Instruction d'utilisation Dymo TESA2 -2401000

Résumé du contenu de la page N° 1

*.--+,- 4-/5-6
English
Quick Start
Follow these steps to install the LabelWriter printer and print your first label.
1. Unpacking your LabelWriter Printer
NOTE For Windows, do not plug the printer into your computer until asked to do so
during the software installation.
1 Unpack your printer and save the original packing materials.
2 Make sure you have all the items shown in Figure 1.
LabelWriter printer
Roll of labels
CD-ROM
Power adapter
USB cable # $

Résumé du contenu de la page N° 2

Your LabelWriter printer is a direct thermal printer and does not use toner, ink cartridges, or a ribbon. Instead, it uses heat from a thermal print head to print on specially treated labels. Labels are the only supplies you will ever need to buy. Become familiar with the printer’s major components. See Figure 2. DC Power USB Top Connector Connector Cover Label Feed Path and Tear Bar Modular Connector for Serial Cable Cable LED Form-Feed Channel (RJ11) Button (Not all model

Résumé du contenu de la page N° 3

2. Installing the Software To install the software on a Windows system NOTE Do not connect the printer to your computer until instructed to do so during the software installation. 1 Insert the LabelWriter CD into your CD-ROM drive. After a few seconds, the installation screen appears. If the installation screen does not appear: a. Click Start and then Run on the Windows taskbar. The Run dialog box appears. b. Enter D:\install.exe (where D is the letter assigned to the CD-ROM drive) and c

Résumé du contenu de la page N° 4

--- ,- 4-/5-6 3. Connecting your LabelWriter Printer At some point during the software installation, you will be asked to connect your LabelWriter printer to the USB or serial port. NOTE For Windows, do not connect the printer to Power Adapter your computer until instructed to do so during the $ " ! $ % ) (

Résumé du contenu de la page N° 5

To connect using the serial port Serial Power Connection 1 Plug the serial cable into the serial port on the bottom of the printer. See Figure 7. 2 Insert the power and serial cables into the cable channel and set the printer down on your work Cable surface. Channel 3 When prompted during the software installation Figure 7 and while the printer is turned on, plug the serial connector into the serial (COM) port on your computer. See Figure 8. Serial Port The installation auto

Résumé du contenu de la page N° 6

6 Cut the first label in half so that you have a clean edge and insert the label into the label feed slot. See Figure 10. The printer feeds the labels, stopping at the end of the first label. If the printer stops without feeding the label, make sure the label is fully inserted and then press the form-feed button. Figure 10 7 Close the top cover. You are now ready to print your first label. 5. Printing your First Label 1 Start the DYMO Label software by doing one of the following: • For Wind