Instruction d'utilisation Applica LitterMaid LM680

Résumé du contenu de la page N° 1

PLEASE READ AND SAVE THIS USE AND CARE BOOK.
®
FOR SINGLE-CAT HOUSEHOLDS
Lu cy
USA/Canada 1-800-LITMAID
Model
(548-6243)
www.littermaid.com
LM680
Accessories/Parts (USA/Canada) 1-800-738-0245

Résumé du contenu de la page N° 2

MIN MAX Product may vary slightly from what is illustrated. IMPORTANT SAFEGUARDS ☐ NOT INTENDED FOR USE WITH KITTENS UNDER SIX MONTHS. ☐ Not intended for use by handicapped, incapacitated or older cats that 3 might experience difficulty in entering or leaving the litter box. 2 ☐ PREGNANT WOMEN and IMMUNE-DEFICIENT PEOPLE should avoid 4 contact with cat waste at all times. 1 ® ☐ CAUTION: THIS IS NOT A TOY. The LitterMaid Self-Cleaning litter 7 box is a precision-operated appliance. Should

Résumé du contenu de la page N° 3

MIN MAX Accessories Setup Instructions 5 No Tools Required for Setup ® • Unpack the pieces of the unit: LitterMaid litter box, AC adapter (packed 4 ® in paper pulp), disposable waste receptacles, LitterMaid scoop and rake cleaner, use and care book and cleaning brush (packed with disposable waste receptacles), plus any optional items including the carbon filters, paw-cleaning ramp and litter box carpet. • Cut and remove the restraints on each end of the rake. Peel off the protective tape o

Résumé du contenu de la page N° 4

• Remove the AC adapter from paper pulp packaging and plug it into the unit. Sensors Then plug cord into a standard electrical wall outlet. Press the On/Off button to Sensors (located on interior side panels) must be clean at all times. Wipe sensors "on" and a green light will appear at top of unit. The rake will automatically run with a soft, dry cloth to keep them dust free. through its first cleaning cycle and smooth out litter. ® The LitterMaid Scoop and Rake Cleaner This handy 3-way tool h

Résumé du contenu de la page N° 5

C. Unit does not completely clean litter box. Troubleshooting Probable Cause: A. Rake continues to go through cleaning cycles. • Low-quality clumping litter. Probable Causes: 1. Do not use non-clumping, crystal or pearl-like litter. • Too much litter in litter box is causing excess litter to collect behind rake, 2. Use only hard clumping litter. preventing it from returning to home position. If the rake cannot move an D. Unit does not operate when On/Off button is buttoned on. obstacle duri

Résumé du contenu de la page N° 6

MIN MIN MAX MAX Probable Cause: Care and Cleaning • Power outage or batteries are incorrectly installed. 1. Turn On/Off button to “off” then back to “on.” Sensor Covers 2. Make sure there is power to the unit and/or batteries are correctly installed. The two sensors located on side panel interiors are protected by sensor covers G. Light blinks slowly and continuously. that need to be kept dust free. After changing or adding litter, always wipe each sensor with a soft, dry cloth to remove dus

Résumé du contenu de la page N° 7

READ INSTRUCTION MANUAL BEFORE USING. CAUTION: MOTOR STARTS AUTOMATICALLY WITHOUT WARNING. KEEP HANDS, CLOTHING AND CHILDREN CLEAR OF UNIT. CAUTION: MOTOR STARTS AUTOMATICALLY WITHOUT WARNING. READ INSTRUCTI ANUAL BEFORE US NG. ON M I • Use only premium clumping litter refill litter tray to just below the "Max Line". Rake Removal, Cleaning & Reinstallation • Plug in AC power adapter and replace batteries. Removing the rake: • Turn the On/Off button to "on" to reactivate automatic operation. Im

Résumé du contenu de la page N° 8

• Push rake into the motor housing until it snaps into place both on top and on NEED HELP? the bottom of the rake (Fig. 14 and 15). For service, repair or any questions regarding your appliance, call the • Press On/Off button and hold it for 3 seconds, the LED stops blinking and motor appropriate "800" number on the cover of this book. Do not return the housing returns to home position. product to the place of purchase. Do not mail the product back to the Note: The motor housing will automa

Résumé du contenu de la page N° 9

Copyright © 2008 Applica Consumer Products, Inc. Made in People’s Republic of China Printed in People’s Republic of China R32008/2-28-69E