Résumé du contenu de la page N° 1
K
R
A
D
.
D
E
M
T
SAVE THIS USE AND CARE BOOK
*
™
Spacemaker Optima
Horizontal Toaster
®
STOP
Spacemaker
Horizontal Toaster Optima
START
1-800-231-9786
QUESTIONS? Please call us TOLL FREE
?
MODEL T1000
*Trademark of General Electric Company, U.S.A.
H
G
I
L
Y
R
T
S
A
P
Résumé du contenu de la page N° 2
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS. Do not touch hot surfaces. Use handles or knobs. Do not operate any electric or gas heating appliance beneath this unit. Do not place on or near a hot gas or electric burner or in a heated oven. Do not install the horizontal toaster over a sink or basin or any electrical or gas heating appliance. To protect against electrical shock, do
Résumé du contenu de la page N° 3
K R A D . D E M T A fire may occur if the horizontal toaster is covered or touching flammable material, including curtains, draperies, walls, and the like, when in operation. Do not store any item on top of the horizontal toaster when in operation. Do not clean with metal scouring pads. Pieces can break off the pad and touch electrical parts, creating a risk of electric shock. Do not leave unattended while toasting. Do not operate in the presence of explosive and/or flammable fumes. Th
Résumé du contenu de la page N° 4
SAFETY NOTE: Overtoasting of thinly sliced breads, reduced fat diet breads, and packaged greasy toaster foods could cause them to catch on fire. Toast thin, diet light, or greasy slices only in lower settings of the Toast Color Control; for packaged toaster foods, follow toasting instructions provided by their manufacturers. POLARIZED PLUG This horizontal toaster has a polarized plug — one blade is wider than the other. To reduce the risk of electric shock, this plug will fit into a polarized ou
Résumé du contenu de la page N° 5
Do not install the Toaster directly in front of an electrical outlet, but be sure it is mounted within reach of an electrical outlet. The Toaster is designed to be mounted directly TM next to any other Spacemaker* Optima product, with a clearance of at least 1” between the two products. If it is not mounted next to any other TM Spacemaker* Optima product, maintain at least a 5” clearance on all sides including the back. NOTE: If you have Flush Bottom cabinets—a flat level surface where the
Résumé du contenu de la page N° 6
INSTALLING YOUR HORIZONTAL TOASTER Tools you will need for installation: • Drill and 1/4” drill bit • Phillips screwdriver • Hammer/Nail to start a drill hole • Adhesive tape • Eye Protection Goggles • Newspaper to cover counter tops (optional) Flush bottom-1A First, determine if your cabinet has a flush bottom or overhang bottom. (See Illustration 1A & 1B). If your cabinet has a flush bottom — flat, level surface — follow the mounting instructions below. If your cabinet has an overhang — a li
Résumé du contenu de la page N° 7
remove the Mounting Template. (Figure C) 4. Cover the counter top to catch drilled wood chips. CAUTION: Suitable eye protection is recommended to prevent injury from shavings while using a drill. 5. Make a small starter hole by hammering a nail or using a Figure C smaller drill bit. Holding the drill straight and vertical at the hole marks, center and drill up through the bottom of the cabinet. (Figure D) 6. Insert a plastic washer on each screw with the flat side of the washer resting on the c
Résumé du contenu de la page N° 8
8. Press the Bracket inward and forward toward the front of the cabinet until it stops. Tighten the screw/nut assem- bly with a screwdriver until the Bracket just touches the bottom of the cabinet. (Figure G) The Bracket should move freely front to rear in the slot to fine tune the fit of the Toaster to the cabinet front. Repeat Steps 7 and 8 for the Figure F other Bracket. 9. Hold the Toaster in front of you and push it forward into the slots on the Mounting Brackets until it locks into place.
