Instruction d'utilisation Spin Master Air Hogs Skywinder

Résumé du contenu de la page N° 1

TM
INSTRUCTIONS Contents:
TM
1 SkyWinder™ Stunt Plane
1 Controller
1 Charger/Trainer/Display Stand
2 Extra Propellers
ON/OFF
1 Tool
Charging
Switch
Indicator
NO ASSEMBLY
Light
REQUIRED
Toggle
Vertical
Thrust
Tail Wing
Button
Rudder Tool
Stunt Flap Land
CONTROLLER Button
Antenna
Stunt Flap
Adjustment
Horizontal
Knob
ON/OFF
Charging
Tail
Switch
Light Charging
Wing
Hose
Ready
Main
Plane
Propeller Light
Wing
Body
Charge
Propeller
Nozzle
Tip
Training
Stand
Charging
Charger
ON/OFF
Port
Propeller
Pro

Résumé du contenu de la page N° 2

TM CHARGING YOUR SKYWINDER IMPORTANT: BEFORE YOUR FIRST FLIGHT,YOU MUST CHARGE AND DISCHARGE YOUR AIRPLANE FULLY 1 TIME. YOU MUST ALSO REPEAT THIS STEP WHEN A PROLONGED PERIOD OF TIME HAS PASSED WITHOUT FLYING. FAILURE TO DO THIS WILL RESULT IN SHORTENED LIFESPAN FOR YOUR AIRPLANE. FOR ALL OTHER FLIGHTS, CHARGE THE BATTERIES ONCE ONLY. DO NOT OVERCHARGE THE BATTERIES AS THIS WILL PERMANENTLY DAMAGE THE BATTERIES. STEP 1 PLANE CHARGER Ensure that the ON/OFF ON/OFF ON/OFF SWITCH on the plane Sw

Résumé du contenu de la page N° 3

TM SETTING UP YOUR SKYWINDER FOR INDOOR TRAINING continued STEP 4 STEP 3 Turn the controller’s ON/OFF SWITCH Turn the plane’s ON/OFF to “ON”. ON/OFF SWITCH Switch to “ON”. NOTE: You are now ready to practice flying on your INDOOR TRAINER! Please refer to Page 4 for Basic Controls. PRE-FLIGHT CHECK 1. Ensure that the STUNT FLAP is LEVEL (or ALIGNED WITH) the HORIZONTAL TAIL WING. CORRECT ALIGNMENT INCORRECT ALIGNMENT Horizontal Tail Wing Stunt Flap IF THE FLYING HEIGHT IS TOO LOW OR THE PLANE

Résumé du contenu de la page N° 4

BASIC FLYING TIPS • Always launch your plane against the wind direction for best performance. • Never fly the plane in high winds. HIGH WINDS WILL LIMIT, AND MAY PREVENT, YOUR ABILITY TO CONTROL THE AIRPLANE. USE IN HIGH WINDS MAY ALSO RESULT IN LOSS OF, OR DAMAGE TO, THE AIRPLANE. TM TM BASIC CONTROLS FOR YOUR AIR HOGS SKYWINDER TURN LEFT/RIGHT NOSE DOWN Toggle FORWARD Toggle LEFT or RIGHT NOSE UP CLIMB Press THRUST button Toggle BACK LAND – OPTION 1 LAND – OPTION 2 Turn ON/OFF SWITCH to

Résumé du contenu de la page N° 5

TM TM HOW TO COMPLETE ADVANCED STUNTS ON YOUR AIR HOGS SKYWINDER STEP 1 STEP 2 Set controller’s ON/OFF Set plane’s ON/OFF SWITCH to “ON”. SWITCH to “ON” for NOTE: ENGINES WILL power. ON/OFF NOW START. NOTE: ENGINES WILL Switch NOT START YET (See Step 2). STEP 3 STEP 4 Launch plane against Press the THRUST wind. Toss it firmly, level BUTTON to climb. with the ground. IMPORTANT: DO NOT attempt any stunts until the plane has reached and leveled off at the minimum altitude listed below, and the plan

Résumé du contenu de la page N° 6

TM TM HOW TO COMPLETE ADVANCED STUNTS ON YOUR AIR HOGS SKYWINDER continued STEP 5 – STUNTS continued 2. SIDEWINDER MINIMUM ALTITUDE 30 Feet A. B. C. TOGGLE BACK to climb. TOGGLE back to pull When the plane reaches a vertical out of dive then return to position TOGGLE – LEFT to NEUTRAL to level off. complete a LEFT SIDEWINDER. To complete a RIGHT SIDEWINDER, TOGGLE – RIGHT when the plane reaches a vertical position. REMEMBER: When you are finished flying your SKYWINDER™, ON/OFF turn the plane’

Résumé du contenu de la page N° 7

CHANGING PROPELLERS ON YOUR SKYWINDER™ In case of propeller damage, please use the steps below to replace the damaged propeller: 1. With one hand, grab hold of the PROPELLER. 2. While holding the PROPELLER in place, use your opposite hand to unscrew the removeable PROPELLER PROPELLER PROPELLER TIP with the PROPELLER REPLACEMENT TOOL. TIP 3. After removing the PROPELLER TIP, pull the damaged PROPELLER from the shaft and replace with a new propeller. 4. While holding the propeller in place, re

Résumé du contenu de la page N° 8

FCC REQUIREMENTS CAUTION: Changes or modifications to this product not expressly approved by the party responsible for compliance may void the user’s authority to operate the equipment. WARRANTY (U.S.A.) Spin Master Ltd. warrants to the original consumer purchaser, that this product is thoroughly tested and inspected before shipment and is guaranteed to be free of factory defects in materials and workmanship for ninety (90) days (unless specified in alternate warranties) from the date of purch