mineral build-up from hard water, or oil builds up from the us
Résumé du contenu de la page N° 12
WA TER QUALITY AND MAINTENANCE GENERAL GUIDELINES FOR WATER QUALITY MAINTENANCE Maintaining water quality within specific limits will enhance your enjoyment and prolong the life of the spa. Safe, comfortable and clean spa water is a fairly simple task to achieve, but it does require regular attention because of the numerous factors that can alter it. There is no one for- mula to be followed because of the variables, i.e. quality of the water used to fill the spa, water temperature user load,
Résumé du contenu de la page N° 13
Trouble Shooting Guide ERROR MESSAGES IMPORTANT: UNPLUG SPA WHENEVER ACCESSING CONTROL BOX LS=S Large water temperature sensor may need replacement. Reboot system. If error returns open the door and remove the four screws to the metal control box cover reseat the sensor in connection. If error returns, reverse sen- sors and note reading if SS=S replace sensor, if LS=S stays replace board. LS=O Large water temperature sensor may be disconnected. Reboot system. If error returns open the door and
Résumé du contenu de la page N° 14
Maintenance Record Keep track of your water maintenance — 13 —
Résumé du contenu de la page N° 15
LIMITED WARRANTY for LD 15 SERIES MODEL SPAS DM Industries, Ltd., extends this limited warranty solely to the original sibility of the spa owner. Purchaser of any LD-15 Series self-contained spa installed within the EXCLUSIONS United States or Canada. This warranty is void if DM Industries, Ltd., or its representative deter- mines that the spa has been subjected to any alterations or repairs by 10 YEAR STRUCTURAL anyone other than an authorized representative of DM Industries, Ltd. SPA SHELL: DM
Résumé du contenu de la page N° 16
© 2005 DM Industries Ltd 2320 NW 147th Street Miami, Florida 33054 PH 305-685-5739 SPALD15-050517