Résumé du contenu de la page N° 9
MOUNTING INSTRUCTIONS FOR CABINET WITH OVERHANG If your cabinet has an overhang — a lip extending below the bottom of the cabinet shelf — follow these simple mounting instructions. 1. Empty your cabinet of its contents before starting to drill. Clean the underside of the cabinet to remove any grease or other residue. 2. To determine whether you need Illustration 2 to use Spacer Bars to mount your Horizontal Toaster, use the Cabinet Overhang Ruler on your Mounting Template and measure the cabine
Résumé du contenu de la page N° 10
the folded grey strip is against the back of the cabinet overhang. Tape the Mounting Template securely in place. Check to be sure the Mounting Template is located where you plan to mount the toaster. NOTE: If the cabinet has an overhang that extends more than 2 inches below the cabinet bottom, a wooden shim (a piece of wood that fits between the Cabinet and the Bracket) will be necessary. Cut a block of wood that is: 16 1/4” x 5 1/2”. Make sure the wood is at least as thick as the amount of the
Résumé du contenu de la page N° 11
6. Make a small starter hole by hammering a nail or using a smaller drill bit. Holding the drill straight and vertical at the hole marks, center and drill up through the bottom of the cabinet. (Figure K) Figure K 7. Insert a plastic washer on each screw with the flat side of the washer resting on the cabinet bottom. Drop each screw with the washer in place through a drilled hole from inside the cabinet. Repeat the proce- dure with remaining screws and washers. Thread a nut onto each screw so tha
Résumé du contenu de la page N° 12
8. If you determined you need Spacer Bars (See Step # 2, page 9), place the Spacer Bars on top of each Bracket so that the 2 small tabs on the bars fit into the notches on the Brackets. Slide the Mounting Bracket and Spacer Bars above the nuts through the U-shaped openings on the Bracket. The Bracket will then be resting on the nuts. (Figure M) Figure M 9. Push the Spacer Bars/Bracket up against the screws and forward toward the front of the cabinet. Tighten the screw/nut assembly with a screwdr
Résumé du contenu de la page N° 13
11. Drape the Cord toward an electrical outlet and use the Cord Hook to hold the Cord out of the way. Peel the paper off the adhesive back of the Cord Hook. For the most attractive appearance, place the Cord Hook at the back edge of the cabinet (on or next to the wall) over the outlet to be used. NOTE: For safety, NEVER USE TACKS THROUGH OR AGAINST THE CORD TO HOLD IT. USING THE NOTE: The Horizontal Toaster must be TOASTER mounted before using. A NOTE ABOUT THE TOASTER: This toaster is designed
Résumé du contenu de la page N° 14
K R A D . D E M T TOASTING GUIDE Electronic Toast Control Knob Guide Pastry Light Medium Dark RECOMMENDED FOOD No. of SLICES SETTING* White Bread, soft type 2 Slices Medium 1 Slice Light Wheat Bread 2 Slices Medium 1 Slice Medium Rye Bread 2 Slices Dark 1 Slice Medium Variety Bread, Hand Sliced, 1 Slice Medium 3/4” thick Italian Bread, 3/4” thick 2 Slices Light French Bread, 3/4” thick 2 Slices Light Portuguese Bread, 6-8” long, 1 Slice Medium 1/2” thick Thin Slice White Bread 2 Slices M
Résumé du contenu de la page N° 15
K R A D . D E M T Questions on Using the Horizontal Toaster 1. Can I toast thick slices of homemade breads? Yes, as long as the slices don’t go over the MAX FILL LINE. You can see the words STOP MAX MAX FILL LINE and the line when you pull FILL LINE START open the door. It is not recommended to put foods in the toaster that exceed the MAX line. 2. I noticed some moisture on the glass door—is that normal? Yes. Some condensation may form on the door during the toasting cycle because the door tra
Résumé du contenu de la page N° 16
3. Pull the handle down until the door is fully opened and latched. The Slide-Out Rack will come forward. Place the slices of bread or toaster foods on the Rack. Use the Door Handle to gently close the door. (Figure P) NOTE: For best toasting results, use the MAX FILL LINE located on the metal Figure P border inside the Glass Door as a guide to food height. It is not recommended to toast foods that rise above the MAX line because toasting quality will be affected. 4. Press the Start Button and t
Résumé du contenu de la page N° 17
T Care Guide CLEANING NOTE: Always unplug the cord from the electrical outlet and allow the Toaster to cool before cleaning. DO NOT IMMERSE TOASTER IN WATER 1. The See-Through Glass Door should be cleaned with a damp, sudsy cloth. Dry thoroughly before using the Toaster. 2. To clean the Slide-Out Rack, pull the handle down until the door is fully opened and latched. Grasp the rack, lift it slightly over the rack Figure Q pins and pull outward. (Figure Q) Wash the Rack in hot, sudsy water. To re
Résumé du contenu de la page N° 18
NOTE: The Pull-Down Crumb Tray can be extremely hot. Allow it to cool completely before cleaning. 3. Check and clean the Pull- Down Crumb Tray often. (Figure R) Immediately wipe away any food crumbs or spills from fillings or toppings before next use. Place a waste receptacle under the Crumb Tray. Open the Crumb Tray to empty the crumbs. Use a cloth or plastic scouring pad and hot, sudsy water to clean the tray. Figure R 4. Dry the Pull-Down Crumb Tray thoroughly before latching to the toaster.
Résumé du contenu de la page N° 19
Need Help? TIPS ABOUT THE The cord length of this Horizontal Toaster was ELECTRICAL CORD selected to reduce safety hazards that may occur with a longer cord. If more cord length is needed, an extension cord may be used. It should be rated not less than 10 amperes, 120 volts, and should have Underwriters Laboratories listing. A properly rated extension cord with a polarized plug may be purchased from a Black & Decker (U.S.) Inc., Household Appliance Company- Owned or Authorized Service Center. Wh
Résumé du contenu de la page N° 20
FULL Black & Decker (U.S.) Inc. warrants this product TWO-YEAR against any defects that are due to faulty WARRANTY material or workmanship for a two-year period after the original date of consumer purchase or receipt as a gift. This warranty does not include damage to the product resulting from accident or misuse. If the product should become defective within the warranty period, we will repair it or elect to replace it free of charge, including free return transportation, provided it is delive
