Instruction d'utilisation Centurion 531

Résumé du contenu de la page N° 1

Centurion 531

English

Warranty Information
Cooler Master guarantees that this device is free of defect in material and workmanship,
and provides a two-year limited hardware warranty for the device commencing from the
date of purchase. Please keep your receipt for proof of purchase.
This product is designed for computer usage only. Using this device in any other capacity
voids the warranty. If you are not familiar with computer hardware installation, please ask
for professional

Résumé du contenu de la page N° 2

Centurion 531 English Specification & Parts list Item Parts Name QTY 1 Alumnus Panel 1 2 Big Shield 5 3 Small Shield 1 4 Fan Filter 1 5 Plastic Panel 1 6 Reset Key cover 1 7 Power key cover 1 8 Power Key 1 9 Reset Key 1 10 Key Rack 1 11 Reset Lamp 1 12 Power LED 1 13Casing 1 14 Left Side Casing 1 15USB 1 16 120 Fan 1 17 120 Fan 1 18Power 1 19 Right Side Casing 1 20 Screw (L. Side Casing) 1 21 Manual Screw 2 22 Fan Screw 8 23 PCB Screw 2 Chapter

Résumé du contenu de la page N° 3

Centurion 531 English Installing the Motherboard 1. Remove the side casing. 2. Lie down the casing. 3. Aiming at the holes on the PCB, and secure the alumnus post with screws. 4. Align the holes of PCB and casing. Secure them by fastening screws on the PCB. Install add-on card 1. Press to loosen the latch on the inner casing. 2. Insert the add-on card. 1. Lock the latch back from the outside of the casing. Installing Drives (CD-ROM, FDD and HDD) After re

Résumé du contenu de la page N° 4

Centurion 531 English 1. Installing Hardware Device on 5.25"3.5" or "HDD" bracket-- Layer III, IV, or V. 2. Insert the hardware device in place; align the screw holes of the device with those of the HDD rack. 3. Push forward the plastic handling and tightening it. 4. Push the lock and the installation is done. Installing the power device 1. Remove side casing. 2. Place the power supply on the power rack with the wiring end facing forward and connect it to the

Résumé du contenu de la page N° 5

CS-8006-02 REV 01 Centurion 531 English Replacing/Installing the Case Fan Change the Front Fan 1. Remove the side casing. 2. Loosen the lower and side screws to remove the HDD bracket. 3. Loosen the fan screws from the front casing, and then remove the fan. 4. Install the new fan and secure it with screws. Continue to put it back on the HDD rack and secure it with screws. Change the Rear Fan 1. Loosen the fan screws from the rear casing and remove the fan. 2. Instal

Résumé du contenu de la page N° 6

Centurion 531 English I/O Function Panel Installation Guide Please refer to the illustration on the section of USB2.0, IEEE 1394a, and Audio connector from the motherboard user’s manual. Please select the motherboard which used the same USB2.0, IEEE1394, AC’97 standard as below; otherwise, it will cause damages to user’s device(s). The following illustration is a connection diagram for the front panel I/O cable. NEVER connect an IEEE1394 cable to the USB2.0 connector. Doing